Lateral bracing systems consisting of cross frames and their connections play a significant role in the elastic buckling strength of steel girder bridges. By providing lateral and torsional stability, they prevent lateral torsional buckling of the girder during bridge construction prior to the concrete bridge deck curing. To perform this function, the bracing system must possess adequate strength and stiffness. And since each component of the bracing system acts in series, the overall stiffness of the system is less than the least stiff component. In skewed bridges, cross frames at the ends of the girders are installed parallel to the bridge skew angle, and their connection to the girder requires that the cross frames be at an angle that prohibits welding a stiffener from the cross frame directly to the girder web. To make this connection, many states use a bent plate to span the angle between the web stiffener and cross frame. While this bent plate connection is now being widely used, it has never been rationally designed to account for its strength or stiffness in the bracing system. Results from field studies show that the bent plate connection may be limiting the cross frame stiffness thereby hampering its ability to provide stability to the girder during construction. The result is significant girder end rotations. The purpose of this research is to classify the impact of the bent plate connection on the end cross frame stiffness in skewed straight steel girder bridges and propose methods to improve the end cross frame’s structural efficiency. This research uses laboratory testing, finite element modeling, and parametric studies to recommend design guidance and construction practices related to the end cross frames of skewed steel girder bridges. In addition to recommending methods to stiffen the existing bent plate connection, an alternative pipe stiffener connection is evaluated. The pipe stiffener not only offers the possibility of a stiffer connection, but can also provide warping restraint to the end of the girder which may significantly increase the girder elastic buckling capacity. / text

An experimental and analytical study was conducted on a BT-63 prestressed concrete girder to investigate the thermal effects on the girder. A 2D finite element heat transfer analysis model was then developed which accounted for heat conduction, convection, radiation, and irradiation. The solar radiation was predicted using the location and geometry of the girder, variations in the solar position, and the shadow from the top flange on other girder surfaces. The girder temperatures obtained from the 2D heat transfer analysis matched well with the measurements. Using the temperatures from the 2D heat transfer analysis, a 3D solid finite element analysis was performed assuming the temperatures constant along the length of the girder. The maximum vertical displacement due to measured environmental conditions was found to be 0.29 inches and the maximum lateral displacement was found to be 0.57 inches. Using the proposed numerical approach, extremes in thermal effects including seasonal variations and bridge orientations were investigated around the United States to propose vertical and transverse thermal gradients which could then be used in the design of I-shaped prestressed concrete bridge girders. A simple beam model was developed to calculate the vertical and lateral thermal deformations which were shown to be within 6% of the 3D finite element analyses results. Finally, equations were developed to predict the maximum thermal vertical and lateral displacements for four AASHTO-PCI standard girders. To analyze the combined effects of thermal response, initial sweep, and bearing support slope on a 100-foot long BT-63 prestressed concrete girder, a 3D finite element sequential analysis procedure was developed which accounted for the changes in the geometry and stress state of the girder in each construction stage. The final construction stage then exposed the girder to thermal effects and performed a geometric nonlinear analysis which also considered the nonlinear behavior of the elastomeric bearing pads. This solution detected an instability under the following conditions: support slope of 5¡Æ and initial sweep of 4.5 inches.