The success of the wavelet transform in the compression of still images has prompted an expanding effort to exercise this transform in the compression of video. Most existing video compression methods incorporate techniques from still image compression, such techniques being abundant, well defined and successful. This dissertation commences with a thorough review and comparison of wavelet still image compression techniques. Thereafter an examination of wavelet video compression techniques is presented. Currently, the most effective video compression system is the DCT based framework, thus a comparison between these and the wavelet techniques is also given. Based on this review, this dissertation then presents a new, low-complexity, wavelet video compression scheme. Noting from a complexity study that the generation of temporally decorrelated, residual frames represents a significant computational burden, this scheme uses the simplest such technique; difference frames. In the case of local motion, these difference frames exhibit strong spatial clustering of significant coefficients. A simple spatial syntax is created by splitting the difference frame into tiles. Advantage of the spatial clustering may then be taken by adaptive bit allocation between the tiles. This is the central idea of the method. In order to minimize the total distortion of the frame, the scheme uses the new p-domain rate-distortion estimation scheme with global numerical optimization to predict the optimal distribution of bits between tiles. Thereafter each tile is independently wavelet transformed and compressed using the SPIHT technique. Throughout the design process computational efficiency was the design imperative, thus leading to a real-time, software only, video compression scheme. The scheme is finally compared to both the current video compression standards and the leading wavelet schemes from the literature in terms of computational complexity visual quality. It is found that for local motion scenes the proposed algorithm executes approximately an order of magnitude faster than these methods, and presents output of similar quality. This algorithm is found to be suitable for implementation in mobile and embedded devices due to its moderate memory and computational requirements. / Thesis (M.Sc.Eng.)-University of Natal, Durban, 2003.

Broadcasting authorities presently measure intermodulation distortion by applying a three tone simulation of a composite video and sound signal to the transposer and then measuring the relative amplitude of the major in-band intermodulation product (nominally at vision carrier frequency plus 1,57 MHz in the 625 line I/PAL System) on a spectrum analyser. This method is slow and requires a skilful operator to achieve repeatable results. Furthermore it tests the common RF amplification equipment at one luminance level and one chrominance level and therefore does not subject the transposer equipment to operation over its full range. A new sampling measurement technique has been proposed which overcomes all these problems by selectively mixing, while transmitting a colour bar test pattern, the demodulated output video signal of the frequency transposer with a pulse train coinciding with a particular colour. This thesis describes the design of a very stable proportional timing generator and its application to the measurement of intermodulation distortion on frequency transposers. The timing generator, which locks automatically onto the video signal and produces narrow sampling pulses which coincide accurately with a particular section of each line over a 50°C temperature range, is applicable to all PAL and NTSC TV Systems. / Thesis (Ph.D.)-University of Natal, Durban, 1989.