Spelling suggestions: "subject:"drugs controlled release"" "subject:"drugs acontrolled release""
11 |
The evaluation of indomethacin and theophylline oral controlled/modified-release dosage forms in vitro-in vivo correlationsTandt, Ludo Alfons Germaan Luc January 1992 (has links)
Over the past few decades many researchers have investigated the utility of in vitro - in vivo correlations for the assessment of dosage forms. These investigations are, however, dependent on reproducible dissolution data and well conducted biostudies in order to establish meaningful and robust correlations. Despite the fact that the establishment of such correlations is perhaps idealistic, considerable interest has still been shown in this area of research. Various Controlled/Modified Release Dosage Forms (CMRD's) of theophylline, a weakly basic drug, and indomethacin, a weakly acidic drug, were assessed in order to establish in vitro - in vivo correlations. Dissolution rate studies were carried out using either the USP basket or paddle apparatus. The dissolution rate studies were conducted in a range of dissolution media of varying pH. Bioavailability studies were conducted on the dosage forms used by the Biopharmaceutics Research Institute at Rhodes University. The results of these biostudies were kindly made available for use in this research project. Type A correlations were established using a mathematical simulation process whereby expected in vivo responses are simulated and compared to actual profiles obtained for the dosage forms. In order to perform the simulations the dissolution rate profiles were stripped and using linear regression and the methods of residuals the dissolution rate order and the relevant dissolution rates were obtained. The results of the s imulations indicated that the in vivo serum concentration-time curves could be accurately predicted for the theophylline dosage forms but to a lesser extent, for the indomethacin formulations. The dissolution rate studies indicated that the paddle method is a suitable method for dissolution rate studies of theophylline CMRD's, although it appeared that the optimum pH of the dissolution medium was formulation dependent. Dissolution rate studies conducted on indomethacin formulations indicated that the USP specified basket method for extended-release indomethacin formulations was not able to distinguish between two formulations which exhibited different in vivo profiles. The conversion to the paddle method was, however, able to highlight the differences between these formulations. The use of three dimensional topographs to depict dissolution rate profiles was demonstrated for formulations of both theophylline and indomethacin. The topographs enabled the successful differentiation between bioinequivalent formulations. The dissolution rate profiles were also fitted to the Wei bull equation and the parameters obtained from this were compared to the Weibull parameters obtained from the in vivo absorption plots obtained using the Wagner-Nelson method. The results indicated that the Weibull function was suitable to describe both the in vivo and in vitro data. The following recommendations for the preformulation dissolution studies of weakly acidic and weakly basic drugs are proposed. The dissolution rate studies of weakly acid drugs, such as indomethacin, should be carried out over a range of pH utilising the paddle apparatus. Three dimensional topographs based on the dissolution data should be constructed and used as a comparative tool for different formulations. Based on these comparisons the appropriate formulation can then be selected for a pilot scale in vivo bioavailability study. The dissolution rate studies of weakly basic drugs, such as theophylline, should be carried out over a range of pH utilising the paddle apparatus. The dissolution data should then be used to simulate the expected in vivo profile and on this basis the appropriate formulation selected for a pilot scale bioavailability study. The above approach to the preformulation studies of new CMRO's would allow for the more careful selection of new dosage forms and could thus eliminate costly and unnecessary bioavailability studies performed on inferior formulations.
|
12 |
Controlled release of macromolecules from ethylene-vinyl acetate copolymer matrices : microstructure and kinetic analysesBawa, Rajan Sohansingh January 1981 (has links)
Thesis (M.S.)--Massachusetts Institute of Technology, Dept. of Nutrition and Food Science; and, (M.S.)--Massachusetts Institute of Technology, Dept. of Chemical Engineering, 1981. / MICROFICHE COPY AVAILABLE IN ARCHIVES AND SCIENCE / Includes bibliographical references. / by Rajan Sohansingh Bawa. / M.S.
|
13 |
Quantitative magnetic resonance imaging studies of extended drug release systemsChen, Chen January 2014 (has links)
No description available.
|
14 |
Development of Novel hydrogels for protein drug deliveryMawad, Damia, Graduate School of Biomedical Engineering, Faculty of Engineering, UNSW January 2005 (has links)
Introduction: Embolic agents are used to block blood flow of hypervascular tumours, ultimately resulting in target tissue necrosis. However, this therapy is limited by the formation of new blood vessels within the tumour, a process known as angiogenesis. Targeting angiogenesis led to the discovery of anti-angiogenic factors, large molecular weight proteins that can block the angiogenic process. The aim of this research is development of poly (vinyl alcohol) (PVA) aqueous solutions that cross-link in situ to form a hydrogel that functions as an embolic agent for delivery of macromolecular drugs. Methods: PVA (14 kDa, 83% hydrolysed), functionalised by 7 acrylamide groups per chain, was used to prepare 10, 15, and 20wt% non-degradable hydrogels, cured by UV or redox initiation. Structural properties were characterised and the release of FITCDextran (20kDa) was quantified. Degradable networks were then prepared by attaching to PVA (83% and 98 % hydrolysed) ester linkages with an acrylate end group. The effect on degradation profiles was assessed by varying parameters such as macromer concentration, cross-linking density, polymer backbone and curing method. To further enhance the technology, radiopaque degradable PVA was synthesised, and degradation profiles were determined. Cell growth inhibition of modified PVA and degradable products were also investigated. Results: Redox initiation resulted in non-degradable PVA networks of well-controlled structural properties. Increasing the solid content from 10 to 20wt% prolonged the release time from few hours to ~ 2 days but had no effect on the percent release, with only a maximum release of 65% achieved. Ester attachment to the PVA allowed flexibility in designing networks of variable swelling behaviors and degradation times allowing ease of tailoring for specific clinical requirements. Synthesis of radiopaque degradable PVA hydrogels was successful without affecting the polymer solubility in water or its ability to polymerize by redox. This suggested that this novel hydrogel is a potential liquid embolic with enhanced X-ray visibility. Degradable products had negligible cytotoxicity. Conclusion: Novel non-degradable and radiopaque degradable PVA hydrogels cured by redox initiation were developed in this research. The developed PVA hydrogels showed characteristics in vitro that are desirable for the in vivo application as release systems for anti-angiogenic factors.
|
15 |
A novel self-sealing chewable sustained release tablet of acetaminophen ; Development and evaluation of novel itraconazole oral formulations ; A novel zero order release matrix tabletRakkanka, Vipaporn 24 April 2003 (has links)
Graduation date: 2003
|
16 |
Physical and chemical properties of acrylic polymers influencing physical agingKucera, Shawn Anthony, 1974- 29 August 2008 (has links)
The influence of water soluble and insoluble stabilizing excipients on the physical stability of coated dosage forms was investigated in this study. The effect of the excipients on the thermal and physico-mechanical properties, and water vapor permeability of free films was studied, as was the influence of these excipients on the physical stability and release kinetics of coated pellets. The effect of water-soluble proteins, bovine serum albumin (BSA) and Type B gelatin, on the physical aging of Eudragit[trademark] RS/RL 30 D films was investigated. It was found that ionic interactions occurred above the isoelectric point of BSA and caused unstable films which showed accelerated decreases in drug release rate. The adjustment of the pH of the dispersion below the isoelectric point of BSA resulted in electrostatic repulsive charges that stabilized the drug release rate from coated dosage forms at both ambient and accelerated conditions. The addition of gelatin to the coating dispersion increased the drug release rate due to the formation of gel-domains through which the drug was able to easily diffuse. The influence of silicon dioxide on the stability of Eudragit[trademark] RS/RL 30 D films was investigated. Colloidal grades showed enhanced incorporation in the acrylic matrix; however, unstable films were formed. The addition of silicon dioxide with a larger particle size increased the permeability of the film and stabilization in drug release rate was attributed to constant water vapor permeability values of free films. The influence of ethylcellulose on the physical aging of Eudragit[trademark] NE 30 D coated pellets was studied. The two polymers were found to be substantially immiscible and the drug release rate of coated pellets was constant at both ambient and accelerated conditions which correlated to stabilizations in both the physico-mechanical properties and water vapor permeability of free films. Blending both Eudragit[trademark] NE 30 D and RS 30 D resulted in the formation of coherent films without the need of plasticizer. The two polymers were found to be miscible and both films and coated dosage forms were stable when stored below the glass transition temperature of the polymer blend. When films were stored above this temperature, instabilities occurred as a result of the further coalescence and densification of the polymer blend.
|
17 |
Effect of N-Trimethyl chitosan chloride and Monocaprin on insulin permeability across CACO-2 cells.Mphoso, Germina Mamoeti. January 2010 (has links)
Thesis (MTech. degree in Pharmaceutical Sciences)--Tshwane University of Technology, 2010. / Investigates the absorption enchancing properties of N-trimethyl chitosan chloride (TMC) and monocaprin (MC), individually and in combination, on the permeability of insulin across the Caco-2 intestinal epothelial cell line.
|
18 |
Development of Novel hydrogels for protein drug deliveryMawad, Damia, Graduate School of Biomedical Engineering, Faculty of Engineering, UNSW January 2005 (has links)
Introduction: Embolic agents are used to block blood flow of hypervascular tumours, ultimately resulting in target tissue necrosis. However, this therapy is limited by the formation of new blood vessels within the tumour, a process known as angiogenesis. Targeting angiogenesis led to the discovery of anti-angiogenic factors, large molecular weight proteins that can block the angiogenic process. The aim of this research is development of poly (vinyl alcohol) (PVA) aqueous solutions that cross-link in situ to form a hydrogel that functions as an embolic agent for delivery of macromolecular drugs. Methods: PVA (14 kDa, 83% hydrolysed), functionalised by 7 acrylamide groups per chain, was used to prepare 10, 15, and 20wt% non-degradable hydrogels, cured by UV or redox initiation. Structural properties were characterised and the release of FITCDextran (20kDa) was quantified. Degradable networks were then prepared by attaching to PVA (83% and 98 % hydrolysed) ester linkages with an acrylate end group. The effect on degradation profiles was assessed by varying parameters such as macromer concentration, cross-linking density, polymer backbone and curing method. To further enhance the technology, radiopaque degradable PVA was synthesised, and degradation profiles were determined. Cell growth inhibition of modified PVA and degradable products were also investigated. Results: Redox initiation resulted in non-degradable PVA networks of well-controlled structural properties. Increasing the solid content from 10 to 20wt% prolonged the release time from few hours to ~ 2 days but had no effect on the percent release, with only a maximum release of 65% achieved. Ester attachment to the PVA allowed flexibility in designing networks of variable swelling behaviors and degradation times allowing ease of tailoring for specific clinical requirements. Synthesis of radiopaque degradable PVA hydrogels was successful without affecting the polymer solubility in water or its ability to polymerize by redox. This suggested that this novel hydrogel is a potential liquid embolic with enhanced X-ray visibility. Degradable products had negligible cytotoxicity. Conclusion: Novel non-degradable and radiopaque degradable PVA hydrogels cured by redox initiation were developed in this research. The developed PVA hydrogels showed characteristics in vitro that are desirable for the in vivo application as release systems for anti-angiogenic factors.
|
19 |
Development of Novel hydrogels for protein drug deliveryMawad, Damia, Graduate School of Biomedical Engineering, Faculty of Engineering, UNSW January 2005 (has links)
Introduction: Embolic agents are used to block blood flow of hypervascular tumours, ultimately resulting in target tissue necrosis. However, this therapy is limited by the formation of new blood vessels within the tumour, a process known as angiogenesis. Targeting angiogenesis led to the discovery of anti-angiogenic factors, large molecular weight proteins that can block the angiogenic process. The aim of this research is development of poly (vinyl alcohol) (PVA) aqueous solutions that cross-link in situ to form a hydrogel that functions as an embolic agent for delivery of macromolecular drugs. Methods: PVA (14 kDa, 83% hydrolysed), functionalised by 7 acrylamide groups per chain, was used to prepare 10, 15, and 20wt% non-degradable hydrogels, cured by UV or redox initiation. Structural properties were characterised and the release of FITCDextran (20kDa) was quantified. Degradable networks were then prepared by attaching to PVA (83% and 98 % hydrolysed) ester linkages with an acrylate end group. The effect on degradation profiles was assessed by varying parameters such as macromer concentration, cross-linking density, polymer backbone and curing method. To further enhance the technology, radiopaque degradable PVA was synthesised, and degradation profiles were determined. Cell growth inhibition of modified PVA and degradable products were also investigated. Results: Redox initiation resulted in non-degradable PVA networks of well-controlled structural properties. Increasing the solid content from 10 to 20wt% prolonged the release time from few hours to ~ 2 days but had no effect on the percent release, with only a maximum release of 65% achieved. Ester attachment to the PVA allowed flexibility in designing networks of variable swelling behaviors and degradation times allowing ease of tailoring for specific clinical requirements. Synthesis of radiopaque degradable PVA hydrogels was successful without affecting the polymer solubility in water or its ability to polymerize by redox. This suggested that this novel hydrogel is a potential liquid embolic with enhanced X-ray visibility. Degradable products had negligible cytotoxicity. Conclusion: Novel non-degradable and radiopaque degradable PVA hydrogels cured by redox initiation were developed in this research. The developed PVA hydrogels showed characteristics in vitro that are desirable for the in vivo application as release systems for anti-angiogenic factors.
|
20 |
Secondary blooming and mottling in an intravaginal drug release product /Waugh, Brendan Arthur. January 2006 (has links)
Thesis (M.Sc.(Tech.))--University of Waikato, 2006. / Includes bibliographical references (leaves 221-230) Also available via the World Wide Web.
|
Page generated in 0.6037 seconds