Three 3D nonlinear finite-element (FE) models are developed to study the behavior of concrete beams and plates with and without externally reinforcement of fibre reinforced polymer (FRP). Ramtekkar’s mixed layer-wise 3 dimensional (3D) 18-node FE model (108 degrees-of-freedom, DOFs) is modified to accommodate the nonlinear concrete and elasto-plastic steel behaviour. Saenz’s stress-strain equation is used for material nonlinearity of concrete. As in any 3D mixed FE analysis, the run time using the model can be computationally expensive. Two additional layer-wise 18-node FE models: Displacement FE model (54 DOF) and transitional FE model (81 DOF) are developed. The displacement FE model is based on purely displacement field, i.e. only displacement components are enforced throughout the thickness of the structures. The transitional FE model has six DOF (three displacement components in the coordinate axis direction and three transverse stress components - where z is the thickness direction) per node in the upper surface and only three DOF (three displacement components in the coordinate axis direction) per node in the bottom surface.The analysis of reinforced concrete (RC) beam strengthened with FRP and composite plate using these models are verified against the experimental results and the results from the commercial software, ANSYS respectively. Several parametric studies are done on composite RC beam and composite plate.

A materially non-linear layered beam super element is developed for the analysis of RC beams and columns strengthened by externally bonded steel/FRP plates. The elasto-plastic behavior of RC member is incorporated by its internally generated or externally supplied moment-curvature diagram. The steel plate is assumed to be elasto-plastic and the FRP laminate is assumed to behave linearly elastic up to rupture. The thin epoxy layer between the RC member and the externally bonded lamina is simulated by a special interface element which allows for the changing failure modes from steel plate yielding/FRP plate rupture to separation of the bonded plates as a result of bond failure in the epoxy layer. An empirical failure criterion based on test results is used for the epoxy material of the interface. The most critical aspect of such applications in real life frame structures is the anchorage conditions at the member ends and junctions. This has direct influence on the success and the effectiveness of the application. Therefore, a special corner piece anchorage element is also considered in the formulation of the joint super element, which establishes the fixity and continuity conditions at the member ends and the joints.

Zugl.: Köln, Univ., Diss., 2005

Thesis (M.S.)--West Virginia University, 2006. / Title from document title page. Document formatted into pages; contains xi, 73 p. : ill. (some col.). Includes abstract. Includes bibliographical references (p. 52-53).

Thesis (Ph. D.)--University of Adelaide, Dept. of Mechanical Engineering, 1989. / Includes bibliographical references (leaves 140-149).

Thesis (M.E.) -- University of Adelaide, Department of Civil Engineering, 1977.

Thesis (M.S.)--Virginia Polytechnic Institute and State University, 1991. / Vita. Abstract. Includes bibliographical references (leaves 36-37). Also available via the Internet.

Thesis (M.S.)--Rochester Institute of Technology, 1992. / Typescript. Includes bibliographical references.

Thesis (M.S.)--Virginia Polytechnic Institute and State University, 1993. / Vita. Abstract. Includes bibliographical references (leaves 181-183). Also available via the Internet.

Thesis (M.S.)--Virginia Polytechnic Institute and State University, 1993. / Vita. Abstract. Includes bibliographical references (leaves 145-149). Also available via the Internet.