Mobile platforms for archaeological purposes have increased in use over the last 20 years with many of the developments coming from Continental Europe. Mobile platform developments have mainly focused on one type of instrumentation, offering multiple sensors, depths of detection or frequencies. This development of mobile platforms has focused on data acquisition rates but has not considered the physical impact on the soil. The Geoscan Research Mobile Sensor Platform (MSP40) was intended to improve survey efficiency and remain a lightweight system. The platform can collect two earth resistance configurations that show directional variation of the current flow through soil. Additional sensors were integrated on to the square frame of the hand-pulled cart to record simultaneous fluxgate gradiometer data and a microtopographic surveys. Ground based geophysical investigation will always have a physical impact on a site. The MSP40 is no exception but careful selection of wheel types and the lightweight frame limit the damage compared to many mobile arrays. The MSP40 has been tested on a number of different soils at various times of the year with encouraging results; however issues with overcoming the contact resistance of electrodes remain. The continuous collection rate and combination of techniques means a slight drop in data quality is inevitable. However the increased data density, multiple-sensors and improved rate of collection offset reductions in data quality. The research has shown that the MSP40 can perform low impact rapid site assessments on ¿vulnerable¿ sites, whilst maximising the information gained from a single traverse. / AHRC, Geoscan Research

No / The square array was initially tested in the UK during the 1960s by Anthony Clark. However, since the development of the twin probe system, the square array has been seldom used in the UK, although greater use has been reported elsewhere, especially in France (Panissod et al., 1998). In the last few years, re-investigation of the square array¿s potential in an archaeological context has reignited interest and led to the development of a hand-pulled cart system by Dr. Roger Walker (Geoscan Research). This cart system incorporates earth resistance and gradiometer instruments to allow simultaneous surveys with a lightweight device. The main objective of the project is to test the application of the MSP40 on a variety of sites and to encourage the use of appropriate geophysical survey equipment to minimize the impact and therefore protect even the most vulnerable of archaeological sites.

Mobile platforms for archaeological purposes have increased in use over the last 20 years with many of the developments coming from Continental Europe. Mobile platform developments have mainly focused on one type of instrumentation, offering multiple sensors, depths of detection or frequencies. This development of mobile platforms has focused on data acquisition rates but has not considered the physical impact on the soil. The Geoscan Research Mobile Sensor Platform (MSP40) was intended to improve survey efficiency and remain a lightweight system. The platform can collect two earth resistance configurations that show directional variation of the current flow through soil. Additional sensors were integrated on to the square frame of the hand-pulled cart to record simultaneous fluxgate gradiometer data and a microtopographic surveys. Ground based geophysical investigation will always have a physical impact on a site. The MSP40 is no exception but careful selection of wheel types and the lightweight frame limit the damage compared to many mobile arrays. The MSP40 has been tested on a number of different soils at various times of the year with encouraging results; however issues with overcoming the contact resistance of electrodes remain. The continuous collection rate and combination of techniques means a slight drop in data quality is inevitable. However the increased data density, multiple-sensors and improved rate of collection offset reductions in data quality. The research has shown that the MSP40 can perform low impact rapid site assessments on 'vulnerable' sites, whilst maximising the information gained from a single traverse.