No description available.

No description available.

No description available.

Stress corrosion cracking (SCC) susceptibility of the phosphorus de-oxidized copper has been evaluated in synthetic seawater polluted by sulfides using slow strain rate test (SSRT). The effect of concentration of sulfide, temperature, and applied cathodic and anodic potentials on the final strain values and maximum stress were also studied. No cracks were found under the tested conditions. The final strain and maximum stress values decreased but not significantly, with increase in the temperature, applied anodic potential and sulfide concentration. The observed effect is due to the section reduction by uniform corrosion. Lateral cross section and microscopic examination of the fractured specimen ruled out the existence of the localized corrosion. Electrochemical measurements showed that the Cu2S film is not a protective film and also exhibits a mass transfer limitation to the inward diffusion of the sulfides. Based on these results the reasons for the absence of cracking are also discussed.

Stress corrosion cracking (SCC) susceptibility of the phosphorus de-oxidized copper has been evaluated in synthetic seawater polluted by sulfides using slow strain rate test (SSRT). The effect of concentration of sulfide, temperature, and applied cathodic and anodic potentials on the final strain values and maximum stress were also studied. No cracks were found under the tested conditions. The final strain and maximum stress values decreased but not significantly, with increase in the temperature, applied anodic potential and sulfide concentration. The observed effect is due to the section reduction by uniform corrosion. Lateral cross section and microscopic examination of the fractured specimen ruled out the existence of the localized corrosion. Electrochemical measurements showed that the Cu2S film is not a protective film and also exhibits a mass transfer limitation to the inward diffusion of the sulfides. Based on these results the reasons for the absence of cracking are also discussed.

Thesis (Ph.D.) -- McMaster University, 1998. / Includes bibliographical references (leaves 149-158). Also available via World Wide Web.

Thesis (Ph. D.)--University of Wisconsin--Madison, 1968. / Typescript. Vita. eContent provider-neutral record in process. Description based on print version record. Includes bibliographical references.

University of Macau / Faculty of Science and Technology / Department of Electromechanical Engineering

Scanning electrochemical microscopy is a method that incorporates an ultramicroelectrode capable of facilitating electrochemical reactions paired with an XYZ positioning system capable of micron-level movements. This study investigates the corrosion behavior of structural transition joint clad material that contains steel, pure aluminum, and an aluminum alloy blast welded into a single joint. This study will characterize the corrosion response of the structural transition joint and identify the galvanic activity measured between its layers. High-temperature coatings in this study are designed to be used effectively up to 1400?F. In this study, we characterized several commercial high-temperature coatings exposed to different levels of heat. General trends of decreasing barrier performance were observed with the exception when these coatings are exposed to their rated temperature limit of 1400?F, at which the barrier increased slightly, indicated by their low-frequency impedance modulus. The cause is a combination of sintering and oxide formation.

No description available.