Spelling suggestions: "subject:"eucalyptus grandissements."" "subject:"eucalyptus transgenetics.""
1 |
Broad and narrow sense heritabilities in a cloned open polinated Eucalyptus grandis breeding populationSnedden, Cynthia Louise 09 February 2006 (has links)
Genetic variances and heritabilities in a cloned Eucalyptus grandis breeding population of families derived from open pollinated selections were estimated and the results are presented. The genetic variance was partitioned into additive and non-additive genetic variance components that allowed the estimation of broad and narrow sense heritabilities. Predicted gains for breeding and production population options are discussed. The magnitude of the coefficient of relationship between sibs was shown to have a considerable impact on the estimate of variance components and the importance of understanding the level of relatedness in the population is highlighted. Growth traits (volume, diameter at breast height/DBH, height), stem from and disease tolerance were assessed at 38 and 66 months in each of the three separate trials established as sub-populations of the breeding population. The additive genetic variance was the largest proportion of genetic variance for the growth traits (84% for volume, 94% for height and 74% for DBH), whereas the proportion of non-additive genetic variance was notably higher for stem form and disease tolerance (37% and 46% respectively). The growth traits and stem from are, economically, the most important traits and a breeding strategy that exploits the additive genetic variation by selection to increase the frequency of the alleles causing the desirable genotypes is appropriate. The higher proportion of non-additive genetic variance for disease does, however, suggest higher gains (compared with the afore-mentioned strategy of selection for general combining ability) will be achieved by exploiting the non-additive variance by for example, selection for specific combining ability, using inbred lines, clones. The composition of the genetic variance was investigated separately in the F1 and F2 families to obtain an indication of whether or not there was a change in proportion of non-additive and additive genetic variance over the two generations. A notably larger proportion of non-additive variance was found for the growth traits and stem form among the F2 families. This is probably due to the reduction in additive variance through selection for these traits in the previous generations. No selection for disease took place in earlier generations and the proportion of non-additive genetic variance for this trait remains approximately the same over both generations. These results may indicate that with advanced generations of breeding in this population, that gains achieved through selection for additive variance will decline compared with that achieved in previous generations. A strategy for future generations that exploits non-additive variance may be appropriate. A high proportion of error variance was estimated and in situations such as these, cloning is particularly beneficial as is shown by the high clone mean heritabilities estimated in these trials. High mortality, resulting in fewer ramets per clone, erodes the benefit of cloning in these trials. The predicted gains showed the benefit of the cloned breeding population both in terms of breeding population gains and production population gains. Reducing the breeding cycle by bulking up clones faster will also increase gains per year. High gains in the production population were predicted, particularly for the selection of tested clones for deployment, which can be done at the same time as selections are made for the next generation. The benefit of the cloned population was therefore shown to be twofold, namely increasing the accuracy of within family selection and increasing the gains in the rapid deployment of tested clones and therefore facilitating the faster realization of predicted gain in the plantation. / Dissertation (MSc (Genetics))--University of Pretoria, 2007. / Genetics / unrestricted
|
2 |
Investigation of the application of best linear prediction for breeding and clonal production purposes in a Eucalyptus grandis population.Louw, Andrea Kate. 28 November 2013 (has links)
The genus Eucalyptus has been planted extensively throughout the world in tropical and
subtropical regions, primarily because of its economic importance and use in wood and pulp
production. Due to the growing demands for timber, forestry companies need to increase the
productivity of available forest land. The genetic improvement of forest trees through selection and
breeding involves a lengthy process of scientifically controlled trials focused on short-term and
long-term goals using breeding and production populations. This investigation focused on the use
of Best Linear Prediction (BLP) and its application to: (1) the prediction of genetic gains for a
breeding population and, (2) the selection of superior individuals for clonal production of E. grandis.
A CSIR dataset for a 20-year-old progeny trial involving 90 open-pollinated families was obtained.
Four traits, namely, diameter at breast height (DBH), stem form, splitting and density were
identified for use in this investigation. Relevant data were extracted and a file termed, Dataset created. Dataset was edited, standardized and corrected for the fixed effect of replication using SAS® procedures.
Precise and accurate population parameter estimates are fundamental in determining breeding
strategies and thus, heritabilities of each trait and phenotypic correlations between traits in Dataset were estimated using SAS® procedures. DBH was found to have the highest heritability (0.600),
followed by density (0.492). The estimated heritability for stem form was 0.401 and splitting had the
lowest heritability at 0.214. A high positive phenotypic correlation of 0.83 was estimated between
DBH and stem form. The phenotypic correlations between other traits were close to zero.
An index provides a weighted score for individuals, which takes all relevant information into
account and allows individuals or families to be chosen for breeding and production purposes.
Consequently, Best Linear Prediction (BLP) of individual breeding values were calculated using
MATGEN® (2003). Thereafter, BLP values were used to determine the rankings of individual trees for 15 different selection indices.
In order to determine the effect of selection on the change in the population mean of a trait, the
breeding population's response to selection was predicted and compared across three selection
strategies, namely: (1) individual selection, (2) single-trait index selection, and (3) multiple-trait
index selection. The top 8% of individuals in the breeding population were selected for and the
genetic gains were predicted. It was found that the response to selection was greatest when using
individual selection. Furthermore, DBH had the best selection response for all three strategies as compared to the other traits under investigation.
Fifteen indices, considering different numbers and choice of traits, were compared for commonality
among rankings of the top 30 individuals. Two methods, namely, (1) a rank-correlation matrix and
(2) a manual assessment, were used. The commonality between indices showed that a simple
index, considering two traits (DBH and density) was equally effective (93%) in identifying
genetically-superior individuals as the more complex index that considered four traits. Furthermore,
it was possible to select for only three traits (DBH, splitting, density) and identify the same top 30
individuals as using the index that considered four traits.
The researcher's goal was to find the most desirable individuals in the population to be used for
production purposes, such as clonal forestry. Consequently, various selection options, specifying
certain trait requirements, were used to select superior individuals for use in production and
deployment. The "commercial selection" option was the only option successful in obtaining an
individual that met the required criteria for the four traits in the population of 475 individuals. The
results suggested that breeders should consider large populations and only a few important traits
in order to obtain a greater number of individuals suitable for mass propagation in clonal forestry.
In order to further investigate the effect of population size on the number of individuals suitable for
clonal forestry, a hypothetical population was generated. This was accomplished using between
family and within family standard deviation values obtained from Dataset. The large hypothetical
population of 1000 individuals produced twelve individuals suitable for production purposes, as
opposed to only one in the real population of 475 individuals. This result further indicates that a
larger population provides a greater number of individuals appropriate for use in production and deployment.
This investigation successfully addressed the aims by: (1) calculating individual breeding values
(BLP) and ranking individuals, (2) predicting the breeding population's response to selection,
according to three strategies, for the four traits under investigation, and (3) identifying superior individuals for use in commercial clonal forestry.
As the work of tree breeders is aimed at improving the growth and quality of trees by increasing the
frequency of desirable genotypes in the population, further research could focus on (1) the effect of
different sets of economic weightings on index rankings in a population and (2) the influence that
population structure has on the optimal genetic gains obtained. / Thesis (M.Sc.)-University of KwaZulu-Natal, Pietermaritzburg, 2006.
|
Page generated in 0.071 seconds