No description available.

Nanoelectrochemistry explores the differences in chemical behaviour at the nanoscale as compared to the macro-scale. This thesis is concerned with nanoelectrochemistry and aims to develop and apply novel experiments for the unambiguous identification of changed electrode kinetics at the nanoscale. This is challenging since electrochemical responses are controlled by diverse factors like enhanced mass transport and adsorption as well as electron transfer kinetics. A joint computational and experimental strategy is employed. Chapter 1, 2 and 3 cover essential introductory material and basic experimental details relevant to all experiment. Fuller descriptions and details are given in the following chapters as and when needed. Chapter 4 reports the development of an electrochemical characterization method, to achieve a fast and simple quantification of the average particle size and the number of nanoparticles deposited on a glassy carbon electrode. The method consists of surface area characterization by underpotential deposition of lead particles and the determination of the amount of gold from anodic stripping in HCl. This method is also proven to be effective by comparing the results with SEM measurements. Next, in chapter 5, a generic strategy combining computation and experimental approach is developed in order to study the electron transfer kinetics of gold nanoparticles. The modelling part considers the kinetics of the electrochemical process on the bulk materials for different regions in the electrode, that is, the substrate (glassy carbon) and the nanoparticles (gold). Comparison of experimental and theoretical results enables the detection of changes in the electrode kinetics at the nanoscale. This approach is applied into the electro-oxidations of nitrite and L-ascorbic acid for gold nanoparticles from 20 - 90 nm. In the former, analysing the system shows that no change in electron transfer kinetics is involved in the process, even though a decrease of the over-potential and an increase in the peak current are observed. But these changes reflect mass transport effects, not electrocatalysis. A case where an authentic enhanced electron transfer kinetic change occurs is shown for the ascorbic acid system. Finally, in chapter 6 , the above strategy is exploited further to apply a quantitative study of electron transfer kinetics for various sizes of gold nanoparticles in the oxygen reduction reaction system in sulphuric acid at 298 K. The latter is at the heart of energy transformation techniques (fuel cells, battery and so on). Compared with the electron transfer kinetics on macro gold electrodes, there is no change at gold nanoparticles from size 5 nm to 40 nm. However, in the presence of Pb(II), a strong enhancement of electron transfer kinetics is observed on 5 nm citrate capped gold nanoparticles for ORR. On the other hand, a significant decrease of electron transfer kinetics has been found for gold nanoparticles of size 2 nm for ORR. The latter observation of strong negative electrocatalysis is also observed for the hydrogen evolution reaction (HER). This represents the first report of such effects with the HER system. Overall the thesis has established a rigurous, theoretical basis for evaluating electrocatalysis in nanoparticulate system.

Steady state reflectance and emission characteristics of anthracene adsorbed on silica gel and titania-silica mixed oxides have been investigated as a function of sample loading. Titania-silica mixed oxides with 1, 3, 5 and 10 wt. % TiO2 were prepared by two different methods: a dropwise method and a sol-gel route. Ground state diffuse reflectance and fluorescence emission spectra of anthracene adsorbed on titania-silica surfaces show a dependence on titania content. The absorption peaks of anthracene are difficult to resolve at higher titania content due to the increasing red-shift of the titania absorption edge. The absorption edge of titania is shifted to longer wavelengths and the band gap energy decreases with increasing the titania loading. Diffuse reflectance laser flash photolysis at 355 nm produces both the triplet and radical cation of anthracene and gives relevant information regarding the photochemical transients and the kinetics details of the surface photochemical processes. Energy dependence studies confirm the monophotonic nature of the triplet production, whereas the anthracene radical cation is formed by monophoton or multiphoton ionisation in the mixed titania-silica systems. Energy and electron transfer reactions of anthracene co-adsorbed with azulene as electron donor on silica sol-gel and titania-silica mixed oxides prepared by the sol-gel method with different titania content have been studied using the time-resolved diffuse reflectance laser flash photolysis technique. The fluorescence of excited anthracene adsorbed on silica sol-gel is quenched by the addition of azulene, while co-adsorption of azulene on titania-silica mixed oxides resulted in a decrease in the fluorescence intensity of the adsorbed anthracene due to the formation, at the same time, of anthracene radical cation and Ti3+ species on the titania-silica surface. Triplet-triplet energy transfer from the excited anthracene to ground state azulene and electron transfer from azulene to the anthracene radical cation have been investigated using a time-resolved diffuse reflectance laser flash photolysis technique following laser excitation at 355 nm. Bimolecular rate constants for energy and electron transfer between anthracene and azulene have been obtained. Kinetic analysis of the decay of the anthracene triplet state and radical cation show that the kinetic parameters depend on the titania content of the sample and the azulene concentration. This indicates that the rate of energy and electron transfer reactions increases as a function of azulene concentration and decreases with increasing titania content in titania-silica mixed oxides, whereas the observed rate of reaction on silica sol-gel is predominantly governed by the rate of diffusion of azulene. Electron transfer reactions in a ternary system using azulene for hole transfer between 9-anthracenecarboxylic acid radical cation as electron acceptor and perylene as electron donor were also studied in order to demonstrate the mobility of radical cations on the silica sol-gel and titania-silica surfaces. The co-adsorption of azulene as a molecule shuttle with 9-anthracenecarboxylic acid and perylene on both silica sol-gel and titania-silica systems has been shown to enhance the rate of electron transfer in this ternary system. Activation energies for energy and electron transfer on photoinduced bimolecular and termolecular processes on silica sol-gel and titania-silica mixed oxides have been measured. In bimolecular anthracene / azulene systems, at higher azulene loadings, the activation energies and the pre-exponential factors on titania-silica surfaces are the same for both energy and electron transfer and are comparable with the parameters extracted for azulene diffusion on silica Davisil suggesting that azulene diffuses across the silica Davisil and titania-silica mixed oxides surfaces, while at lower azulene loadings, ion-electron recombination dominates and the activation energy extracted is for this process. In a ternary 9-anthracenecarboxylic acid / azulene / perylene system, the activation energy for perylene diffusion is higher than that observed for the anthracene / azulene system, reflecting the lower mobility of the perylene molecule. In this study, a series of titania-silica samples with different loadings of titania (1 10 wt. %) prepared by the sol-gel method and also the pure TiO2 P25 Degussa have been used to study the photocatalytic degradation of 4-chlorophenol in aqueous solution under UV light irradiation. The absorption peak of 4-chlorophenol at 280 nm decreases with increasing titania content and finally disappeared suggesting that titania has a positive influence on the degradation of 4-chlorophenol. The investigated titania-silica mixed oxides prepared by the sol-gel method are less efficient photocatalysts for the degradation of 4-chlorophenol than TiO2 P25.

As part of the study, photosynthetic system constructs based on BF2-chelated dipyrromethene (BODIPY), BF2-chelated azadipyrromethene (AzaBODIPY), porphyrin, phthalocyanine, oxasmaragdyrin, polythiophene, fullerene (C60), single-walled carbon nanotube and graphene are investigated. Antenna systems of BODIPY dyads and oligomers having BODIPY as an excitation energy donor connected to different acceptors including BODIPY, azaBODIPY, oxasmaragdyrin and aluminum porphyrin are studied. Different synthetic methodologies are used to afford donor-acceptor systems either directly linked with no spacer or with short spacers of varying length and orientation. The effect of donor orientation, donor optical gap as well as nature of donor-acceptor coupling on the donor-acceptor spectral overlap and hence the rate of excitation energy transfer is investigated. In all these systems, an ultrafast energy transfer followed by electron transfer is observed. In particular, in a directly connected BODIPY-azaBODIPY dyad an unusually ultrafast energy transfer (~ 150−200 f) via Förster mechanism is observed. The observation of energy transfer via Förster instead of Dexter mechanism in such closely coupled donor-acceptor systems shows the balance between spatial and electronic coupling achieved in the donor-acceptor system. Moreover, in donor-acceptor systems involving semiconducting 1D and 2D materials, covalently functionalized single-walled carbon nanotubes via charge stabilizing (TPA)3ZnP and noncovalently hybridized exfoliated graphene via polythiophene chromophores are studied for their charge transportation functions. In both cases, not only an ultrafast charge transfer in the range of (~ 2−5 p) is observed but also the charge-separated states were long lived implying the potential of these functionalized materials as efficient charge transporting substrates with organic chromophores for photovoltaic and optoelectronic applications where ultrafast intercomponent charge transfer is vital. In addition, as a final part of this dissertation, the mechanisms of electron injection and back electron transfer in heterogeneous systems involving supramolecularly anchored high potential chromophores on TiO2 film are studied by femtosecond transient absorption spectroscopy. In this study, not only are important insights gained on the utilization of supramolecular anchoring of chromophores such as porphyrins, phthalocyanines, and their perflorinated high potential analogues, chromophores currently showing promise as highly efficient sensitizers in dye sensitized solar cells, on TiO2 film but also on the effect of anchor length and sensitizer orientation on the rates of electron injection and back electron transfer at the sensitizer-TiO2 interface.