Implanted Devices are important components of the Wireless Body Area Network (WBAN) as a promising technology in biotelemetry, e-health care and hyperthermia applications. The design of WBAN faces many challenges, such as frequency band selection, channel modeling, antenna design, physical layer (PHY) protocol design, medium access control (MAC) protocol design and power source. This research focuses on the design of implanted antennas, channel modeling between implanted devices and Wireless Power Transfer (WPT) for implanted devices. An implanted antenna needs to be small while it maintains Specific Absorption Rate (SAR) and is able to cope with the detuning effect due to the electrical properties of human body tissues. Most of the proposed antennas for implanted applications are electric field antennas, which have a high near-zone electric field and, therefore, a high SAR and are sensitive to the detuning effect. This work is devoted to designing a miniaturized magnetic field antenna to overcome the above limitations. The proposed Electrically Coupled Loop Antenna (ECLA) has a low electric field in the near-zone and, therefore, has a small SAR and is less sensitive to the detuning effect. The performance of ECLA, channel model between implanted devices using Path Loss (PL) and WPT for implanted devices are studied inside different human body models using simulation software and validated using experimental work. The study is done at different frequency bands: Medical Implanted Communication Services (MICS) band, Industrial Scientific and Medical (ISM) band and 3.5 GHz band using ECLA. It was found that the proposed ECLA has a better performance compared to the previous designs of implanted antennas. Based on our study, the MICS band has the best propagation channel inside the human body model among the allowed frequency bands. The maximum PL inside the human body between an implanted antenna and a base station on the surface is about 90 dB. WPT for implanted devices has been investigated as well, and it has been shown that for a device located at 2 cm inside the human body with an antenna radius of 1 cm an efficiency of 63% can be achieved using the proposed ECLA. / Ph. D.

Wireless Power Transfer (WPT) has become quite popular over the recent years. This thesis presents some design challenges while developing a WPT system and describes a system-level methodology for designing an end-to-end system. A critical analysis of contemporary research is performed in the form of a literature survey of both academic and commercial research to understand their benefits and demerits. Some theoretical notes are presented on coupled-mode theory and coupled filter theory and the problems concerning WPT analyzed using these models. The need for higher power transfer efficiency (PTE) and power delivered to load (PDL) is studied using these models. The case for using magnetic antennas over electric antennas when surrounded by lossy media (specifically for the case of human body tissues at various frequencies) is made using some theoretical models and simulation results. An Electrically Coupled Loop Antenna (ECLA) is introduced, studied and designed for two main WPT applications, viz. free space transmission and that of powering implanted devices. An equivalent circuit is proposed to better understand the coupling effects of the antennas on a circuit level and to study the effect of various environmental and structural factors on the coupling coefficient. Some prototypes were created and measured for the two use cases of free space and implanted applications. In order to complete the system design, a negative resistance-based oscillator is designed and fabricated, that incorporates the antennas as a load and oscillates at the required frequency. Some changes in load conditions and power handling are studied by the use of two circuits for free-space (high-power) and implanted (low-power) applications. Finally, the salient points of the thesis are re-iterated and some future work outlined in the concluding chapter. / Master of Science