The combination of X-ray imaging and diffraction techniques provides a unique tool for structural and mechanical analysis of engineering components. A variety of modes can be employed in terms of the spatial resolution (length-scale), time resolution (frequency), and the nature of the physical quantity being interrogated. This thesis describes my contributions towards the development of novel X-ray “rich” imaging experimental techniques and data interpretation. The experimental findings have been validated via comparison with other experimental methods and numerical modelling. The combination of fast acquisition rate and high penetration properties of X-ray beams allows the collection of high-resolution 3-D tomographic data sets at submicron resolution during in situ deformation experiments. Digital Volume Correlation analysis tools developed in this study help understand crack propagation mechanisms in quasi-brittle materials and elasto-plastic deformation in co-sprayed composites. For the cases of crystalline specimens where the knowledge of “live” or residual elastic strain distributions is required, diffraction techniques have been advanced. Diffraction Strain Tomography (DST) allows non-destructive reconstruction of the 2-D (in-plane) variation of the out-of-plane strain component. Another diffraction modality dubbed Laue Orientation Tomography (LOT), a grain mapping approach has been proposed and developed based on the translate-rotate tomographic acquisition strategy. It allows the reconstruction of grain shape and orientation within polycrystalline samples, and provides information about intragranular lattice strain and distortion. The implications of this method have been thoroughly investigated. State-of-the-art engineering characterisation techniques evolve towards scrutinising submicron scale structural features and strain variation using the complementarity of X-ray imaging and diffraction. The first successful feasibility study is reported of in operando stress analysis in an internal combustion engine. Finally, further advancement of ‘rich’ imaging techniques is illustrated via the first successful application of Time-of-Flight Neutron Diffraction Strain (TOF-NDST) tomography for non-destructive reconstruction of the complete strain tensor using an inverse eigenstrain formulation.

In the absence of a fusion neutron source, research on the structural integrity of materials in the fusion environment relies on current fission data and simulation methods. Through investigation of the Fe-Cr system, this detailed study explores the challenges and limitations in the use of currently available radiation sources for fusion materials research. An investigation of ion-irradiated Fe12%Cr using nanoindentation with a cube corner, Berkovich and spherical tip, and micro-cantilever testing with two different geometries, highlighted that the measurement of irradiation hardening was largely dependent on the type of test used. Selected methods were used for the comparison of Fe6%Cr irradiated by ions and neutrons to a dose of 1.7dpa at a temperature of 288°C. Micro-cantilever tests of the Fe6%Cr alloy with beam depths of 400 to 7000nm, identified that size effects may significantly obscure irradiation hardening and that these effects are dependent on radiation conditions. Irradiation hardening in the neutron-irradiated alloy was approximately double that of the ion-irradiated alloy and exhibited increased work hardening. Similar differences in hardening were observed in an Fe5%Cr alloy after ion-irradiation to a dose of 0.6dpa at 400°C and doses rates of 6 x 10^-4dpa/s and 3 x 10^-5dpa/s. Identified by APT, it was shown that increased irradiation hardening was likely to be caused by the enhanced segregation of Cr observed in the alloy irradiated with the lower dose rate. These observations have significant implications for future fusion materials research in terms of the simulation of fusion relevant radiation conditions and micro-mechanical testing.