Electric power systems have been in existence for over a century. Electric power transmission line systems play an important role in carrying electrical power to customers everywhere. The number of transmission lines in power systems is increasing as global demand for power has increased. Parallel transmission lines are widely used in the modern transmission system for higher reliability. The parallel lines method has economic and environmental advantages over single circuit. A fault that occurs on a power transmission line will cause long outage time if the fault location is not located as quickly as possible. The faster the fault location is found, the sooner the system can be restored and outage time can be reduced. The main focus of this research is to develop a new accurate fault location algorithm for parallel transmission lines to identify the fault location for long double-circuit transmission lines, taking into consideration mutual coupling impedance, mutual coupling admittance, and shunt capacitance of the line. In this research, the equivalent PI circuit based on a distributed parameter line model for positive, negative, and zero sequence networks have been constructed for system analysis during the fault. The new method uses only the voltage and current from one end of parallel lines to calculate the fault distance. This research approaches the problem by derivation all equations from positive sequence, negative sequence, and zero sequence network by using KVL and KCL. Then, the fault location is obtained by solving these equations. EMTP has been utilized to generate fault cases under various fault conditions with different fault locations, fault types and fault resistances. Then the algorithm is evaluated using the simulated data. The results have shown that the developed algorithm can achieve highly accurate estimates and is promising for practical applications.

This thesis deals with the high speed transient modelling in the electrical networks. The introduction of this work discusses mathematical models of the individual devices used in the system and focuses on the line representation. It also contains a more detailed description of Bergeron and frequency dependent line model. The objective of this thesis is to design a network model using ATP-EMTP simulation program. In this model, the switching overvoltage caused by shunt reactor switching and lightning overvoltage are simulated. The thesis thoroughly describes the settings of the components used in the model of analysed network and in conclusion evaluates obtained simulation results in a relation to the insulation coordination.