Titanium dioxide or titania is applied in paints, in the paper industry, fibbers, cosmetics, sunscreen products, toothpaste, foodstuffs, optical coatings, beam splitters and anti-reflection coatings. It is also used as support catalyst and its use as humidity and high-temperature oxygen sensor is under consideration. These applications are related to its high refractive index, oil absorption, tinting strength and inert chemical properties. Commonly, titania is recovered either by leaching ilmenite with sulphuric acid and subsequently hydrolysing the resulting sulfate solution by boiling. In another process, titanium feedstock is converted into titanium tetrachloride and further oxidised to titanium dioxide. These methods are reportedly time-consuming and environmentally unfriendly. They are also unable to use all existing types of titanium minerals. In this study, a novel process for the extraction of titanium valuables from its minerals is presented. The process entails the roasting of titanium ore with alkaline metal salt. The roasted product is hydrolysed with water and acid, and subsequently reacted with sulphuric acid. Alternatively, the hydrolysed product can be used as feedstock in the chloride process. Roasting at 900°C and using a 2:1 (NaOH:ilmenite) mole ratio proved to be the most efficient in releasing titanium units from its ore. Ternary phases dominate under these conditions. Na0.75Fe0.75Ti0.25O2 was the dominant titanium-bearing phase. NaFeTiO4a ndNa2Fe2Ti3O10 were also present. Whenever the Ti:Fe atom ratio was different from one, the surplus titanium was accommodated in single titanates, mainly Na2TiO3, while iron was accommodated in NaFeO2. In many cases Na8Ti5O14 was also present as a result of Na2TiO3 polymerisation. This is consistent with a fusion period of one hour or more. Shorter fusion periods tended to produce binary phases. Similar results were obtained when lower fusion temperatures were employed, i.e. below 550°C. When anatase reactant was used to resemble an anatase ore, Na2Ti6O3,Na2TiO3, Na8Ti5O14 and Na16Ti10O28 were identified in the products. Optimum recoveries were obtained using a 1:1 NaOH:TiO2 mole ratio, and fusing at 800°C for 2 h. Close to 100% of the titanium was recovered. A one-step leaching process was found to be effective compared with multi-step leaching. The leaching step was found to be dependent on time, solid:liquid ratio and temperature. The optimum conditions for solid:liquid ratio, time and temperature were found to be 0.20, and 15 min at 75°C, respectively. Acidic hydrolysis was controlled by the relative amount of iron and titanium in solution. It was found that less than 1% was dissolved between 3 and 7 in pH units. Higher pH values are recommended, since less acid will be used. Any excess of sulphuric acid in the sulfation step proved to be unnecessary. No significant changes were observed in the amount of dissolved iron and titanium. Therefore the stoichiometric amount can be used in the sulfation process. / Thesis (PhD)--University of Pretoria, 2012. / Chemistry / unrestricted