Hydrogen has been shown to be a promising replacement for fossil fuels for use in light duty vehicles because it is a clean, renewable and plentiful resource with a high gravimetric energy density. However, in order to obtain an acceptable volumetric energy density, densification of the hydrogen is required. Adsorptive materials have been shown in the literature to increase volumetric and gravimetric storage densities. A major issue with adsorptive storage is that the adsorption process generates heat and optimal storage conditions are at temperatures below 100 K at pressures up to 50 atm. There is a need to develop heat exchanging architecture that enables adsorbents to be a viable method for hydrogen storage by managing the thermal environment of the storage tank. Based on previous modeling efforts to determine an acceptable bed module height for removal of heat via microchannel cooling plates, a thermal management system has been designed and tested capable of removing the heat of adsorption within adsorbent-filled hydrogen storage tanks. The system uses liquid nitrogen cooling to maintain tank temperatures of below 80 K at 50 atm. System studies show that the microchannel architecture offers a high cooling capacity with about a 6% displacement volume. Simulations and experiments have been conducted to evaluate the design for the cooling capacity, pressure drop, and flow distribution between and across the cooling plates, stress due to the pressurized environment, and thermal stress. Cost models have been developed to demonstrate that the system can be manufactured for a reasonable cost at high production volumes. Experimental results show that the modular system offers an acceptable cooling capacity and pressure drop with good flow distribution while adequately managing thermal stresses during operation. / Graduation date: 2013

The need for clean and renewable fuel such as hydrogen is driven by a growing worldwide population and increasing air pollution from fossil fuels. One of the major barriers for the use of hydrogen in automotive industry is the storage of hydrogen. Physisorption is the most promising storage technique due to its high storage density, reversibility and rapid sorption kinetics besides being safe and volume-efficient. A major challenge for physisorption is the need to manage the heat of adsorption at cryogenic temperatures. In this thesis, a 6061 aluminum microchannel cooling plate is designed to remove the equivalent heat flux required by the adsorption of hydrogen within an adsorption bed. Therefore, the objective of this thesis is to determine whether laser welding and heat treating strategies can be developed for a 6061 aluminum microchannel cooling plate as part of a larger hydrogen storage thermal management system. Key manufacturing process requirements include controlling the hermeticity, strength and dimensional stability of the heat-treated weld joint. A hermetic microchannel cooling plate was successfully laser welded and heat treated using free convection in air to quench the solution heat treatment. The weld strength and warpage obtained were within acceptable limits. Experimental testing of the fabricated microchannel cooling plate showed acceptable percent error with an experimental heat removal rate within 13.4% of computational fluid dynamics (CFD) analyses and an average pressure drop error of 25%. Calculations show that the cooling plate developed could support a hydrogen storage thermal management system taking up 5.0% and 10.3% of the system displacement volume and mass, respectively. / Graduation date: 2013