The demand for deep fried chips by public and the number of people entering the fast food industry in the form of fast food outlets has increased tremendously. Frying oils are very expensive and are the most important ingredient used in the preparation of fried foods. Due to high oil costs and lack of knowledge, frying oils are used to their maximum. This has resulted in the abuse of deep fried chip cooking oils. The overall quality of the deep fried chip cooking oil used in the South Central Operational Entity of the eThekwini Municipality is not known but abused cooking oils have been identified by Environmental Health Practitioners (EHP's) during routine inspections of fast food outlets. Considering all of the above, the objectives of the proposed research were: (l) Determine the overall prevalence of the use of abused deep fried chip cooking oils at fast food outlets in the South Central Operational Entity of the eThekwini Municipality. (2) Determine in which supervision areas in the South Central Operational Entity the use of abused cooking oil is most prevalent. (3) Determine current/reported practices in preserving the quality of chip oil. (4) Make appropriate recommendations to owner/managers of the fast food outlets and to Environmental Health Practitioners. The study design was observational utilizing a Rapid Epidemiological Assessment (REA) technique, with both a descriptive and analytical component. All fast food outlets making deep fried chips in the South Central Operational Entity registered with the eThekwini Health Department at the time of the study were included in the study population. The Lot Quality Assurance Sampling (LQAS) method was used to determine the overall prevalence of the use of abused oil and to determine supervision areas reached the predetermined service target. A total of 100 fast food outlets were sampled. An oil sample from each fast food outlet, which was taken and sent to a laboratory where an Oxifrit Test was done on every oil sample taken. The Oxifrit Test was the benchmark in this study. EHP's of eThekwini Municipality collected further data by means of an observational checklist and a closed-ended questionnaire, which aimed to establish cooking oil preservation practices. The study revealed that 60 of the outlets had oil that was acceptable whereas 40 had oil that was unacceptable (abused oil). In the multivariate analysis the only factors significantly associated with abused oil were the condition of the fryer and frequency of oil change. Supervision Areas 6, and 4 had more abused deep fried chip cooking oil than average in the South Central Operational Entity. For further prioritization, Supervision Areas 6 and 4 fell below the decision rule for majority of acceptable oil preservation practices, thus Supervision Areas 6 and 4 will be targeted for intervention. Intervention will include education, monitoring and ultimately enforcing the law by EHP's to ensure safe use of deep fried chip cooking oil in the South Central Operational Entity within eThekwini Municipality. / Thesis (M.P.H.)-University of KwaZulu-Natal, 2006.

Thesis (MTech (Engineering))--Cape Peninsula University of Technology, 2008 / While there is a standard for quality and environmental auditors, there is no local or international standard for food safety auditing, which means auditors from different certification bodies can use their own discretion when auditing food establishments. There is a requirement to investigate the quality of work performed by South African food safety auditors. in order to establish whether they do in fact add value when conducting registration and certification audits. This is also an indication of the importance of improving and maintaining a high standard of food safety in the food services industry. The overall concept of food safety in South Africa IS clearly not defined. understood by only a few consumers, and not widely accepted. Research has shown that food retailers in South Africa in general do not believe food safety auditors are competent. In the wake of the Sudan Red scare two years ago. a long awaited food safety initiative was launched in February 2006. The scare pertaining to a carcinogenic food dye. which found its way into spices on local supermarket shelves, mobilized food industry role players to improve food safety standards. Under the auspices of the Consumer Goods Council of South Africa (CGCSA), the body responsible for establishing best practices and implementation standards, Food Safety South Africa (FSSA) will enable an organization to determine the exact nature and extent of possible and actual problems along the food supply chain. The key objectives of this research study are to determine whether one food certification standard is needed in South Africa and to assess the value added by the food auditors to their clients. Social research will be conducted within the ambit of the dissertation, with case study serving as research method. Both quantitative and qualitative research paradigms will be used to gather data for the research survey in support of the research question. forming the crux of the dissertation which reads as follow: "How can food safety auditors increase value added to the audit process in food environments in South Africa?"

A macroscopic model describing the main physiological phenomena observed during the fed-batch baker’s yeast production process and including the influence of nitrogen on the key bio-mechanisms is proposed. First, on the basis of a set of biological reactions, inspired by the model of Sonnleitner and Käppeli, a model in which the nitrogen and glucose consumption are coordinated is proposed. Second, an attempt of estimating storage carbohydrate contents in yeast cells through an extension of this model is presented. The model is identified and validated with experimental data of fed-batch yeast cultures and successfully predicts the dynamics of cell growth, substrate consumption (nitrogen and carbon sources) and metabolite production (ethanol and storage carbohydrates). <p><p>The developed model was used for the determination of optimal operating conditions, in the sense of a production criterion. To this end, two different approaches were used: a control vector parameterization approach and a semi-analytical formulation of the optimal operating policy. The two approaches were compared with numerical and experimental data. The results of the two approaches lead to the determination of similar optimal operation conditions, which have been implemented for a new experimental phase. Moreover, these optimal conditions are in agreement with the profiles obtained by industrial manufacturers through an empirical optimization of the process.<p> / Doctorat en Sciences de l'ingénieur / info:eu-repo/semantics/nonPublished