In geotechnical engineering, granular flows are often studied as a means to further the understanding of the mechanisms that drive landslide motion. High quality experimental data is essential in providing evidence for the development and verification of new theoretical methods that link complex grain interactions to the extended mobility of some landslide events. At present, limited experimental data is available that captures the full range of landslide mobility. In an attempt to add to the present data sources, high quality experimental data was obtained through the use of high speed cameras and physical modelling using a geotechnical centrifuge and a large scale landslide flume. These modelling techniques allow for landslide motion, representative of field scale events, to be observed in a well-defined and controlled setting. A series of nine tests were performed in a geotechnical centrifuge under varying slope inclinations and Coriolis conditions. The effects of Coriolis on landslide mobility were evident when comparing final deposit shapes and total runout. The effects of Coriolis were more pronounced for higher velocity situations and when material was travelling on the horizontal base section opposed to the sloped section of the physical model. A series of thirty tests were performed using a large scale flume under varying source volumes and basal friction conditions, capturing the grain scale interactions and overall runout behaviour. The grain interactions and ultimately the flow behavioural regimes developed were a function of material source volume and boundary roughness. The dimensionless inertial number was used to classify flows into behavioural regimes, but was found to break down when describing transitions to the granular gas behavioural regime. The runout-time results and final deposit shapes showed significant variation between test configurations, indicating the effects of volume and basal friction on overall mobility. Using the depth averaged numerical model, DAN, it was found that a single set of empirically derived frictional parameters (i.e. specific to internal and basal friction conditions) was appropriate for matching the overall mobility of the experimental flows over a range of flow volumes and slope inclinations. / Thesis (Master, Civil Engineering) -- Queen's University, 2013-09-25 15:48:54.761

Tsunamis are gravity water waves that are generated by impulsive disturbances such as submarine earthquakes, landslides, volcanic eruptions, underwater explosions or asteroid impacts. Submarine earthquakes are the primary tsunami source, but landslides may generate tsunamis exceeding tectonic tsunamis locally, in both wave and runup heights. The field data on landslide tsunami events are limited, in particular regarding submarine landslide dynamics and wave generation. Tsunamis generated by three-dimensional deformable granular landslides are physically modeled in the NEES (Network of Earthquake Engineering Simulation) 3D tsunami wave basin (TWB) at Oregon State University in Corvallis, Oregon. A novel pneumatic landslide tsunami generator is deployed to simulate natural landslide motion on a hill slope. The instrumentation consists of various underwater, above water and particle image velocimetry (PIV) cameras, numerous wave and runup gauges and a multi-transducer acoustic array (MTA). The subaerial landslide shape and kinematics on the hill slope and the surface elevation of the offshore propagating tsunami wave and runup on the hill slope are measured. The evolution of the landslide front velocity, maximum landslide thickness and width are obtained along the hill slope. The landslide surface velocity distribution is obtained from the PIV analysis of the subaerial landslide motion. The shape and the size of the submarine landslide deposit are measured with the MTA. Predictive equations are obtained for the tsunami wave amplitude, wave period and wavelength in terms of the non-dimensional landslide parameters. The generated 3D tsunami waves propagate away from the landslide source as radial wave fronts. The amplitudes of the leading tsunami waves decay away from the landslide source in radial and angular direction. The wave celerity of the leading tsunami wave may be approximated by the solitary wave speed while the trailing waves are slower due to the dispersion effects. The energy conversion rate between the landslide and the generated wave is estimated. The observed waves are weakly non-linear in nature and span from shallow water to deep water depth regime. The unique experimental data serves the validation and advancement of numerical models of tsunamis generated by landslides. The obtained predictive equations facilitate initial rapid tsunami hazard assessment and mitigation.