Various physical parameters of solvents within two component, PMMA + Solvent films are analyzed for their impact upon the coating uniformity of spin deposited PMMA films. Towards this end, a model is presented for describing the surface behavior of spin-on films during the latter stages of deposition, correlating the tendency of a film toward non-uniform deposition to physical characteristics of the spin-on solution. A finite difference solution to this model is presented for two-component, spin-on films that is shown to effectively predict the uniformity of the resulting thin-film layers. The model is then used to determine the impact of specific film parameters upon the predicted spin-on uniformity of the film. Based upon these results, the interdependency between evaporation rate, solvent viscosity, surface tension and rotation rate in determining the uniformity of the spin-on film is evaluated by comparing the model predictions against those found in actual spin-on, two component films. The results from this model are used to provide a physical explanation for why certain surface non-uniformities begin to develop during spin coating.

Print quality demands for coated papers are steadily growing, and achieving coating uniformity is crucial for high image sharpness, colour fidelity, and print uniformity. Coating uniformity may be divided into two scales: coating thickness uniformity and coating microstructure uniformity, the latter of which includes pigment, pore and binder distributions within the coating layer. This thesis concerns the investigation of both types of coating uniformity by using an approach of quantitative microscopy.First, coating thickness uniformity was analysed by using scanning electron microscope (SEM) images of paper cross sections, and the relationships between local coating thickness variations and the variations of underlying base sheet structures were determined. Special attention was given to the effect of length scales on the coating thickness vs. base sheet structure relationships.The experimental results showed that coating thickness had a strong correlation with surface height (profile) of base sheet at a small length scale. However, at a large length scale, it was mass density of base sheet (formation) that had the strongest correlation with coating thickness. This result explains well the discrepancies found in the literature for the relationship between coating thickness variation and base sheet structure variations. The total variance of coating thickness, however, was dominated by the surface height variation in the small scale, which explained around 50% of the variation. Autocorrelation analyses were further performed for the same data set. The autocorrelation functions showed a close resemblance of the one for a random shot process with a correlation length in the order of fibre width. All these results suggest that coating thickness variations are the result of random deposition of particles with the correlation length determined by the base sheet surface textures, such as fibre width.In order to obtain fundamental understandings of the random deposition processes on a rough surface, such as in paper, a generic particle deposition model was developed, and systematic analyses were performed for the effects of particle size, coat weight (average number of particles), levelling, and system size on coating thickness variation. The results showed that coating thickness variation3grows with coat weight, but beyond a certain coat weight, it reaches a plateau value. A scaling analysis yielded a universal relationship between coating thickness variation and the above mentioned variables. The correlation length of coating thickness was found to be determined by average coat weight and the state of underlying surfaces. For a rough surface at relatively low coat weight, the correlation length was typically in the range of fibre width, as was also observed experimentally.Non-uniformities within the coating layer, such as porosity variations and binder distributions, are investigated by using a newly developed method: field emission scanning electron microscopy (FESEM) in combination with argon ion beam milling technique. The combination of these two techniques produced extremely high quality images with very few artefacts, which are particularly suited for quantitative analyses of coating structures. A new evaluation method was also developed by using marker-controlled watershed segmentation (MCWS) of the secondary electron images (SEI).The high resolution imaging revealed that binder enrichment, a long disputed subject in the area, is present in a thin layer of a 500 nm thickness both at the coating surface and at the base sheet/coating interface. It was also found that the binders almost exclusively fill up the small pores, whereas the larger pores are mainly empty or depleted of binder.