No description available.

This work reports the experimental and numerical study of the thermal management of Li-ion battery packs under the context of electric vehicle (EV) or hybrid EV (HEV) applications. Li-ion batteries have been extensively demonstrated as an important power source for EVs or HEVs. However, thermal management is a critical challenge for their widespread deployment, due to their highly dynamic operation and the wide range of environments under which they operate. To address these challenges, this work developed several experimental platforms to study adaptive thermal management strategies. Parallel to the experimental effort, multi-disciplinary models integrating heat transfer, fluid mechanics, and electro-thermal dynamics have been developed and validated, including detailed CFD models and lumped parameter models. The major contributions are twofold. First, this work developed actively controlled strategies and experimentally demonstrated their effectiveness on a practical sized battery pack and dynamic thermal loads. The results show that these strategies effectively reduced both the parasitic energy consumption and the temperature non-uniformity while maintaining the maximum temperature rise in the pack. Second, this work established a new two dimensional lumped parameter thermal model to overcome the limitations of existing thermal models and extend their applicable range. This new model provides accurate surface and core temperatures simulations comparable to detailed CFD models with a fraction of the computational cost. / Ph. D.

This thesis deals with thermal management aspects of electric machinery used in high-performance  applications  with  particular  focus put  on electric machines designed for hybrid electric vehicle applications. In the first part of this thesis,  new thermal models of liquid (water and oil) cooled electric machines are proposed.  The proposed thermal models are based on a combination of lumped parameter (LP)  and numerical methods. As  a first  case study,  a permanent-magnet  assisted  synchronous reluctance machine (PMaSRM) equipped with a housing water jacket is considered.  Particular focus is put on the stator winding and a thermal model is proposed that divides the stator slot into a number of elliptical copper and impregna- tion layers.  Additionally, an analysis, using results from a proposed simplified thermal finite element (FE)  model representing only a single slot of the sta- tor and its corresponding end winding, is presented in which the number of layers and the proper connection between the parts of the LP thermal model representing the end winding and the active part of winding are determined. The approach is attractive due to its simplicity  and the fact  that it closely models the actual temperature distribution for common slot geometries.  An oil-cooled induction machine where the oil is in direct contact with the stator laminations  is also considered.  Here, a multi-segment structure is proposed that  divides  the  stator,  winding and cooling  system  into  a number  of an- gular  segments.   Thereby,  the  circumferential  temperature  variation  due to the  nonuniform distribution  of the  coolant  in the  cooling  channels  can be predicted. In the  second part  of this  thesis,  the  thermal  impact  of using  different winding impregnation  and steel  lamination  materials  is  studied.   Conven- tional varnish, epoxy and a silicone based thermally conductive impregnation material are investigated and the resulting temperature distributions in three small induction machines are compared. The thermal impact of using different steel lamination materials is investigated by simulations using the developed thermal  model  of the water  cooled  PMaSRM. The  differences  in alloy con- tents and steel lamination thickness are studied separately and a comparison between the produced iron losses and the resulting hot-spot temperatures is presented. Finally, FE-based approaches  for  estimating  the  induced  magnet  eddycurrent losses in the rotor of the considered PMaSRM are reviewed and compared in the  form  of a case  study  based on simulations.   A  simplified three-dimensional  FE model  and an analytical  model,  both  combined  with time-domain 2D FE analysis, are shown to predict the induced eddy current losses with a relatively good accuracy compared to a complete 3D FE based model.  Hence, the two simplified approaches are promising which motivates a possible future experimental verification. / <p>QC 20130528</p>