This thesis presents the results of a series of experiments in which electrons are superelastically scattered from various laser excited states of sodium. The atoms, once in the optically prepared state, are forced to relax via the superelastic collision with an electron. The rate of detection of superelastically scattered electrons was measured as a function of the laser polarisation which enabled pseudo Stokes parameters to be determined. These pseudo Stokes parameters are functions of both optical pumping parameters and atomic collision parameters. The optical pumping parameters describe the laser-atom interaction and the atomic collision parameters describe the electron-atom collision process. Three different laser excitation mechanisms were used to optically pump the atoms into various excited states. The first of these used a single laser tuned to the 32S 112(F'=2 hyperfine state)-~32P312 transition. The excited atoms underwent a superelastic collision with an electron leaving the atom in the ground state and pseudo Stokes parameters were measured as a function of both scattering angle and incident electron energy. The second superelastic experiment, utilised a folded step excitation mechanism which employed two lasers tuned from the two hypethne states of the 32S112 ground state respectively to the 32P312 excited state. Power broadening effects in the single laser experiment cause the atoms to be optically pumped into the F= 1 hyperfine ground state. The laser powers used were not great enough to power broaden the hyperfine ground states and as such the F'= 1 sublevel effectively acted as a sink. The folded step excitation method enabled the excited state population to be increased so that data at larger scattering angles could be obtained. Stokes parameters from both of these experiments which had an incident energy range of 10eV to 30eV and an angular range of 5°-25° were compared to three current electron-atom scattering theories and previous experimental data. Overall, fair to good agreement was found between theory and experiments for the individual Stokes parameters. Losses of coherence was observed at small scattering angles (50.200) at 20eV and 25eV incident electron energies which were poorly modelled by the three different theories. The third superelastic experiment involved the use of two lasers of specified polarisation to stepwise excite the atoms to the 32D512 excited state. Superelastic collisions with incident electron energies of 20eV from the 32D512-*32P312~312 collision were studied at three different scattering angles and pseudo Stokes parameters for the case where the polarisations of the radiation from the lasers were parallel were measured. The single step and folded step laser-atom interactions for it excitation were modelled using a full quantum electrodynamical treatment so that the optical pumping parameters from the single and folded step experiments could be investigated. Equations of motion were derived in the Heisenberg picture and it is shown that for the single laser case 59 equations of motion are required to fully model the interaction and for the folded step ease 78 equations of motion are required. The results of calculations demonstrated that the optical pumping parameters were sensitive to laser intensity, laser detuning and the Doppler width of the atomic beam. The theoretical quantum electrodynamical calculation results were in good agreement with the experimental results.

The research presented in this dissertation was performed in the Atomic, Molecular and Optical (AMO) physics laboratory at the University of Manitoba. Atomic beams of the two-valence-electron heavy atom systems, barium and ytterbium, were investigated with low energy electron scattering and optical emission studies. Both the ground states and laser excited states were investigated as a function of incident electron beam energy from 10 eV to 50 eV. Measurements of relative cross sections and polarization for 583 nm and 554 nm line emission from the (6s7p)1P1 and (6s6p)1P1 states of barium excited by electron impact from both the ground states and the optically pumped metastable (6s5d)1D2 are reported. Data are normalized to absolute cross sections for the ground state (6s2)1S0→(6s6p)1P1 state transition due to electron scattering, with corrections for branching ratios and cascading from higher states to deduce the total level excitation cross sections. Results are also presented for the first studies of the 399 nm line emission from laser-excited ytterbium, yielding an upper limit on the apparent cross section for the (6s6p)3P1→(6s6p)1P1 transition. Results are compared with the latest theoretical models and previous data, where available. / October 2015

Polycyclic aromatic compounds (PACs), which comprise a complex class of condensed multi-ring benzenoid compounds, are important environmental pollutants originating from a wide variety of natural and anthropogenic sources. PACs are generally formed during incomplete combustion of pyrolisis of organic matter containing carbon and hydrogen. Because combustion of organic materials is involved in countless natural processes or human activities, PACs are omnipresent and abundant pollutants in air, soil, and water. Chemical analysis of PACs is of great environmental and toxicological importance. Many of them are highly suspect as etiological agents in human cancer. Because PACs carcinogenic properties strongly depend on molecular structure and differ significantly from isomer to isomer, it is of paramount importance to determine the most toxic isomers even if they are present at much lower concentrations than their less toxic isomers. Gas chromatography (GC), high-resolution GC, and high-performance liquid chromatography (HPLC) are the basis for standard PACs identification and determination. Many cases exist where GC, HPLC, and even HR-GC have not been capable to provide unambiguous isomer identification. The lack of reliable analytical data has lead to serious errors in environmental and toxicological studies. This dissertation deals with the development of novel instrumentation and analytical methods for the analysis of PACs in environmental samples. The developed methodology is based on two well-known high-resolution luminescence techniques, namely Shpol'skii Spectroscopy (SS) and Fluorescence Line Narrowing Spectroscopy (FLNS). Although these two techniques have long been recognized for their capability in providing direct determination of target PACs in complex environmental samples, several reasons have hampered their widespread use for the problem at hand. These include inconvenient sample freezing procedures; questions about signal reproducibility; lengthy spectral acquisition, which might cause severe sample degradation due to prolonged excitation; broadband fluorescence background that degrades quality of spectra, precision of measurements and detection limits; solvent constrains imposed by the need of optically transparent media; and, most importantly, the lack of selectivity and sensitivity for unambiguous determination of closely related PACs metabolites. This dissertation presents significant advances on all fronts. The analytical methodology is then extended to the analysis of fluoroquinolones (FQs) in aqueous samples. FQs are one of the most powerful classes of antibiotics currently used for the treatment of urinary tract infections. Their widespread use in both human and animal medicine has prompted their appearance in aquatic systems. The search for a universal method capable to face this new environmental challenge has been centered on HPLC. Depending on the FQ and its concentration level, successful determination has been accomplished with mass spectrometry, room-temperature fluorescence (RTF) or UV absorption spectrometry. Unfortunately, no single detection mode has shown the ability to detect all FQ at the concentration ratios found in environmental waters. We provide a feasible alternative based on FLNS. On the instrumentation side, we present a single instrument with the capability to collect multidimensional data formats in both the fluorescence and the phosphorescence time domains. We demonstrate the ability to perform luminescence measurements in highly scattering media by comparing the precision of measurements in optically transparent solvents (Shpol'skii solvents) to those obtained in "snow-like" matrixes and solid samples. For decades, conventional low-temperature methodology has been restricted to optically transparent media. This restriction has limited its application to organic solvents that freeze into a glass. In this dissertation, we remove this limitation with the use of cryogenic fiber-optic probes. Our final efforts deal with low-temperature absorption measurements. Recording absorption spectra via transmittance through frozen matrixes is a challenging task. The main reason is the difficulty to overcome the strong scattering light reaching the detector. This is particularly true when thick samples are necessary for recording absorption spectra of weak oscillators. In the case of strongly fluorescent compounds, additional errors in absorbance measurements arise from the emission reaching the detector, which might have comparable intensity to that of the transmitted light. We present a fundamentally different approach to low-temperature absorption measurements as the sought-for-information is the intensity of laser excitation returning from the frozen sample to the intensified-charge coupled device (ICCD). Laser excitation is collected with the aid of a cryogenic fiber optic probe. The feasibility of our approach is demonstrated with single-site and multiple-site Shpol'skii systems. 4.2K absorption spectra show excellent agreement to their literature counterparts recorded via transmittance with closed cycle cryogenators. Fluorescence quantum yields measured at room-temperature compare well to experimental data acquired in our lab via classical methodology. Similar agreement is observed between 77K fluorescence quantum yields and previously reported data acquired with classical methodology. We then extend our approach to generate original data on fluorescence quantum yields at 4.2K.

This dissertation focuses on the development of analytical methodology for the analysis of polycyclic aromatic hydrocarbons (PAHs) in water samples. Chemical analysis of PAHs is of great environmental and toxicological importance. Many of them are highly suspect as etiological agents in human cancer. Among the hundreds of PAHs present in the environment, the U.S. Environmental Protection Agency (EPA) lists sixteen as "Consent Decree" priority pollutants. Their routine monitoring in environmental samples is recommended to prevent human contamination risks. A primary route of human exposure to PAHs is the ingestion of contaminated water. The rather low PAH concentrations in water samples make the analysis of the sixteen priority pollutants particularly challenging. Current EPA methodology follows the classical pattern of sample extraction and chromatographic analysis. The method of choice for PAHs extraction and pre-concentration is solid-phase extraction (SPE). PAHs determination is carried out via high-performance liquid chromatography (HPLC) or gas chromatography/mass spectrometry (GC/MS). When HPLC is applied to highly complex samples, EPA recommends the use of GC/MS to verify compound identification and to check peak-purity of HPLC fractions. Although EPA methodology provides reliable data, the routine monitoring of numerous samples via fast, cost effective and environmentally friendly methods remains an analytical challenge. Typically, 1 L of water is processed through the SPE device in approximately 1 h. The rather large water volume and long sample processing time are recommended to reach detectable concentrations and quantitative removal of PAHs from water samples. Chromatographic elution times of 30 - 60 min are typical and standards must be run periodically to verify retention times. If concentrations of targeted PAHs are found to lie outside the detector's response range, the sample must be diluted (or concentrated), and the process repeated. In order to prevent environmental risks and human contamination, the routine monitoring of the sixteen EPA-PAHs is not sufficient anymore. Recent toxicological studies attribute a significant portion of the biological activity of PAH contaminated samples to the presence of high molecular weight (HMW) PAHs, i.e. PAHs with MW ≥ 300. Because the carcinogenic properties of HMW-PAHs differ significantly from isomer to isomer, it is of paramount importance to determine the most toxic isomers even if they are present at much lower concentrations than their less toxic isomers. Unfortunately, established methodology cannot always meet the challenge of specifically analyzing HMW-PAHs at the low concentration levels of environmental samples. The main problems that confront classic methodology arise from the relatively low concentration levels and the large number of structural isomers with very similar elution times and similar, possibly even virtually identical, fragmentation patterns. This dissertation summarizes significant improvements on various fronts. Its first original component deals with the unambiguous determination of four HMW-PAHs via laser-excited time-resolved Shpol'skii spectroscopy (LETRSS) without previous chromatographic separation. The second original component is the improvement of a relatively new PAH extraction method - solid-phase nanoextraction (SPNE) - which uses gold nanoparticles as extracting material for PAHs. The advantages of the improved SPNE procedure are demonstrated for the analysis of EPA-PAHs and HMW-PAHs in water samples via GC/MS and LETRSS, respectively.