233 U est le noyau fissile produit dans le cycle du combustible 232 T h/233 U qui a été proposé comme une alternative plus sûre et plus propre du cycle 238 U/239 P u. La connaissance précise de la section efficace de capture de neutrons de cet isotope est requise avec une haute précision pour la conception et le développement de réacteurs utilisant ce cycle du combustible. Les deux seuls jeux de données expérimentales fiables pour la section efficace de capture de l’233 U montrent des écarts important allant jusqu’à 20%. Ces différences peuvent être dues à desincertitudes systématiques associées à l'efficacité du détecteur, la correction du temps mort, la soustraction du bruit de fond et le phénomène d’empilement de signaux causé par la forteactivité α de l’échantillon. Un dispositif expérimental dédié a la mesure simultanée des sections efficaces de fission et de capture des noyaux fissiles radioactifs a été conçu, assemblé et optimiséau CENBG dans le cadre de ce travail. La mesure sera effectuée à l’installation de temps de vol de neutrons Gelina de l’IRMM, où les sections efficaces neutroniques peuvent être mesurées sur une large gamme d’énergie avec une haute résolution énergétique. Le détecteur de fission se compose d’une chambre à ionisation (CI) multi-plaque de haute efficacité. Les rayons γ produits dans les réactions de capture sont détectés par un ensemble de six scintillateurs C6 D6entourant la CI. Dans ces mesures, les rayons γ de la capture radiative sont masqués parle grand nombre de rayons γ de fission, ce qui représente le problème le plus délicat. Ces γ parasites doivent être soustraits par la détection des événements de fission avec une efficacité très bien connue (méthode de VETO). Une détermination précise de cette efficacité est assezdifficile. Dans ce travail, nous avons soigneusement étudié la méthode des neutrons prompts de fission pour la mesure de l'efficacité de la CI, apportant un éclairage nouveau sur la méthode, ce qui a permi d’obtenir une excellente précision sur l'efficacité de détection des fission d’une sourcede 252 Cf. Avec cette même source, plusieurs paramètres (pression du gaz, haute tension et la distance entre les électrodes) ont été étudiés afin de déterminer le comportement de la CI et detrouver le point de fonctionnement idéal : une bonne séparation énergétique entre les particulesα et les fragments de fission (FF) et une bonne résolution temporelle. Une bonne séparationα-FF a également été obtenue avec une cible d’233 U très radioactive. De plus, l’analyse deforme de signaux entre les rayons γ et les neutrons dans les détecteurs C6 D6 a été observée àGelina dans des conditions expérimentales réalistes. Pour conclure, le dispositif expérimentalet la méthode de VETO ont été soigneusement vérifiés et validés, ouvrant la voie à la mesure future des sections efficaces de capture et fission d’233 U . / 233U is the fissile nucleus produced in 232T h/233U fuel cycle which has been proposed as asafer and cleaner alternative to the 238U/239P u cycle. The accurate knowledge of the neutroncapture cross-section of this isotope is needed with high-precision for design and developmentof this fuel cycle. The only two reliable experimental data for the capture cross-section of233U show discrepancies up to 10%. These differences may be due to systematic uncertaintiesassociated with the detector efficiency, dead-time effects, background subtraction and signalpile-up caused by the α-activity of the sample. A special experimental set-up for simultaneousmeasurement of fission and capture cross sections of radioactive fissile nuclei was designed,assembled and optimized at CENBG in the frame of this work. The measurement will be per-formed at the Gelina neutron time-of-flight facility at IRMM, where neutron cross sectionscan be measured over a wide energy range with high energy resolution. The fission detectorconsists of a multi-plate high-efficiency ionization chamber (IC). The γ-rays produced in cap-ture reactions are detected by an array of six C6 D6 scintillators surrounding the IC. In thesemeasurements the radiative capture γ-rays are hidden in large background of fission γ-rays thatrepresents a challenging issue. The latter has then to be subtracted by detecting fission eventswith a very well known efficiency (VETO method). An accurate determination of this efficiencyis rather difficult. In this work we have thoroughly investigated the prompt-fission-neutronsmethod for the IC efficiency measurement, providing new insights on this method. Thanks tothis study the IC efficiency was determined with a very low uncertainty. Using a 252Cf source,several parameters (gas pressure, high voltage and the distance between the electrodes) havebeen studied to determine the behaviour of the IC in order to find the ideal operation point:a good energy separation between α-particles and fission fragments (FF) and a good timingresolution. A good α-FF separation has been obtained with a highly radioactive 233U target.Also, the pulse-shape discrimination between γ-rays and neutrons in the C6D6 detectors wasobserved at Gelina under realistic experimental conditions. To conclude, the experimentalset-up and the VETO method have been carefully checked and validated, opening the way tofuture measurements of the capture and fission cross sections of 233U.

233U is the fissile nucleus produced in 232T h/233U fuel cycle which has been proposed as asafer and cleaner alternative to the 238U/239P u cycle. The accurate knowledge of the neutroncapture cross-section of this isotope is needed with high-precision for design and developmentof this fuel cycle. The only two reliable experimental data for the capture cross-section of233U show discrepancies up to 10%. These differences may be due to systematic uncertaintiesassociated with the detector efficiency, dead-time effects, background subtraction and signalpile-up caused by the α-activity of the sample. A special experimental set-up for simultaneousmeasurement of fission and capture cross sections of radioactive fissile nuclei was designed,assembled and optimized at CENBG in the frame of this work. The measurement will be per-formed at the Gelina neutron time-of-flight facility at IRMM, where neutron cross sectionscan be measured over a wide energy range with high energy resolution. The fission detectorconsists of a multi-plate high-efficiency ionization chamber (IC). The γ-rays produced in cap-ture reactions are detected by an array of six C6 D6 scintillators surrounding the IC. In thesemeasurements the radiative capture γ-rays are hidden in large background of fission γ-rays thatrepresents a challenging issue. The latter has then to be subtracted by detecting fission eventswith a very well known efficiency (VETO method). An accurate determination of this efficiencyis rather difficult. In this work we have thoroughly investigated the prompt-fission-neutronsmethod for the IC efficiency measurement, providing new insights on this method. Thanks tothis study the IC efficiency was determined with a very low uncertainty. Using a 252Cf source,several parameters (gas pressure, high voltage and the distance between the electrodes) havebeen studied to determine the behaviour of the IC in order to find the ideal operation point:a good energy separation between α-particles and fission fragments (FF) and a good timingresolution. A good α-FF separation has been obtained with a highly radioactive 233U target.Also, the pulse-shape discrimination between γ-rays and neutrons in the C6D6 detectors wasobserved at Gelina under realistic experimental conditions. To conclude, the experimentalset-up and the VETO method have been carefully checked and validated, opening the way tofuture measurements of the capture and fission cross sections of 233U.

Submitted by Marco Antonio Oliveira da Silva (maosilva@ipen.br) on 2016-12-21T15:11:54Z No. of bitstreams: 0 / Made available in DSpace on 2016-12-21T15:11:54Z (GMT). No. of bitstreams: 0 / A Terapia por Captura de Nêutrons, NCT (Neutron Capture Therapy) é uma técnica radioterápica em que a energia útil do tratamento vem da energia liberada em uma reação nuclear e não do feixe primário, como comumente utilizado em outros procedimentos radioterápicos. O Boro, por constituir-se em um elemento de baixa toxicidade e por apresentar um isótopo (10B) com alta seção de choque para a reação 10B(n,α)7Li tem sido o elemento mais utilizado nas pesquisas que visam o aprimoramento e a promoção desta técnica, derivando daí o termo BNCT (Boron Neutron Capture Therapy). Para fins de pesquisa em BNCT foi construída ao longo de um dos extratores de feixes (BH - Beam Hole) do reator IEA-R1 uma instalação, onde filtros e moderadores são posicionados entre o núcleo do reator e a posição de irradiação com o objetivo de modular o feixe de irradiação, otimizando a componente útil do feixe, os nêutrons térmicos, e reduzindo os contaminantes, raios gama e nêutrons em outras faixas energéticas. Tem-se realizado estudos visando a implementação de melhorias na caracterização e otimização do feixe obtido nesse arranjo instalado no BH-3. Atualmente a monitoração dos nêutrons é feita através de folhas de ativação, e a componente gama pelo TLD-400. Uma nova metodologia de monitoração tem sido estudada pelo grupo. A referida técnica consiste em usar TLDs de tipos diferentes, ou seja, que possuam sensibilidades distintas aos nêutrons térmicos, em virtude de diferenças na concentração dos isótopos de Lítio. No estudo dessa nova metodologia têm sido usados os TLD-600 e TLD-700. Este trabalho propõe uma metodologia usando o par TLD-100 e TLD-700. Inicialmente foi verificada a reprodutibilidade das respostas dos TLDs 700, 400 e 100 frente a campos gama puro e campos mistos, gama e nêutron. Campos estes obtidos em arranjos usando fontes de 60Co e 241AmBe. A partir de simulações usando o VI MCNP5 foi projetado e construído um Irradiador de campos mistos, que permitiu expor os dosímetros em campos mistos com diferentes espectros energéticos. As condições criadas no irradiador permitiram verificar, como a resposta do TLD é modificada pelas mudanças no espectro energético de um campo misto gama e nêutrons de baixo fluxo. O irradiador de campo misto permitiu condições para estabelecer uma relação entre o formato da curva termoluminescente e a composição do campo misto. A relação estabelecida relaciona o fluxo relativo e a razão entre a resposta das duas regiões de interesse dos TLDs 700 e 100. A partir de campos mistos com condições controladas, esse trabalho permitiu verificar a viabilidade do uso do par de TLD-100 e TLD-700 para monitoração de nêutrons térmicos na instalação de BNCT. / Dissertação (Mestrado em Tecnologia Nuclear) / IPEN/D / Instituto de Pesquisas Energéticas e Nucleares - IPEN-CNEN/SP