The Consumer's Guide is designed to help consumers by providing guidelines for the purchase of specific energy-efficient household appliances- water heaters, air conditioning and heating systems, windows, dishwashers, refrigerators, clothes washers, and dryers. This serves two major purposes: to decrease the environmental impact of those products and to save consumers money over the lifetime of the products. The seven major appliances covered in this work are things that consumers tend to purchase quickly when their older models wear out and with little research into their energy and/or water efficiency. The guide begins with a general introduction and an explanation of the need for energy conservation. Explanations of how they work, purchasing tips, installation tips, maintenance tips, tips for additional energy efficiency, and case studies are given for each appliance. Printable pamphlets are included at the end.

A dissertation submitted to the Faculty of Engineering and the Built Environment, University of the Witwatersrand, Johannesburg, in ful lment of the requirements for the degree of Master of Science in Engineering. Johannesburg, 2015 / The work presented extends and contributes to research in Non-Intrusive Load Monitoring (NILM), focussing on steady-state and transient power measurement disaggregation techniques for circuits containing household ap- pliances. Although previous work in this area has produced and evaluated a wide range of NILM approaches, much of it has involved the use of datasets captured from real-world household implementations. In such cases, the lack of accurate ground truth data makes it di cult to assess disaggregation tech- niques. In the research presented, three NILM techniques are comparatively evaluated using measurements from typical household appliances assembled within a laboratory environment, where accurate ground truth data could be compiled to complement the measurements. This allows for the accu- racy of the various disaggregation approaches to be precisely evaluated. It is demonstrated that the correlation of transient event edges in aggregated power measurements to individual appliance transient exemplars performs better than the matching of steady-state power levels against individual ap- pliance state combinations. Furthermore, the transient approach is shown to be the most appropriate technique for further development. / MT2017