M.Phil. / This dissertation describes the design and experimental realization of an all-optical active Q-switched Erbium-doped fibre ring laser. The aim of this research is to propose an approach of Q-switching mechanism for a fibre laser. The Q-switch device combines a fibre Bragg grating and a tunable fibre Fabry-Perot filter. The Q-switching principle is based on dynamic spectral overlapping of two filters, namely FBG based filter and tunable F-P filter. When the spectra overlap, the filter system has the maximum transparency, the laser cavity has minimal losses and it can release the stored power in the form of the giant impulse. A series of experiments are performed to optimize the all-optical active Q-switched Erbium-doped ring laser system in term of output peak power and time duration of laser pulses. Two different Erbium-doped fibres having different Erbium ion concentration are used in this experimental investigation. The first fibre, with an Erbium ion concentration of 2200 ppm and pump absorption of 23.4 at 980 nm is referred to as “high concentration” and the second with an Erbium ion concentration of 960 ppm and pump absorption of 12.4 at 980 nm is referred to as “low concentration” To optimize the Q-switched fibre laser system, different parameters were investigated such as the length of the Erbium-doped fibre, the output coupling ratio, the repetition rate of pulses and the concentration of the Erbium Doped Fibres. The achieved output laser pulse characteristics, peak power and time duration, were 580 mW and 13 μs respectively, at 1 kHz of repetition rate. These characteristics were obtained using a length of 3.5 m “low concentration” Erbium-doped fibre in a ring laser cavity; the output coupling is 90 %, for a pump power of 80 mW. Employing this all-optical Q-switching approach, a simple, robust all-optical active Q-switched Erbium-doped laser is demonstrated.