One of the major problems with surface-mounted or embedded induced strain actuator (ISA) patches are the considerably high stress gradients introduced at the edges of the actuator patches when an electric field is applied. These excessive stress gradients initiate debonding of the actuators from the substrate, thus affecting the mechanical reliability of the structure. This thesis is begun by investigating existing theoretical models of induced strain actuated structures, and will later use these to compare with the finite element analysis. The finite element analysis is used to explore the stress concentrations located at the edges of the actuators and begins by refining the mesh areas of the same structure focusing in on the ends of the ISA’s. This preliminary analysis is conducted on a structural configuration with a perfectly bonded actuator and proceeds to one with a finite bonding layer. After completion of the mesh refinement investigation several modifications in the design and implementation of the induced strain actuators are examined to reduce the stress concentrations at the edges of the actuators. In the finite element analysis two separate modeling considerations are examined: 1) The actuator is perfectly-bonded to the substrate. 2) A finite adhesive layer is incorporated between the actuator and the substrate. With each modeling consideration several design modifications are considered in this thesis including employing partial electrodes on the induced strain actuator surface regions instead of fully electroded surfaces, examining an actuator with a chamfered end, and using caps to reduce the stress concentrations and possibly increase the performance of the structure by allowing the induced strain actuators to utilize their piezoelectric strain coefficient in the thickness direction, d₃₃. The design modifications and different modeling techniques help to alleviate the critical stresses in the structure while gaining a better understanding of causes them. / Master of Science