Although it has been well established that abnormal group delay is a real physical phenomenon and is not in violation of Einstein causality, there has been little investigation into whether or not such abnormal behaviour can be used to reduce signal latency in practical communication systems in the presence of noise. In this thesis, we use time-varying probability of error to determine if abnormal group delay “channels” can offer reduced signal latency. Since the detection system plays a critical role in the analysis, three important detection systems are considered: the correlation, matched filter and envelope detection systems. Our analysis shows that for both spatially negligible microelectronic systems and spatially extended microwave systems, negative group delay “channels” offer reduced signal latency as compared to conventional “channels”. The results presented in the thesis can be used to design a new generation of electronic and microwave interconnects with reduced or eliminated signal latency.

Parameter estimation and signal detection are the two key components of a wireless communication system. They directly impact the bit-error-ratio (BER) performance of the system. Several criteria have been successfully applied for parameter estimation and signal detection. They include maximum likelihood (ML), maximum a-posteriori probability (MAP), least square (LS) and minimum mean square error (MMSE) etc. In the linear detection framework, linear MMSE (LMMSE) and LS are the most popular ones. Nevertheless, these criteria do not necessarily minimize the BER, which is one of the key aspect of any communication receiver design. Thus, minimization of BER is tantamount to an important design criterion for a wireless receiver, the minimum bit/symbol error ratio (MBER/MSER). We term this design criterion as the minimum-error-probability (MEP). In this thesis, parameter estimation and signal detection have been extensively studied based on the MEP framework for various unexplored scenar-ios of a wireless communication system. Thus, this thesis has two broad categories of explorations, first parameter estimation and then signal detection. Traditionally, the MEP criterion has been well studied in the context of the discrete signal detection in the last one decade, albeit we explore this framework for the continuous parameter es-timation. We first use this framework for channel estimation in a frequency flat fading single-input single-output (SISO) system and then extend this framework to the carrier frequency offset (CFO) estimation of multi-user MIMO OFDM system. We observe a reasonably good SNR improvement to the tune of 1 to 2.5 dB at a fixed BER (tentatively at 10−3). In this context, it is extended to the scenario of multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) or MIMO-OFDM with pa-rameter estimation error statistics obtained from LMMSE only and checked its effect at the equalizer design using MEP and LMMSE criteria. In the second exploration of the MEP criterion, it is explored for signal detection in the context of MIMO-relay and MIMO systems. Various low complexity solutions are proposed to alleviate the effect of high computational complexity for the MIMO-relay. We also consider various configurations of relay like cognitive, parallel and multi-hop relaying. We also propose a data trans-mission scheme with a rate of 1/Ns (Ns is the number of antennas at the transmitter) with the help of the MEP criterion to design various components. In all these cases, we obtain considerable BER improvement compared to the existing solutions.

Traditionally, source coding (data compression) and channel coding (error protection) are performed separately and sequentially, resulting in what we call a tandem (separate) coding system. In practical implementations, however, tandem coding might involve a large delay and a high coding/decoding complexity, since one needs to remove the redundancy in the source coding part and then insert certain redundancy in the channel coding part. On the other hand, joint source-channel coding (JSCC), which coordinates source and channel coding or combines them into a single step, may offer substantial improvements over the tandem coding approach. This thesis deals with the fundamental Shannon-theoretic limits for a variety of communication systems via JSCC. More specifically, we investigate the reliability function (which is the largest rate at which the coding probability of error vanishes exponentially with increasing blocklength) for JSCC for the following discrete-time communication systems: (i) discrete memoryless systems; (ii) discrete memoryless systems with perfect channel feedback; (iii) discrete memoryless systems with source side information; (iv) discrete systems with Markovian memory; (v) continuous-valued (particularly Gaussian) memoryless systems; (vi) discrete asymmetric 2-user source-channel systems. For the above systems, we establish upper and lower bounds for the JSCC reliability function and we analytically compute these bounds. The conditions for which the upper and lower bounds coincide are also provided. We show that the conditions are satisfied for a large class of source-channel systems, and hence exactly determine the reliability function. We next provide a systematic comparison between the JSCC reliability function and the tandem coding reliability function (the reliability function resulting from separate source and channel coding). We show that the JSCC reliability function is substantially larger than the tandem coding reliability function for most cases. In particular, the JSCC reliability function is close to twice as large as the tandem coding reliability function for many source-channel pairs. This exponent gain provides a theoretical underpinning and justification for JSCC design as opposed to the widely used tandem coding method, since JSCC will yield a faster exponential rate of decay for the system error probability and thus provides substantial reductions in complexity and coding/decoding delay for real-world communication systems. / Thesis (Ph.D, Mathematics & Statistics) -- Queen's University, 2008-05-13 22:31:56.425