Sterners Specialfabrik AB tillverkar bland annat mynt- och biljettautomater. För att underlätta felsökning, underhåll, avläsning av statistik med mera på en automat är det lämpligt att detta utförs på en PC över Internet. Det innebär att automaten inte behöver besökas då dessa uppgifter skall utföras. Examensarbetet går ut på att få en PIC mikrokontroller att kommunicera med en användare vid en PC över internet. För detta krävs att en TCP/IP stack implementeras på PICmikrokontrollern. Arbetet ledde till en fungerande demoapplikation som klarar av att kommunicera över TCP/IP. Demoapplikationen innehåller diverse olika funktioner för att demonstrera hur en automat skulle kunna styras och övervakas.

This work deals with construction of an embedded system with remote access, whitch controls computers in the same network in order to reduce their energy consumption. For this purpose is used the WakeOnLAN technique. The device also uses two power components called SSR and  these are used for switching AC power to them attached appliances. The work discusses the TCP/IP architecture, system design and finally the firmware implementation.

The goal of the project was to create independent system, which is able to supervise remote site using Ethernet network. It can measure temperature and check state of door magnetic contact. Gained information are sent over network to the cenral node, which is able to present them on web page. In the project are also discussed important network protocols needed for implementation of the system, hardware used for implementation and software of the system.

This diploma project summarizes a theoretical introduction regarding the issue of traffic light control. Further there is industrial communication discussed, where they are the Ethernet / IP protocol and the Modbus TCP protocol described more in detail. The following is the description of the Logix series programmable controllers. Then the diploma follows up with market research in order to find the most suitable development kit which is used as a trial prototype. Then it is concerned with a development kit with a communication module from AND-TECH company. Software was developed on them, more specifically a library for processor ports, memory and the Modbus TCP protocol. After verifying the functionality of the software, the hardware design was started. From the first site it is development kit and module and from the second site there are input and output circuits. There must be the assessment of the results found during the test operation. The end of the document describes incorrect steps that were repaired in hardware.

The aim of my master’s thesis is the design of the LED lighting system for breeding and growing purposes as replacement for the classical high-pressure sodium lamps and other sources of light used today. The whole system can be controlled locally by buttons or remotely by web server using Ethernet interface. LEDs are powered by five-channel step-down converter with current feedback. Converters are controlled by pulse width modulation generated by microcontroller.

This master's thesis is concerned about embedded system for automatic water renewal in aquariums. Besides water renewal system also controls lights and ventilation in aquarium fish breeding station. In this report you will find informtions about technology relevant to automation of aquarium fish breeding station. Also you will find here informations about design and implementation of my specific final working solution.

This project deals with design and implementation of control system, which is used for regulation climate conditions in special grow box. Measured values are displayed on graphic LCD, sent to application in PC or displayed on web server. The project solves software and hardware implementation of measurement system.