The heat transfer characteristics through arrays of pin fins were studied for the further development of internal cooling methods for turbine airfoils. Low aspect ratio pin fin arrays were tested through a range of Reynolds numbers between 5000 and 30,000 to determine the effects of pin spacing as well as aspect ratio on pin and endwall heat transfer. Experiments were also conducted to determine the independent effects of pin spacing and aspect ratio on arrays with different flow incidence angles. The pin Nusselt numbers showed almost no dependence on pin spacing or flow incidence angle. Using an infrared thermogaphy technique, spatially-resolved Nusselt numbers were measured along the endwalls of each array. The endwall results showed that streamwise spacing had a larger effect than spanwise spacing on array-averaged Nusselt numbers. Endwall heat transfer patterns showed that arrays with flow incidence angles experienced less wake interaction between pins than arrays with perpendicular flow, which caused a slight decrease in heat transfer in arrays with flow incidence angles. The effect of flow incidence angle on array-average Nusselt number was greater at tighter pin spacings. Even though the pin Nusselt number was independent of pin spacing, the ratio of pin-to-endwall Nusselt number was dependent on flow conditions as well as pin spacing. The pin aspect ratio had little effect on the array-average Nusselt number for arrays with perpendicular flow; however, the effect of flow incidence angle on array-average Nusselt number increased as aspect ratio decreased. / Master of Science

The performance of many engineering devices from power electronics to gas turbines is limited by thermal management. Pin fins are commonly used to augment heat transfer by increasing surface area and increasing turbulence. The present research is focused on but not limited to internal cooling of turbine airfoils using pin fins. Although the pin fins are not limited to a single shape, circular cross-sections are most common. The present study examines heat transfer from a single row of circular pin fins with the row oriented perpendicular to the flow. The configurations studied have spanwise spacing to pin diameter ratios of two, four, and eight. Low aspect ratio pin fins were studied whereby the channel height to pin diameter was unity. The experiments are carried out for a Reynolds number range of 5000 to 30,000. Heat transfer measurements are taken on both the pin and on the endwall covering several pin diameters upstream and downstream of the pin row. The results show that the heat transfer augmentation relative to open channel flow is highest for the smallest spanwise spacing for the lowest Reynolds number flows. The results also indicate that the pin fin heat transfer is higher than on the endwall. / Master of Science