We study the integral equation related to the three and higher dimensional superradiance problem. Collective radiation phenomena has attracted the attention of many physicists and chemists since the pioneering work of R. H. Dicke in 1954. We first consider the three-dimensional superradiance problem and find a differential operator that commutes with the integral operator related to the problem. We find all the eigenfunctions of the differential operator and obtain a complete set of eigensolutions for the three-dimensional superradiance problem. Generalization of the three-dimensional superradiance integral equation is provided. A commuting differential operator is found for this generalized problem. For the three dimensional superradiance problem, an alternative set of complete eigenfunctions is also provided. The kernel for the superradiance problem when restricted to one-dimension is the same as appeared in the works of Slepian, Landau and Pollak. The uniqueness of the differential operator commuting with that kernel is indicated. Finally, a concentration problem for the signals which are bandlimited in disjoint frequency-intervals is considered. The problem is to determine which bandlimited signals lose the smallest fraction of their energy when restricted in a given time interval. A numerical algorithm for solution and convergence theorems are given. Orthogonality properties of analytically extended eigenfunctions over L2(−∞,∞) are also proved. Numerical computations are carried out in support of the theory.

Yes / A dynamic response analysis model of a Class E2 converter for wireless power transfer applications is presented. The converter operates at 200 kHz and consists of an induction link with its primary coil driven by a class E inverter and the secondary coil with a voltage-driven class E synchronous rectifier. A seventh-order linear time invariant state-space model is used to obtain the eigenvalues of the system for the four modes resulting from the operation of the converter switches. A participation factor for the four modes is used to find the actual operating point dominant poles for the system response. A dynamic analysis is carried out to investigate the effect of changing the separation distance between the two coils, based on converter performance and the changes required of some circuit parameters to achieve optimum efficiency and stability. The results show good performance in terms of efficiency (90–98%) and maintenance of constant output voltage with dynamic change of capacitance in the inverter. An experiment with coils of the dimension of 53 × 43 × 6 mm3 operating at a resonance frequency of 200 kHz, was created to verify the proposed mathematical model and both were found to be in excellent agreement.

No / A numerical method for sound propagation of higher-order cross-sectional modes in a duct of arbitrary cross-section and boundary conditions with nonzero, complex acoustic admittance has been considered. This method assumes that the cross-section of the duct is uniform and that the duct is of a considerable length so that the longitudinal modes can be neglected. The problem is reduced to a two-dimensional (2D) finite element (FE) solution, from which a set of cross-sectional eigen-values and eigen-functions are determined. This result is used to obtain the modal frequencies, velocities and the attenuation coefficients. The 2D FE solution is then extended to three-dimensional via the normal mode decomposition technique. The numerical solution is validated against experimental data for sound propagation in a pipe with inner walls partially covered by coarse sand or granulated rubber. The values of the eigen-frequencies calculated from the proposed numerical model are validated against those predicted by the standard analytical solution for both a circular and rectangular pipe with rigid walls. It is shown that the considered numerical method is useful for predicting the sound pressure distribution, attenuation, and eigen-frequencies in a duct with acoustically nonrigid boundary conditions. The purpose of this work is to pave the way for the development of an efficient inverse problem solution for the remote characterization of the acoustic boundary conditions in natural and artificial waveguides.