Master of Science / Department of Electrical and Computer Engineering / Steven Warren / The continuous and autonomous real-time monitoring of cattle state of health can provide major benefits for the U.S. livestock industry and lead to a higher quality beef product. Complete real-time monitoring could not only lead to earlier detection of disease in individual animals and reduce the spread of disease to a larger herd, but it could ultimately reduce the cost and frequency of on-site veterinary consultations. This thesis details a wearable device that is mounted on cattle to collect data from a network of internal and external sensors. In addition to the basic data collection, this thesis will describe the infrastructure to communicate these data sets to a central database for permanent storage and future analysis. Physiological, ambient environment, and physical activity data are acquired by the various sensors to give a good indication of the state of health of an animal wearing the device. The communication of data from internal sensors to an external wearable receiver is of particular interest since tissue is not an ideal medium for radio-frequency data transmission. Past research has attempted to use such links with little success due to large signal attenuation at high frequencies and a package that becomes much too large to be usable at low frequencies. As a result, a wireless communications method employing magnetic inductance at relatively low frequencies over short distances is described here.

Master of Science / Department of Electrical Engineering / William B. Kuhn / Designers of mixed-signal systems must understand coupling mechanisms at the system, PC board, package and integrated circuit levels to control crosstalk, and thereby minimize degradation of system performance. This research examines coupling mechanisms in a RF-targeted high-resistivity partially-depleted Silicon-on-Insulator (SOI) IC process and applying similar coupling mitigation strategies from higher levels of design, proposes techniques to reduce coupling between sub-circuits on-chip. A series of test structures was fabricated with the goal of understanding and reducing the electric and magnetic field coupling at frequencies up to C-Band. Electric field coupling through the active-layer and substrate of the SOI wafer is compared for a variety of isolation methods including use of deep-trench surrounds, blocking channel-stopper implant, blocking metal-fill layers and using substrate contact guard-rings. Magnetic coupling is examined for on-chip inductors utilizing counter-winding techniques, using metal shields above noisy circuits, and through the relationship between separation and the coupling coefficient. Finally, coupling between bond pads employing the most effective electric field isolation strategies is examined. Lumped element circuit models are developed to show how different coupling mitigation strategies perform. Major conclusions relative to substrate coupling are 1) substrates with resistivity 1 kΩ·cm or greater act largely as a high-K insulators at sufficiently high frequency, 2) compared to capacitive coupling paths through the substrate, coupling through metal-fill has little effect and 3) the use of substrate contact guard-rings in multi-ground domain designs can result in significant coupling between domains if proper isolation strategies such as the use of deep-trench surrounds are not employed. The electric field coupling, in general, is strongly dependent on the impedance of the active-layer and frequency, with isolation exceeding 80 dB below 100 MHz and relatively high coupling values of 40 dB or more at upper S-band frequencies, depending on the geometries and mitigation strategy used. Magnetic coupling was found to be a strong function of circuit separation and the height of metal shields above the circuits. Finally, bond pads utilizing substrate contact guard-rings resulted in the highest degree of isolation and the lowest pad load capacitance of the methods tested.

Doctor of Philosophy / Department of Electrical and Computer Engineering / William B. Kuhn / Balasubramaniam Natarajan / Wireless body area networks (WBANs) are an important part of the developing internet of things (IOT). NASA currently uses space suits with wired sensors to collect limited biomedical data. Continuous monitoring and collecting more extensive body vital signs is important to assess astronaut health. This dissertation investigates wireless biomedical sensor systems that can be easily incorporated into future space suits to enable real time astronaut health monitoring. The focus of the work is on the radio-wave channel and associated antennas. We show that the space suit forms a unique propagation environment where the outer layers of the suit’s thermal micrometeoroid garment are largely radio opaque. This environment can be modeled as a coaxial one in which the body itself plays the role of the coax center conductor while the space suit shielding materials play the role of the outer shield. This model is then validated through simulations and experiments. Selecting the best frequency of operation is a complex mixture of requirements, including frequency allocations, attenuation in propagation, and antenna size. We investigate the propagation characteristics for various frequency bands from 315 MHz to 5.2 GHz. Signal attenuation is analyzed as a function of frequency for various communication pathways through 3D simulations and laboratory experiments. Small-scale radio channel results indicate that using lower frequency results in minimal path loss. On the other hand, measurements conducted on a full-scale model suggest that 433 MHz and 2400 MHz yield acceptable path loss values. Propagation between the left wrist and left ankle yielded the worst overall path loss, but signals were still above –100 dBm in raw measurements for a 0dBm transmission indicating that the intra-suit environment is conducive to wireless propagation. Our findings suggest that the UHF bands are best candidate bands since there is interplay between the body conductivity favoring lower frequencies, and the difficulty of coupling RF energy into and out of the channel using suitably sized antennas favoring higher frequencies. Finally, a new self-shielded folded bow-tie antenna is proposed that can be a promising choice for the general area of WBAN technologies as well as potential new space suit environments.