Thesis (M.S. in Applied Physics)--Naval Postgraduate School, December 2009. / Thesis Advisor(s): Colson, William B. ; Blau, Joseph. "December 2009." Description based on title screen as viewed on January 28, 2010. Author(s) subject terms: Free-electron lasers, FEL simulations, undulators, FEL oscillators, FEL amplifiers, diamond field-emitter arrays, field emission cathodes, cathode test cell. Includes bibliographical references (p. 45). Also available in print.

Manganese spinel cathodes LiMn₂O₄ offer the advantage of a strong, edge-shared octahedral framework with fast, 3-dimensional Li⁺-ion conduction. To better understand the safety of these materials, the thermal stability characteristics of spinel oxide and oxyfluoride cathodes Li[subscript 1.1]Mn[subscript 1.9-y]M[subscript y]O₄[subscript-z]F[subscript z] (M = Ni and Al, 0 ≤ y ≤ 0.3, and 0 ≤ z ≤ 0.2) have been investigated systematically. The thermal characteristics are assessed in terms of the onset temperature and reaction enthalpy for the exothermic reaction. The thermal stability increases with decreasing lithium content in the cathode in the charged state. High-voltage spinel cathodes LiMn[subscript 1.5]Ni[subscript 0.5]O₄ are promising candidates for electric vehicles and stationary storage of electricity produced by renewable energies due to their high power capability. However, widespread adoption of this high-voltage spinel cathode is hampered by severe capacity fade resulting from aggressive reaction with the electrolyte to form a thick solid-electrolyte interphase (SEI) layer. The synthesis conditions of the co-precipitation method are found to influence the microstructure and morphology through nucleation and growth of crystals in solution. Two samples prepared by similar wet-chemical routes have been characterized by microscopy and electrochemical methods to determine the role of microstructure and morphology on the electrochemical performance. It is found that the surface crystal planes play a key role in the capacity retention and rate performance. In order to achieve consistent electrochemical properties essential for the commercialization of the high-voltage spinel cathode LiMn[subscript1.5]Ni[subscript 0.5]O₄, the relationship between cation ordering, presence of impurity phase, and particle morphology must be elucidated. Accordingly, comparison of the stoichiometric LiMn[subscript1.5]Ni[subscript 0.5]O₄ cathodes with a Mn/Ni ratio of 3.0 prepared by different methods having varying morphologies and degrees of cation ordering is presented. It is found that although an increase in the degree of cation ordering decreases the rate capability, the crystallographic planes in contact with the electrolyte have a dominant effect on the electrochemical properties. To examine the effect of cation substitution on morphology, an investigation of the nucleation and growth of doped co-precipitated mixed-metal hydroxide precursor particles and the resulting stabilization of preferred crystallographic surface planes in the final spinel samples are presented. It is found that doping with certain cations stabilizes the growth of low-energy (111) surface planes, facilitating a long cycle life and fast high-rate performance. With an aim to develop a better understanding of the factors influencing the electrochemical properties, a systematic investigation of LiMn[subscript 1.5]Ni[subscript0.5-x]M[subscript x]O₄ (M = Cu and Zn and x = 0.08 and 0.16), in which Ni²⁺ ions are substituted by divalent Cu2+ and Zn2+ ions, is presented. It is found that although both Zn and Cu are divalent with ionic radii similar to that of Ni2+, they behave quite differently with respect to cation ordering and site occupancy, and higher levels of doping leads to distinct differences in cycling and rate performances. / text

Not available / text

Lithium ion batteries, due to their relatively high energy density, are now widely used as the power source for portable electronics. Commercial lithium ion cells currently employ layered LiCoO₂ as a cathode but only 50% of its theoretical capacity can be utilized. The factors that cause the limitation are not fully established in the literature. With this perspective, prompt gamma-ray activation analysis (PGAA) has been employed to determine the hydrogen content in various oxide cathodes that have undergone chemical extraction of lithium (delithiation). The PGAA data is complemented by data obtained from atomic absorption spectroscopy (AAS), redox titration, thermogravimetric analysis (TGA), and mass spectroscopy to better understand the capacity limitations and failure mechanisms of lithium ion battery cathodes. As part of this work, the PGAA facility has been redesigned and reconstructed. The neutron and gamma-ray backgrounds have been reduced by more than an order of magnitude. Detection limits for elements have also been improved. Special attention was given to the experimental setup including potential sources of error and system calibration for the detection of hydrogen. Spectral interference with hydrogen arising from cobalt was identified and corrected for. Limits of detection as a function of cobalt mass present in a given sample are also discussed. The data indicates that while delithiated layered Li[subscript 1-x]CoO₂, Li[subscript 1-x]Ni[subscript 1/3]Mn[subscript 1/3]Co[subscript 1/3]O₂, and Li[subscript 1-x]Ni[subscript 0.5]Mn[subscript 0.5]O₂ take significant amounts of hydrogen into the lattice during deep extraction, orthorhombic Li[subscript 1-x]MnO₂, spinel Li[subscript 1-x]Mn₂O₄, and olivine Li[subscript 1-x]FePO₄ do not. Layered LiCoO₂, LiNi[subscript 0.5]Mn[subscript 0.5]O₂, and LiNi[subscript 1/3]Mn[subscript 1/3]Co[subscript 1/3]O₂ have been further analyzed to assess their relative chemical instabilities while undergoing stepped chemical delithiation. Each system takes increasing amounts of protons at lower lithium contents. The differences are attributed to the relative chemical instabilities of the various cathodes that could be related to the position of the transition metal band and the top of the O²-:2p band. Chemically delithiated layered Li[Li[subscript 0.17]Mn[subscript 0.33]Co[subscript0.5-y]Ni[subscript y]]O₂ cathodes have also been characterized. The first charge and discharge capacities decrease with increasing nickel content. The decrease in the capacity with increasing nickel content is due to a decrease in the lithium content present in the transition metal layer and a consequent decrease in the amount of oxygen irreversibly lost during the first charge. / text

Lithium ion batteries have been successful in portable electronics market due to their high energy density, adopting the layered LiCoO₂ as the cathode material in commercial lithium ion cells. However, increasing interest in lithium ion batteries for electric vehicle and hybrid electric vehicle applications requires alternative cathode materials due to the high cost, toxicity, and limited power capability of the layered LiCoO₂ cathode. In this regard, spinel LiMn₂O₄ has become appealing as manganese is inexpensive and environmentally benign, but LiMn₂O₄ is plagued by severe capacity fade at elevated temperatures. This dissertation explores the factors that control and limit the electrochemical performance of spinel LiMn₂O₄ cathodes and focuses on improving the performance parameters such as the capacity, cyclability, and rate capability of various spinel cathodes derived from LiMn₂O₄. From a systematic investigation of a number of cationic and anionic (fluorine) substituted spinel oxide compositions, the improvements in electrochemical properties and performances are found to be due to the reduced manganese dissolution and suppressed lattice parameter difference between the two cubic phases formed during the charge-discharge process. Investigations focused on fluorine substitution reveal that spinel LiMn[subscript 2-yz]LiyZnzO[subscript 4-eta]F[subscript eta] oxyfluoride cathodes synthesized by solid-state reactions at 800 °C employing ZnF₂ as a raw material and spinel LiMn[subscript 2-y-z]Li[subscript y]Ni[subscript z]O[subscript 4-eta]F[subscript eta] oxyfluoride cathodes synthesized by firing the cation-substituted LiMn[subscript 2-y-z]LiyNi[subscript z]O₄ oxides with NH₄HF₂ at a moderate temperature of 450 °C show superior cyclability, increased capacity, reduced Mn dissolution, and excellent storage performance compared to the corresponding oxide analogs and the conventional LiMn₂O₄. Spinel-layered composite cathodes are found to exhibit better electrochemical performance with graphite anode when charged to 4.7 V in the first cycle followed by cycling at 4.3-3.5 V compared to the normal cycling at 4.3 - 3.5 V. The improved performance is explained to be due to the trapping of trace amounts of protons that may be present in the electrolyte within the layered oxide lattice during the first charge to 4.7 V and the consequent reduction in Mn dissolution. Electrochemical performances of 3 V spinel Li₄Mn₅O₁₂ cathodes are also improved by fluorine substitution due to the suppression of the disproportionation of Li4Mn5O12 during synthesis and the formation of the Li₂MnO₃ phase.

No description available.

No description available.

No description available.

Thesis (PhD)--University of South Australia, 1997

Thesis (Ph.D.)--University of Wollongong, 2007. / Typescript. Includes bibliographical references: leaf 230-232.