Rheological properties of idealised models which exhibit all the non-Newtonian flow phenomenology commonly seen in dense suspensions are investigated by particulate-dynamics computer-simulations. The objectives of these investigations are: (i) to establish the origins of various aspects of dense suspension rheology such as shear-thinning, shear thickening and dilatancy; (ii) to elucidate the different regions of a typical dense suspension rheogram by examining underlying structures and shear induced anisotropies in kinetic energy, diffusivity and pressure; (iii) to investigate the scaling of the simplest idealised model suspension; i.e. the hard-sphere model in Newtonian media and its relationship to the isokinetic flow curves obtained through non-equilibrium molecular dynamics (NEMD) simulations; (iv) to preliminarily determine the effect of perturbations present in all real colloidal suspensions, namely particle size polydispersity and a slight 'softness' of the interparticle potential. Non-equilibrium isokinetic simulations have been performed upon ;systems of particles interacting through the classical hard-sphere potential and a perturbation thereof, in which the hard-core is surrounded by a 'slightly soft' repulsive skin. The decision to base the present work upon isokinetic studies was made in order to obtain a better under- standing of suspension rheology by making a direct connection with previous NEMD studies of thermal systemst(93). These studies have shown that the non-linear behaviour exhibited by these systems under shear is atttributable to a shear-induced perturbation of the equilibrium phase behaviour. The present study shows this behaviour to correspond to the high shear region of the generalised suspension flow curve.

Rheological properties of idealised models which exhibit all the non-Newtonian flow phenomenology commonly seen in dense suspensions are investigated by particulate-dynamics computer-simulations. The objectives of these investigations are: (i) to establish the origins of various aspects of dense suspension rheology such as shear-thinning, shear thickening and dilatancy; (ii) to elucidate the different regions of a typical dense suspension rheogram by examining underlying structures and shear induced anisotropies in kinetic energy, diffusivity and pressure; (iii) to investigate the scaling of the simplest idealised model suspension; i.e. the hard-sphere model in Newtonian media and its relationship to the isokinetic flow curves obtained through non-equilibrium molecular dynamics (NEMD) simulations; (iv) to preliminarily determine the effect of perturbations present in all real colloidal suspensions, namely particle size polydispersity and a slight 'softness' of the interparticle potential. Non-equilibrium isokinetic simulations have been performed upon ;systems of particles interacting through the classical hard-sphere potential and a perturbation thereof, in which the hard-core is surrounded by a 'slightly soft' repulsive skin. The decision to base the present work upon isokinetic studies was made in order to obtain a better under- standing of suspension rheology by making a direct connection with previous NEMD studies of thermal systemst(93). These studies have shown that the non-linear behaviour exhibited by these systems under shear is atttributable to a shear-induced perturbation of the equilibrium phase behaviour. The present study shows this behaviour to correspond to the high shear region of the generalised suspension flow curve. / Science and Engineering Research Council and Unilever Research

Par rapport à un fluide Newtonien, les suspensions denses de particules présentent des propriétés rhéologiques différentes. Des comportements rhéofluidifiants ou rhéoépaississants liés à des phénomènes de migration de particules peuvent apparaitre. Pour des suspensions, le taux de cisaillement, la concentration et la taille des particules ont une grande influence sur ce comportement rhéologique (Denn et Morris 2014). Pour observer l'influence de ces facteurs, l'un des meilleurs moyens est de disposer d’un système simple dans lequel tous les facteurs mentionnés ci-dessus sont bien contrôlés. Ceci peut être réalisé par le développement d'une plate-forme expérimentale, sur laquelle les comportements d'écoulement de suspension (profil de vitesse et concentration locale de particules) à des vitesses de cisaillement et des concentrations de particules bien contrôlées peuvent être étudiés. Dans l'étude actuelle, 4 tâches ont été réalisées :1) Le développement d'une nouvelle formulation pour la préparation d’une suspension adaptée en indice de réfraction et en densité basée sur des particules de PMMA. 2) Le développement d'un dispositif expérimental consacré à l'étude des flux de suspension dense sous une large gamme de taux de cisaillement constant. 3) La caractérisation des profils de vitesse des flux de suspension dense sous un dispositif cône-plan utilisant des techniques de micro-PIV. 4) Une mesure préliminaire de la concentration locale de particules de la suspension sous écoulement cône-plan en utilisant des méthodes de traitement d'image. / Compared to general Newtonian fluids, highly concentrated mixtures of particles and fluid, so called dense suspensions, have different rheological properties and fluid dynamic behaviors. Such as, shear-thinning or shear-thickening effect, and apparent slip and particle migration behaviors under certain shear flow conditions. These properties are related to the application of suspension flow in real systems, for example, the blood.For suspensions, shear rate, particle concentration and particle size have a big influence of on their rheological behaviors (Denn and Morris 2014). To observe the influence of these factors, one of the best ways is to start the research from a simple case in which all the above mentioned factors are well controlled. This can be realized by developing such an experimental platform, on which the suspension flow behaviors (velocity profile and local particle concentration) at different shear rates and particle concentrations can be investigated.In the current study, 4 tasks were achieved:1) The development of a new recipe for the preparation of density and refractive index matched suspension with PMMA particles. 2) The development of an experimental set-up devoted to the investigation of dense suspension flow under a large range of constant shear rate. 3) The characterization of the velocity profiles of dense suspension flows under a cone-plate device by using micro-PIV techniques.4) A preliminary measurement of the local particle concentration of the suspension flow by using image processing techniques.

Cette thèse, financée dans le cadre du projet européen CSP2, porte sur l'étude d'un nouveau type de récepteur solaire thermique à concentration utilisant comme fluide caloporteur une suspension dense de fines particules en circulation ascendante dans des tubes verticaux. Ladite suspension est obtenue par fluidisation de particules de classe A. Le principe consiste à créer un écoulement ascendant de la suspension dans un tube vertical exposé au rayonnement solaire concentré qui chauffe la paroi du tube, qui transmet ensuite cette chaleur aux particules, qui la transportent jusqu'à un cycle de conversion d'énergie pour la production d'électricité. Au contraire des fluides solaires classiques, les particules peuvent atteindre les hautes températures (> 700 °C) permettant l'utilisation de cycles à haut rendement de conversion (Brayton, cycles combinés), tout en permettant un stockage direct de la pour une production continue. Au cours de la thèse, un récepteur à un tube a été testé avec succès au grand four solaire du laboratoire PROMES-CNRS à Odeillo, les particules en sortie atteignant 750 °C, ce qui a prouvé la faisabilité du concept et permis la détermination des premières valeurs de coefficient d'échange de chaleur tube-suspension. L'hydrodynamique de l'écoulement et les mécanismes d'échange de chaleur ont été observés grâce à des simulations numériques 3D. Un récepteur de 150 kWth à 16 tubes a ensuite été testé et modélisé, validant l'utilisation du procédé à plus grande échelle. / This thesis, financed in the frame of the CSP2 European project, concerns the study of a new kind of thermal concentrating solar receiver using a dense suspension of solid particles circulating upward in vertical tubes. The suspension is obtained by fluidizing Geldart A-type particles. The principle consists in creating an upward flow of the suspension in a vertical tube exposed to the concentrated solar radiation that heats the tube wall. The heat is then transmitted to the particles circulating inside that transport it to a conversion cycle for electricity production. Contrarily to usual solar heat transfer fluids, particles can reach high temperatures (> 700 °C) that permit to power high efficiency thermodynamic cycles such as Brayton or combined cycles. Moreover they can be used as a direct heat storage medium for continuous electricity production. During this thesis, a one-tube solar receiver was successfully tested at the PROMES-CNRS solar furnace in Odeillo, with particle outlet temperatures of 750 °C reached. The first values of wall-to-suspension heat transfer coefficient were calculated and a Nusselt correlation was determined. A specific flow pattern with a particle downward flux close to the wall and upward flux in the tube center was underlined. The flow hydrodynamics and the heat transfer mechanisms were studied thanks to 3D numerical simulations. A 16-tube 150 kWth receiver was finally tested and modeled, proving the process applicability at larger scale.