Transparent glasses embedded with TTB structured ferroelectric nano/micro crystals (K3Li2Nb5O15, Ba5Li2Ti2Nb8O30) were fabricated in various tellurite and borate based glass matrices and characterized for their physical properties. Nanocrystals of K3Li2Nb5O15 were successfully grown inside tellurite glass matrix via conventional heat-treatment route. Eventhough, tellurite glasses preferentially crystallize only on the surface, bulk uniform crystallization was achieved in the (100-x) TeO2 - x(1.5K2O-Li2O-2.5Nb2O5) system. Heat capacity studies revealed them to be thermodynamically less fragile than any other tellurite glasses ever reported in the literature. Pyroelectric and ferroelectric effects as well as second harmonic generation were demonstrated for the heat treated (glass nanocrystal composites) samples in this system. The conventional method of melt-quenching of constituent oxides could not yield Ba5Li2Ti2Nb8O30 crystallites. So, Ba5Li2Ti2Nb8O30 microcrystals were successfully formed in tellurite glass matrix by mixing pre-reacted Ba5Li2Ti2Nb8O30 ceramic powders with TeO2. The glass transition temperature was found to be the highest ever reported and this system was kinetically strong based on the fragility parameter. Dielectric studies revealed a frequency and temperature independent nature of the dielectric constant and very low dielectric loss. The SHG measurement which was carried out as a function of temperature demonstrated the incidence of blue second harmonic generation in the microcrystals present in the glass matrix. Ba5Li2Ti2Nb8O30 nanocrystals were successfully crystallized in the transparent glass system (100-x)Li2B4O7 – x(Ba5Li2Ti2Nb8O30). Dielectric constant increased while the dielectric loss decreased with the increase in Ba5Li2Ti2Nb8O30 content. Nuclear magnetic resonance spectroscopic studies were carried out to have an insight into the structure of this system. Transmission studies and refractive index measurements were performed and various optical parameters were calculated. Dielectric and transport properties were studied for the glasses and glass nano/microcrystal composites of all the systems reported in this thesis. Li+ ion was found to be responsible for conduction in all these systems. Evolution of self-organized nanopatterns of K3Li2Nb5O15 crystals has been demonstrated in the glass system (100-x) TeO2 - x(1.5K2O-Li2O-2.5Nb2O5) by excimer laser irradiation. The second harmonic signal observed by the Maker fringe technique has been attributed to the presence of well-aligned nano-sized grating structures in the glass system. Glasses belonging to the systems TeO2-K3Li2Nb5O15, TeO2-Ba5Li2Ti2Nb8O30 and V2Te2O9 undergo spinodal decomposition on exposing to KrF pulsed excimer laser. The spinodally phase separated structures were observed on all the surfaces of the samples. Ring shaped patterns were observed on several locations of the samples at higher frequency of laser pulses probably owing to the shock waves produced by the high intense laser beam. Line shaped patterns were found to originate on the sample surfaces when irradiated for longer periods.

The ability to tune the properties over a wide range of values by changing the additives, composition, etc., has made chalcogenide glassy semiconductors, most interesting from both fundamental physics as well as technology point of view. In particular, the occurrence of the two network topological thresholds namely the Rigidity Percolation Threshold (RPT) and the Chemical Threshold (CT) and their influence on various properties of chalcogenide glasses have been of immense interest during the last three decades. The Rigidity Percolation Threshold (also known as the Stiffness Threshold or Mechanical Threshold) corresponds to the composition at which the material transforms from a floppy polymeric glass to a rigid amorphous solid, whereas at Chemical Threshold the sample tends towards an ordered state. Though the rigidity percolation has been considered for long to occur at a critical threshold defined by the constraint’s theory, the recent theoretical and experimental investigations have found the RPT to occur over a range of compositions. In systems exhibiting an extended rigidity percolation, two distinct transitions namely from a floppy to an isostatically rigid phase and from an isostatically rigid to a stressed rigid phase are seen. In the category of chalcogenide glasses, tellurides have been found to exhibit interesting properties including the phenomenon of electrical switching which finds applications in Phase Change Memories (PCM). Studies on various thermal, electrical and photoelectrical properties of glassy tellurides help us in identifying suitable materials for different technological applications. This thesis deals with Differential Scanning Calorimetric (DSC) & Temperature Modulated Alternating Differential Scanning Calorimetric (ADSC) studies, electrical switching investigations, photoconductivity & photothermal measurements on certain metal doped telluride glasses. The composition dependence of properties such as glass transition & crystallization temperatures, switching voltage, thermal diffusivity, photosensitivity, etc., have been analyzed to obtain information about topological thresholds, thermally reversing window, etc. The first chapter of thesis provides an overview of properties of amorphous semiconductors, in particular chalcogenide glasses. The local & defect structure, the electronic band structure & electrical properties, electrical switching behavior, etc., are discussed in detail. The theoretical aspects related to the experiments undertaken in this thesis work have also been described. The instrumentation used for various experiments conducted to measure thermal, electrical, photoelectrical and photothermal properties have been discussed in chapter two. The chapter three deals with the photocurrent measurements on As40Te60-xInx (7.5 ≤ x ≤ 16.5) glasses. In these samples, it has been found that the photocurrent increases with illumination, which is understood on the basis of the large dielectric constant and also due to the presence of a large number of positively charged defect states. Further, the composition dependence of the conductivity activation energy and the photosensitivity exhibit a maximum at x = 12.5 (<r> = 2.65) and a minimum at x = 15.0 (<r> = 2.70) which has been identified to be the Rigidity Percolation Threshold (RPT) and the Chemical Threshold (CT) respectively. The results of electrical switching, DSC and Photothermal Deflection (PTD) studies on As20Te80-xGax (7.5 ≤ x ≤ 18.5) glasses, undertaken to elucidate the network topological thresholds, are described in chapter four. It has been found that all the As20Te80-xGax glasses studied exhibit memory type electrical switching. The switching voltage (VT) of these glasses increases monotonically with x, in the composition range 7.5 ≤ x ≤ 15.0. The increase in VT with gallium addition leads to a local maximum at x = 15.0 and VT decreases with x thereafter, reaching a distinct minimum at x = 17.5. Based on the variation with composition of the electrical switching voltages, the composition x = 15.0 and x = 17.5 have been identified to be the rigidity percolation and chemical thresholds of the As20Te80-xGax glassy system respectively. Further, the DSC studies indicate that As20Te80-xGax glasses exhibit a single glass transition (Tg) and two crystallization reactions (Tc1 & Tc2) upon heating. There is no appreciable change in Tg of As20Te80-xGax glasses with the addition of upto about10 atom% of Ga, whereas a continuous increase is seen in the crystallization temperature (Tc1). It is interesting to note that both Tg and Tc1 exhibit a maximum at x = 15.0 and a minimum at x = 17.5, the compositions identified to be the RPT and CT respectively by the switching experiments. The composition dependence of thermal diffusivity estimated from the PTD signal, indicate the occurrence of an extended stiffness transition in As20Te80-xGax glasses, with the compositions x = 9.0 and x = 15.0 being the onset and the completion of an extended rigidity percolation. A maximum and a minimum are seen in the thermal diffusivity respectively at these compositions. Further, a second maximum is seen in the thermal diffusivity of As20Te80-xGax glasses, the Chemical Threshold (CT) of the glassy system. The fifth chapter of the thesis describes the ADSC, electrical switching and photocurrent measurements on Ge15Te85-xInx (1 ≤ x ≤ 11) glasses. It is found there is not much change in the Tg of Ge15Te85-xInx glasses in the composition range 1 ≤ x ≤ 3. An increase is seen in Tg beyond x = 3, which continues until x = 11. Further, the composition dependence of non-reversing enthalpy shows the presence of a thermally reversing window in the compositions range x = 3 and x = 7. Electrical switching studies indicate that Ge15Te85-xInx glasses exhibit threshold type of switching at input currents below 2 mA. It is observed that switching voltages decrease initially with indium addition, exhibiting a minimum at x = 3, the onset of the extended rigidity percolation as revealed by ADSC. An increase is seen in VT above x = 3, which proceeds till x = 8, with a change in slope (lower to higher) seen around 7 atom% of indium which corresponds to the completion of the stiffness transition. The reversal in trend exhibited in the variation of VT at x = 8, leads to a well defined minimum around x = 9, the chemical threshold of the Ge15Te85-xInx glassy system. Photocurrent measurements indicate that there is no photodegradation in Ge15Te85-xInx glasses with x < 3, whereas samples with x ≥ 3 show photodegradation behavior. The composition dependent variation in the glass transition temperature has been attributed for this behavior. Further, the composition dependence of photo sensitivity has been found to show the signatures of the extended rigidity percolation and the chemical threshold in Ge15Te85-xInx glasses. The last chapter of thesis (chapter six) summarizes the results obtained and also the scope of future work to be undertaken.