Yes / Highly oriented long-chain-branched poly (lactic acid) (LCB-PLA) was prepared and the structure evolution was studied in the process of solid die drawing by compared with poly (lactic acid) (PLA). During drawing, samples underwent not only die drawing process but also free drawing process. Drawing speed presented a prominent effect on the free drawing process, while die thickness showed a more obvious influence on the die drawing process. For PLA, free drawing process mainly contributed to its final orientation degree and crystallinity, and thus the mechanical properties of PLA were greatly influenced by drawing speed. However, for LCB-PLA, die drawing process made a greater contribution to the final orientation degree and crystallinity, and its mechanical properties were mainly affected by die thickness. Under the same drawing condition, the tensile strength and modulus of LCB-PLA were always higher than those of PLA, and reached up to 228 MPa and 7.2 GPa, respectively, which basically met the requirement for born fixation materials. Samples which only underwent die drawing showed obvious “sandwich” structure, and the thickness of the oriented skin layer for LCB-PLA was thicker than that for PLA, suggesting that shear-induced orientation can be easily retained due to the enhanced entanglement between long branched chains. After drawing, LCB-PLA samples showed smaller lamellae size (Llateral) but larger long period (Lac) compared with PLA, suggesting that the low chain mobility restricted the motion of chain slipping of LCB-PLA and thus resulted in the fragmentation of neighboring crystal lamella by chain stretched-out.

Yes / The shape memory effect of highly oriented long‐chain‐branched poly(lactic acid) (LCB‐PLA) prepared through solid‐phase die drawing technology was studied by comparison with PLA. When the recovery temperature increased from 60°C to 120°C, for PLA, only one‐step recovery at about 80°C can be observed and the recovery ratio was below 21.5%, while, for LCB‐PLA, multiple recovery behavior with high recovery ratio of 78.8% can be achieved. For oriented PLA, the recovery curve of the final sample showed the same trend with that of sample suffering just free drawing; while for oriented LCB‐PLA, the recovery curve of the final sample showed the same trend with that of sample suffering just die drawing. After shape recovery, the mechanical properties of LCB‐PLA showed a linear downward trend with the recovery temperature. Together with amorphous phase, the oriented mesomorphic phase, which formed during solid die drawing, can act as switching domains. And thus, upon heating, the chain segment of amorphous phase relaxed at first and triggered the first macroscopical shape recovery, leading to the decrease of long period (Lac) and the thickness of the amorphous layer (La). Then, with further increasing temperature, the oriented mesomorphic phase gradually relaxed resulting subsequently multi‐shape recovery, and the Lac and the La further decreased. Therefore, by regulating the recovery temperature of oriented LCB‐PLA, the shape recovery ratio and mechanical strength can be controlled effectively, and thus the self‐reinforced and self‐fastening effect can be achieved simultaneously for PLA as bone fixation material.