41 |
Path Matched Vibration Insensitive Fizeau InterferometerKimbrough, Bradley Trent January 2006 (has links)
An on-axis, vibration insensitive, polarization Fizeau interferometer is realized through the use of a novel pixelated mask spatial carrier phase shifting technique in conjunction with a low coherence source and a polarization path matching mechanism. In this arrangement, coherence is used to effectively separate out the orthogonally polarized test and reference beam components for interference. With both the test and the reference beams on-axis, the common path cancellation advantages of the Fizeau interferometer are maintained. Microwave modulation of a high powered red laser diode is used to create a 15 mW laser source having a coherence length of 250 um with minimal sidelobe ringing. With a 15 mW source, the maximum camera shutter speed, used when measuring a 4% reflector, was 150 usec, resulting in very robust vibration insensitivity. Additionally, stray light interference is substantially reduced due to the source's short coherence, allowing the measurement of thin transparent optics. Experimental results show the performance of this new interferometer to be within the specifications of commercial phase shifting interferometers.This work starts with a basic review of interferometry, phase shifting, and polarization as a lead in to a description of the theory and operation of the pixelated mask spatial carrier phase shifting technique. An analysis of the standard Fizeau Interferometer is then given. This is followed by detailed theoretical discussion of the path matched vibration insensitive (PMVI) Fizeau, which includes a theoretical model of the effects of multiple beam return from the test surface when measuring high value reflectors. The coherence properties of laser diodes are then discussed, a theoretical model for the effects of high frequency drive current is derived, and experimental results are given. Finally, the performance of the PMVI Fizeau is experimentally analyzed, potential error sources discussed, and suggestions for improvements provided.
|
42 |
Interferometric measurement of induced birefringence in polycrystalline ZnSe.Govender, Patricia. January 2011 (has links)
The aim of this research project was to assemble an apparatus capable of
measuring field-induced birefringence in polycrystalline ZnSe. A Michelson
interferometric apparatus was assembled, and care was taken to actively stabilize the interferometer against the effects of environmental noise by using electronic feedback techniques. This greatly enhanced the sensitivity of the interferometric measurements. In addition, the applied electric field was modulated, allowing sophisticated phase-sensitive detection techniques to be used to extract the induced birefringences.
Once assembled, the interferometer was tested using electric-field induced
birefringence in a perspex sample, since there is Kerr-effect data in the literature against which to compare our measured quadratic electro-optic coefficients. The interferometer was then used to measure the quadratic electrooptic coefficients of polycrystalline ZnSe, these being, to the best of our knowledge, the first such measurements for this species.
The theory of electro-optic and photoelastic phenomena is comprehensively
reviewed. This has permitted a critical discussion of the measured Kerr coefficients obtained in this project. It is demonstrated how quadratic electro-optic coefficients measured using the traditional technique of static polarimetry might include contributions arising from the linear electro-optic effect, these data being rendered suspect. In addition, suggestions are made as regards to the future possibilities for extending the apparatus to allow for direct measurement of stress-induced birefringences. / Thesis (M.Sc.)-University of KwaZulu-Natal, Pietermaritzburg, 2011.
|
43 |
Analysis and design of modified Wollaston prismsMontarou, Carole C. 12 1900 (has links)
No description available.
|
44 |
On the applicability of holographic interferometry to assess J-integral and C.O.D. fracture criteriaAchard, Louis-Marie. January 1982 (has links)
No description available.
|
45 |
Interferometric Synthetic Aperture Sonar Design and PerformanceBarclay, Philip John January 2006 (has links)
Synthetic aperture sonar (SAS) has become a well developed imaging technique for imaging shallow water environments. Aperture synthesis provides high along-track resolution imagery, with range independent resolution. However, mapping of the seafloor using traditional SAS is limited to a two-dimensional surface. To provide the third dimension (height), an interferometric synthetic aperture sonar (InSAS) is formed, comprising of two or more vertically displaced hydrophone arrays. Each of the interferometric receiver datasets are processed using standard SAS algorithms, with motion compensation and corrective processing applied equally to each channel, preserving the underlying interferometric time delays. By then estimating the time delay of the incoming wavefronts across the interferometric receiver array, the height of the seafloor can be inferred from the side-scan geometry of the system. The InSAS approach is similar to the radar equivalent (InSAR), however, significant differences in geometry and medium properties limit the applicability of InSAR algorithms to the sonar equivalent. A height estimate from interferometric data is formed by estimating the time difference between the receiver elements of the interferometric array. Therefore, for an accurate estimate of the time-delay, the signals of the receivers must contain significant 'common' information. Presented in this thesis is an analysis of coherence as applicable to an InSAS system. The coherence of an InSAS system can be decomposed into five 'coherence components': additive acoustic noise, footprint misalignment, baseline decorrelation, temporal decorrelation, and processing noise. Of these, it is shown footprint misalignment has the greatest effect for an InSAS system if it is not corrected for. The importance of maintaining high coherence between the receiver channels is presented; small losses in coherence from the ideal of unity will have a significant impact of the accuracy of the resulting height estimate. To reduce the sensitivity of the height accuracy losses, multiple estimates of the height can be formed from independent 'looks' of the scene. Combining all these estimates into one height estimate is shown to significantly improve the height estimate. The design and signal processing of an InSAS system is of high importance to the generation of high accuracy height estimates of the seafloor. Several parameters of design are explored, in particular the effect of aperture sampling. Low along-track aperture sampling rates are shown to cause a significant decrease in signal coherence, caused by the generating of 'grating lobes' from the synthetic aperture processing. Substantial improvements can be made by careful selection of transmitter and receiver element sizes, relaxing the requirements of a highly sampled aperture. An analysis of interpolation schemes on interferometric quality is also presented. The effect of footprint misalignment can be reduced by first resampling the data from each receiver onto a common ground-plane. However, this requires prior knowledge of the seafloor height, an unknown parameter before an interferometric height estimate is made. One possible method to form an initial height estimate is through the use of belief propagation, a technique applied from the field of stereo imaging. Belief propagation is used to estimate an initial height surface, albeit at discrete height intervals. This initial low resolution height surface can then be used to remap the data, partially eliminating the detrimental effects of footprint misalignment. The combination of all the independent estimates of the scene can be combined using maximum likelihood estimation. This framework allows the individual estimates to be combined into one overall cost function. Searching of the cost function for minimum cost yields a single interferometric time-delay estimate, from which a single height estimate can be inferred. This framework allows looks formed from many different sources to be combined, including multiple imaging frequency bands, and the use of more than one interferometric pair of receivers.
|
46 |
The Mauritius radio telescope and a study of selected super nova remnants associated with pulsarsDodson, R. G. January 1997 (has links)
The just completed Mauritius Radio Telescope, a 2km by 1km T shaped synthesis array designed to repeat the 6C survey but for the Southern hemisphere, is described. Full details of the instrument hardware, and the software designed to interpret the output of the hardware are presented. The early results from the instrument, in the shape of maps of known SNR with possibly associated pulsars, are shown. In combination with publicly available X-ray data and published maps at other frequencies, conclusions on the associations are drawn. The sources described are G5.4-2.3 with PSR 1757-23, G8.7-0.1 with PSR 1800-21, G315.4-2.3 with SN 185, G320.4-1.2 with PSR 1509-58 and G343.1-2.3 with PSR 1706-44.The MRT project is an example of hardware simplifications being made possible by the increasing power and sophistication of software and computation. The sheer speed with which calculations can be done nowadays has allowed corrections to be applied post facturn, where previously it would have to be fixed in hardware (at much greater cost).
|
47 |
A study of optical and opto-electronic techniques for nondestructive testingWang, Jianmin January 1992 (has links)
No description available.
|
48 |
Radio variability and interstellar scintillation of blazarsBignall, Hayley Emma January 2003 (has links)
This thesis presents several observational studies based on radio variability and interstellar scintillation of extragalactic flat-spectrum radio sources. Such sources are commonly called blazars, a term used to describe the phenomenon observed when the jet of a radio-loud Active Galactic Nucleus (AGN) is directed towards the observer. These sources provide unique laboratories for studying the physics of relativistic jets. Observations of selected samples of blazars, made with the Australia Telescope Compact Array (ATCA) and the Australia Telescope Long Baseline Array are presented here. Statistics for long-term (months--years) and short-term (intraday) variability in both total and linearly polarized flux density at several frequencies are presented. The sensitivity and flux density measurement accuracy of the ATCA make it particularly useful for observations of intraday variability (IDV). Resolving the question of what is the mechanism for radio IDV was of great importance at the time this thesis was being undertaken, since if intrinsic, IDV implies extremely high brightness temperatures, far in excess of the Inverse Compton limit for incoherent synchrotron radiation. Most source models are fundamentally based on the assumption that the radiation from radio to optical, and sometimes soft X-ray, energies is produced by the incoherent synchrotron mechanism, so any result which challenges this has serious implications. There is now strong evidence that interstellar scintillation (ISS) is the principal cause of radio IDV, which substantially lowers the implied source brightness temperatures from those calculated assuming intrinsic variability. Some of the results presented in this thesis have made an important contribution to the paradigm shift from IDV to ISS, by showing unequivocally that the rapid IDV observed in PKS 1257-326 is a result of scintillation due to a nearby scattering screen in the ionised interstellar medium (ISM) of our Galaxy. This unusual source, serendipitously discovered during the course of my PhD, has also proved extremely valuable in showing that ISS can be used as a probe of microarcsecond-scale source structure and also of the local Galactic ISM. Such high angular resolution is not currently achievable even with space interferometer baselines. / Thesis (Ph.D.)--Physics, 2003.
|
49 |
Low Coherence Interferometry in turbid media : the effect of multiply scattered light detection on image quality /Bizheva, Kostadinka. January 1900 (has links)
Thesis (Ph.D.)--Tufts University, 2001. / Adviser: David Alan Boas. Submitted to the Dept. of Physics. Includes bibliographical references (leaves 165-168). Access restricted to members of the Tufts University community. Also available via the World Wide Web;
|
50 |
A theoretical analysis of Bose-Einstein condensate based beamsplitters, interferometers, and transistorsStickney, James Arthur. January 2008 (has links)
Dissertation (Ph.D.)--Worcester Polytechnic Institute. / Keywords: atom interferometery; Bose-Einstein condensation. Includes bibliographical references (leaves 211-220).
|
Page generated in 0.0479 seconds