Master’s thesis is based on analysis and design of a load bearing structure of an mountains hotel. Mountain hotel schould be realized in the village Vernirovice in Šumperk district. The proposed structure is formed 4th floors. In 1.NP is a restaurant, a sports and wellness center. In 2.NP in the right side is situated the swimming pool. In 2 to 4 floor are located rooms. This structure is supported with a strip footing made of reinforced concrete. The main load-bearing elements in the vertical direction are in 1.NP reinforced concrete walls and columns, the upper floors bearing masonry walls of ceramic blocks THERM. The inner support walls are 300 mm thick, outside support walls are 400 mm thick. Floors are constructed of carrying plates with girders above the larger openings. These plates and girders are made of reinforced concrete. In the 2 floor are beams with the span of 8,8 m. These girders are designed of prestressed concrete cause the large loads. Individual levels are connected with monolithic concrete staircases. Around the middle of the building is a monolithic reinforced concrete elevator shaft. The highest elevation above grade level is 16 m. The thesis also deals with relevant drawing documentations for chosen parts of construction.The building is located in the ski area VI and IV wind areas.

The main goal of the master’s thesis is to design a new building of the nursery in Brno-Soběšice. It is one-storey building. This floor is divided to two same parts. In each of them is day room, sleeping room, office, bathroom, cloakroom for children, cloakroom for teachers with shower and toilet and stock for beds. Also there is director office, toilet, hallway, utility room, room for cleaners, sink and stocks. The vertical loadbearing structures are designed from Porotherm ceramic blocks and the hollow concrete blocks. The building is insulated by a contact thermal insulation system ETICS. The horizontal loadbearing structures and the staircase are designed from reinforced monolithic concrete slab. The roof is flat with extensive greenery. The whole construction are based on foundation passports. The building site contains also an outdoor car park with ten parking spot and garden with climbing frames. The project was performed in Autocad and visualization was performed in ArchiCad and Lumion. All constructions comply with valid standards and regulations. Master’s thesis is divided to three parts. In the first part A it deals with the construction design of a building for a building permission. It contains architectural-building solutions, building physics, situation drawing, reports, building design solutions and fire safety solutions. In the second part B it deals with the design of technical equipment of buildings. It includes the design of sewerage system, water, gas, photovoltaic panels, lighting, ventilation and heating. In the third part C it deals possible systems for the use of rainwater. I described possible systems for the use of rainwater and developed a rough calculation for the selected system.