An indirect tire pressure monitoring system uses the wheel rolling radius as an indicator of low tire pressure. When extra load is put in the trunk of a car, the load distribution in the car will change. This will affect the rolling radius which in its turn will be confused with a change in the tire pressure. To avoid this phenomenon, the load distribution has to be estimated. In this thesis methods for estimating the pitch angle of a car and an offset in the pitch angle caused by changed load distribution are presented and when an estimate is derived, a load distribution can be derived. Alot of available signals are used but the most important are the longitudinal accelerometer signal and the acceleration at the wheels derived from the velocity of the car. A few ways to detect or compensate for a non-zero road grade are also presented. Based on the estimated offset, a difference between the front and rear axle heights in the vehicle can be estimated and compensating for the changed load distribution in an indirect tire pressure monitoring system will be possible.