Study of turbulent flow over a rough bed is highly important due to its numerous applications in the areas of sediment transport and pollutant discharge in streams, rivers and channels. Over the past few decades, many experimental studies have been conducted in this respect to understand the underlying phenomenon. However, there is a scarcity in the number of computational studies conducted on this topic. Therefore, a Large Eddy Simulation (LES) of turbulent flow over a rough channel bed was conducted to contribute further understanding of the influence of bed roughness on turbulent flow properties. For this purpose, an efficient, second order accurate 'immersed boundary method' was implemented into the LES code Hydro3d-GT, and validated for flow past bluff bodies. LES results from the present study showed excellent agreement with previous experimental studies on flow over rough beds. An in-depth analysis of time varying turbulent quantities (like the velocity fluctuations) revealed the presence of coherent structures in the flow. Also, a three dimensional visualization of the turbulent structures provided a good picture of the flow, especially in the near bed region, which is quite difficult to accomplish using experimental studies.

Indiana University-Purdue University Indianapolis (IUPUI) / In recent years, magnesium alloys, due to their high strength and biocompatibility, have attracted significant interest in medical applications, such as cardiovascular stents, orthopedic implants, and devices. To overcome the high corrosion rate of magnesium alloys, coatings have been developed on the alloy surface. Most coating methods, such as anodic oxidation, polymer coating and chemical conversion coating, cannot produce satisfactory coating to be used in human body environment. Recent studies demonstrate that micro-arc oxidation (MAO) technique can produce hard, dense, wear-resistant and well-adherent oxide coatings for light metals such as aluminum, magnesium, and titanium. Though there are many previous studies, the understanding of processing conditions on coating performance remains elusive. Moreover, previous tests were done in simulated body fluid. No test has been done in a cell culture medium, which is much closer to human body environment than simulated body fluid. In this study, the effect of MAO processing time (1 minute, 5 minutes, 15 minutes, and 20 minutes) on the electrochemical behaviors of the coating in both conventional simulated body fluid and a cell culture medium has been investigated. Additionally a new electrolyte (12 g/L Na2SiO3, 4 g/L NaF and 4 ml/L C3H8O3) has been used in the MAO coating process. Electrochemical behaviors were measured by performing potentiodynamic polarization and electrochemical impedance spectroscopy tests. In addition to the tests in simulated body fluid, the MAO-coated and uncoated samples were immersed in a cell culture medium to investigate the corrosion behaviors and compare the difference in these two kinds of media. The results show that in the immersion tests in conventional simulated body fluid, the 20-minute MAO coated sample has the best resistance to corrosion due to the largest coating thickness. In contrast, in the cell culture medium, all MAO coated samples demonstrate a similar high corrosion resistance behavior, independent of MAO processing time. This is probably due to the organic passive layers formed on the coating surfaces. Additionally, a preliminary finite element model has been developed to simulate the immersion test of magnesium alloy in simulated body fluid. Comparison between the predicted corrosion current density and experimental data is discussed.