ABSTRACT Organic light emitting diode (OLED) has significant scientific implication and technological potential. Using organic materials for tailored emitting color, threshold voltage reduction, and emission efficiency gain are the key points for the commercialization of OLED. An UV-Vis spectrophotometer was applied to obtain the absorption spectra of PVK, C6, and PRL, as well as their respective band gap (Eg) values of 3.49 eV, 2.32 eV, and 2.55 eV. The turn-on oxidation potential of cyclic voltammograms was reduced for HOMO energy at 5.64 eV, 5.21 eV, and 5.16 eV, respectively. The Eg subtracted from HOMO energy yielded the respective LUMO values of 2.15 eV, 2.89 eV and 2.61 eV. Excitation at 457 nm or 325 nm was applied to the freestanding films of PVK, PVK doped with C6 (10/1), and PVK doped with PRL (10/1). From the UV-Vis absorption spectra and Egs, we knew that 457 nm excitation did not generate photoluminescence (PL) of PVK. The PL spectra of the doped freestanding films were mostly attributed to the dye molecules of C6 or PRL. The PL spectra of doped freestanding films were insensitive to the excitation sources at 325 nm and 457 nm. There was a blue shift at the PL emission peak indicative of energy transfer from PVK to C6 or PRL for the doped films. Using spin-coating or vacuum deposition to fabricate PVK, C6, and PRL films onto an ITO substrate followed by evaporating Al (Ag) as the electron injector to form OLED devices. Because of the energy transfer between PVK and C6 or PRL, ITO/PVK:C6/Al homojunction OLED showed a smaller threshold voltage than that of ITO/C6/Al, from 9 V to 3.5 V. Likewise, ITO/PVK:PRL/Al homojunction OLED had a smaller threshold voltage than that of ITO/PRL/Al, from 8 V to 4.5 V. PVK was also used as the hole blocking layer to construct heterojunction OLED to balance electron-hole numbers in the emitting layer. The threshold voltage of ITO/C6/Al reduced from 9 V to 7 V with a heterojunction of ITO/PVK/C6/Al. A device of ITO/PRL/Al having a threshold voltage of 8V reduced to 6V with an ITO/PVK/PRL/Al heterojunction OLED. Coating a protective layer (Ag) on the metallic electron injector, or packaging the device in N2 could both decrease the decay and increase the life time of OLED.