Estimating local site effects and modifying the uncertainty in ground motion predictions are two indispensable parts of partially non-ergodic site-specific PSHA. Local site effects can be estimated using site response simulations or recorded ground motions at the site. When such predictions are available, the aleatory variability of ground motions used in PSHA can be changed to the single station sigma value. However, in these cases, the epistemic uncertainty in predicting site effects must be incorporated into the hazard analyses. This research focuses on the challenges specific to conducting partially non-ergodic site-specific PSHA using recorded ground motions or site response analysis. The main challenge in estimating local site effects using recorded data is whether ground motions collected in a relatively short time can be used to estimate site effects for long return period events. We first develop a database for recorded ground motions at the KiK-net array to investigate this question and use this database to develop a predictive model for the Fourier Amplitude Spectra of ground motions. The ground motion model (GMM) residuals are used to investigate the stability of site terms across different tectonic regimes. We observe that empirical site terms are stable across different tectonic regimes. This observation allows the use of ground motions from any tectonic regime (whether they belong to the tectonic regime that controls the hazard or not) to estimate local site effects. Moreover, in Fourier amplitude, site effects are not dependent on event magnitude and source to site distance; therefore, estimates of site effects from low magnitude events can be easily extrapolated to larger events. The Fourier amplitude GMM developed in this study adds to the library of Fourier amplitude models to be used in future partially non-ergodic site-specific PSHAs. In practice, one of the most common tools for simulating wave propagation is 1-D site response analysis. Two central assumptions in 1-D site response analysis are that the soil profile is comprised of horizontal soil layers of infinite extent and that the vertically propagating SH-waves control the horizontal component of ground motion. SH-waves tend to propagate vertically near the surface because as earthquake waves hit softer layers traveling from the source to the site, they refract until the path becomes steeply inclined. The validity of both assumptions in 1-D site response depends on the geological setting at the site and the geology between the earthquake source and the site, raising the question of which sites are suitable for 1-D site response analysis and what the model error in 1-D site response analysis is. We use the GMM developed for FAS to estimate observed and empirical site terms. The empirical site effects are then compared with the theoretical site effects to determine whether sites are amenable to 1-D site response analyses, and to quantify the model error in the analyses. / Doctor of Philosophy / It is impossible to predict future earthquake-induced ground motions due to randomness in the process and a lack of knowledge. In fact, there are significant uncertainties not only in predicting the location, time, and magnitude of a future earthquake but also in predicting the intensity of ground motion induced by a given future earthquake. Therefore, assessing the safety of the human environment against earthquake hazards requires a method that considers all sources of uncertainties. To this end, Earthquake Engineers have developed Probabilistic Seismic Hazard Analysis(PSHA) framework. Structural engineers use the results of PSHA to design a new structure or assess the safety of an existing building. The accuracy of PSHA estimations leads to designs that are both safe and cost-efficient. The distribution of possible ground motions induced by a given earthquake scenario significantly controls the result of PSHA. This distribution should consider the effect of source, source to site path, and local site effects. This research focuses on improving PSHA results by estimating local site effects using recorded ground motions or simulating wave propagation in the site. In estimating local site effects using recorded data, the local site effect observed in ground motions collected in a relatively short time window is used to estimate hazards from all scenarios. However, the collected ground motions usually belong to frequent low magnitude events that are different from large magnitude events that control the hazard. This difference requires either using a measure of local site effect that is independent of the magnitude and distance of the earthquake or considering the effect of magnitude and distance on the local site effect estimate. Moreover, since frequent events sample different sources and paths than large events, we need to make sure the local site effect is consistent across different sources and paths. This research develops Ground Motion Models(GMMs) for Fourier amplitude, a linear function of ground motion times series, using Japanese ground motions. The ratio of Fourier amplitude at the surface over bedrock is a measure of local site effect that is not dependant on magnitude and distance. The model is then used to see if the trade-off between source and site effect and path and site effect is significant or not. In practice, one of the most common tools for simulating wave propagation is 1-D site response analysis. Two central assumptions in 1-D site response analysis are that the soil profile comprises horizontal soil layers of infinite extent and that the vertically propagating horizontal shear waves (SH-waves) control the horizontal component of ground motion. SH-waves tend to propagate vertically near the surface because as earthquake waves hit softer layers traveling from the source to the site, they refract until the path becomes vertically inclined. The validity of both assumptions in 1-D site response depends on the geological setting at the site and the geology between the earthquake source and the site, raising the question of which sites are suitable for 1-D site response analysis and what the model error in 1-D site response analysis is. We use the GMM developed for FAS to estimate empirical local site effects. The empirical site effects are then compared with the theoretical site effects to determine whether sites are amenable to 1-D site response analyses and quantify the model error in the analyses.

Nedávné studie předpovídají nárůst pasažérů využívajících leteckou dopravu. Tento trend bude vyžadovat zavedení nových leteckých linek, důsledkem čeho bude zhuštěn letový provoz s dopadem hlavně na nápor letišť v metropolitních oblastech. Automatizovaně řízení pojíždení letounu umožní menší rozestupy mezi jednotlivými linkami a zvýšení příletové a odletové kapacity letišť. Tato práce se zabývá návrhem modelu pohybu dopravního letounu po zemi s ohledem na různé provozní podmínky jako např.: stav povrchu vzletové a přistávací dráhy za různého počasí a lišící se provozní parametry letounu (tlak v pneumatikách, zatížení podvozků a pod.). Validace modelu byla založena na sledování poloměru zatáčky pro různe uhly natočení přední podvozkové nohy. Výsledky simulace byly validovany vzhledem k analytickému modelu Ackermanovy geometrie a na specifikační dokument od Boeingu určený pro plánovaní pohybu letounu na letišti. Výsledky prokázaly přesnost modelu a potvrdily jeho možné nasazení pro simulace v reálnem čase.