Submarine channels are important conduits for sediment in deep marine environments, and understanding their formation is critical to modeling basin fill processes. Most models describing channel evolution focus on turbidity currents as the erosive and constructive force in channel initiation. However, slope failure and slumping can be significant drivers of channelization, particularly in upper slope and ramp environments. Determining the relative roles of slumping and erosion by turbidity currents can provide important insight into the timing of channelization and the geometries of subsequent deposits. Samples were collected from Guadalupe Mountains National Park from two primary localities at Salt Flat Bench (Figure 2). Three vertical sections were measured at both locations. A total of 16 samples were collected for petrographic analysis and X-ray fluorescence (XRF) imaging. Spectacular outcrop quality makes the Middle Permian Brushy Canyon Formation in Guadalupe Mountains National Park an ideal location for the study of early channel evolution. A detailed facies analysis of fine-grained channel deposits was conducted in the Upper Brushy Canyon Formation in the Salt Flat Bench outcrops. After channelization, an interval of relative condensation dominated by hemipelagic settling of organic matter and silt was followed by an interval of incomplete sediment bypass by turbidity currents. This sequence of events suggests that sea level was at a relative highstand at the time of channel inception, whereas channel inception by turbidity currents is expected during a lowstand. Slumping rather than erosion by turbidity currents is the most likely mechanism to have initiated a channel at the study area. There is no evidence for the existence for high energy currents until after the interval of condensation. However, the action of weak contour currents during early channel evolution is observed in outcrop and microtextural features. Early carbonate cementation of channel-lining silts may have stabilized the slump surface with respect to erosion by later turbidity currents.

This dissertation examines how turbidity currents interact with submarine channels. Turbidity currents display exaggerated super-elevation at the outer banks of channel bends, because they have low excess densities relative to the ambient sea-water. Low-velocity zones form where flows separate from the inner banks. In a high-resolution seismic volume, I mapped 226 inclined surfaces associated with bank-attached bars in 16 channel bends of 2 buried sinuous channels. Position and geometries of bars indicate construction from suspended sediment in flow separation zones. Concave-bank benches, first identified in rivers where they are built from fully-suspended sediment deposited within flow separation zones in channel bends, comprise approximately 19% of this dataset. Bars have high median slopes (10°-11°) and occupy less than 30% of channel width. Associated channels migrated a median distance of less than 70% of the channel width and incised 20-30% of the channel depth. These bars are therefore interpreted to have formed during sediment bypass or weak erosion. I have analyzed the sedimentology and stratigraphy of a well-exposed channel complex, in the Permian Brushy Canyon Formation, west Texas. A steeply-inclined set of fine-grained sandstone beds (median dip=10°) at the margin of the channel complex is interpreted as deposits of a bank-attached bar. Beds are characterized by sub- to super-critically climbing ripple-lamination, planar stratification and trough cross-stratification. Paleo-transport directions are at high angles, 20-120°, to the dip azimuths of interpreted bar surfaces. Geometries of bounding surfaces, sedimentation styles and grain-size data were used to construct a facies model for suspension-dominated, bank-attached bars, built within flow-separation zones in submarine channels. I designed physical experiments to examine how erosional turbidity currents evolve channel- bend topography. Time-lapse bathymetry maps capture the evolution of raised benches tied to sedimentation within flow separation zones and erosion outside of separation zones. Erosional currents showed sensitivity to local conditions. The pattern of erosion was connected to roughness elements such as bend curvature and scours on the bed. Turbidity current run-up at the outside of bends produced a greater aerial extent of side-wall erosion than is commonly seen in incisional rivers.