The main objective of the research was to investigate the effect of influent organic compounds on the performance of biological nutrient removal system. To carry out the investigation, a pilot plant system was designed and constructed. The system was operated as a UCT process at an influent flow rate of 0.15 liters/minute and a sludge age of 13 days. The influent wastewater was domestic sewage. Excess biological phosphorus removal and steady-state conditions were established before making experimental measurements, or adding supplemental substrate. The effects of separate addition of formic, acetic, propionic, butyric, isobutyric, valeric, and isovaleric acid, plus glucose, addition on phosphorus release under anaerobic conditions, and phosphorus uptake under aerobic conditions, were studied. The effects of the organic acid additions on the removal of nitrogen and COD, and changes in SOUR, MLVSS, and metals such as iron, magnesium, calcium and potassium, were also studied. In all experiments, the specific substrate was added continuously to the first anaerobic reactor for three days at an influent concentration of 100 mg COD/liter. Samples were collected from each reactor at the end of the addition period and analyzed for orthophosphate, nitrate, nitrite, sulfate, volatile fatty acids, COD, MLVSS, pH and metals. All added substrates, except formic acid and dextrose, caused significant increases in phosphorus release in the anaerobic stage, and phosphorus uptake, in the aerobic stage, and consequently, an increase in phosphorus removal efficiency. The molar ratios of phosphorus release to volatile fatty acid added obtained for propionic acid, acetic acid, butyric acid, and valeric acid were 0.44, 0.77, 0.78, and 1.72 respectively. However, on a COD basis, the greatest ratios of mg phosphorus released to mg COD utilized was produced by the addition of acetic acid (0.37) and valeric acid (0.19). It was also found that the branched organic acids, isobutyric and isovaleric, caused more phosphorus release in the anaerobic stage and better phosphorus removal efficiencies as compared with the nonbranching forms of the same organic acids. The molar ratios of phosphorus release for these two acids were 0.8 and 2.3, respectively, and on a COD basis were 0.16 and 0.25. For engineering applications, it is suggested by this research that at least 20 mg COD equivalent of acetic acid is needed for the removal of I mg phosphorus. The results obtained by this investigation were consistent with the hypothesis proposed by Marais et al., 1983. The most recent biochemical models, proposed by Comeau et al., 1986 and Wentzel et al., 1986, were also tested using the data collected in the present investigation. Both models, in most cases, overestimated the ratios of phosphorus release to volatile fatty acid utilized. A speculative model for anaerobic metabolism by poly-p bacteria of volatile fatty acids which contain both odd and even numbers of carbon atoms was proposed. All added substrates produced no effect on both COD and TKN removals. Metal releases were found to correlate with the amount of phosphorus release. / Ph. D.