The main objective of this thesis is to develop a new methodology to evaluate the transmission cable losses of wind-generated electricity. The research included the power loss variations of submarine cables in relation to the line length, cable capacity and the transmission technology in an offshore wind farm having a capacity of 500 MW. The literature of similar studies helped to generate a solid background for the research.   The comprehensive analysis carried out is based on a hypothetical wind farm and using three different power transmission wind farm models to investigate the technical reliability of transmission technology, namely, High Voltage Alternative Current (HVAC), High Voltage Direct Current Voltage Source Converter (HVDC VSC) and High Voltage Direct Current Line Commutated Converter (HVDC LCC). The analyses carried out are performed under assumptions and simplifications of power system models to evaluate the submarine cable transmission losses of 3 different transmission systems by using the MATLAB/ Simulink software.   With relevance to the simulation results, the HVAC submarine cable has more losses than any other transmission technology cables and it is suitable for short distance power transmission. The VSC technology has less losses than HVAC. Comparing with afore-mention technologies the HVDC LCC technology transmission links have the lowest line losses. Moreover, the transformer losses and the converter losses were calculated. The simulation results also included the overall power system losses by each of the transmission models.

The main circuit equipment in an HVDC station must be rated for continuous operation as well as for stresses during ground faults and other short circuits. The component impedances are thus selected for proper operation during both continuous operation and short circuit events. Normally, Electromagnetic Transient (EMT) simulations are performed for the short circuit current ratings, which can leadto time consuming iterations for the optimization of impedance values. Hence, sufficiently correct and handy formulas are useful. For that reason, in this research work, firstly, a thorough literature study is done to gain a deep understanding of the modular multilevel converter (MMC) and its behaviour after aDC pole-to-pole short circuit fault. Two associated simulation models are designed in PSCAD/EMTDC simulation software. The focus of this thesis is on DC pole-topoleshort circuit in Symmetric Monopole HVDC VSC Modular Multilevel Converter (MMC). The desired analytical expression for the steady state fault current is determined byusing mesh analysis and also by applying KCL and it is verified by doing a set of simulations in PSCAD. A detailed sensitivity study has been done in the PSCAD simulation software to understand the influence of the AC converter reactor inductance and the DC smoothing reactor inductance on the steady state as well as peak fault current respectively. From the sensitivity study, the simulated values of peak factor have been obtained. By means of the ratio in between DC side inductance (L_DC) and AC side inductance (L_AC), and by performing a number of calculations, the desired expression for the peak factor is derived. As a result, the peak fault current can be calculated. The calculated value of the peak fault current from the derived formula is compared to the simulated value and validated. An over-estimation is considered for the rating of the equipment. Along with that, the analysis of the effect of impedances of equipment and systems are done and also verified, to better judge the accuracy of the result. In the result, it is found that, the error margin obtained from the derived analytical expression for the steady state value is within 2% of the PSCAD simulated value, which means the error can be safely ignored. Similarly, the value obtained from the derived formula for the peak fault current is within 4% over-estimation margin of the PSCAD simulated value, which is quite good in terms of cost estimation for the rating of the components.