No description available.

Among current technologies used for the treatment of polycyclic aromatic hydrocarbons (PAHs) -contaminated media, adsorption has been reported to offer relatively high PAH removal efficiency while being rapid and cost-effective. Therefore, the main goal of this research was to assess and optimize the adsorption process for the removal of PAHs from contaminated water and soil using recoverable magnetic activated carbon-based composites. In the first phase, 6 different composites, 3 magnetic powder activated carbon (MPAC) composites and 3 magnetic granular activated carbon (MGAC) composites, were synthesized, and then, characterized using XRD, FE-SEM, EDS, and FTIR methods. The adsorption experiments revealed that all the recoverable MPACs and MGACs were capable of removing the PAHs from water, with removal percentages ranging from 87.2 to 99.3%. The PAH-loaded MPAC and MGAC with the highest PAH removal efficiency were also subjected to a series of desorption studies. The results indicated that the PAHs desorption was in the range 38.1-60.1% for low molecular weight (LMW) PAHs and 23.4 to 57.2% for the high molecular weight (HMW) PAHs. In the second phase, the adsorption kinetics and isotherms studies were performed on MPAC synthesized by a precipitation (MPAC-Prec.) method, which showed the highest PAH removal efficiency among the prepared magnetic activated carbons (MACs). The PAHs adsorption by MPAC-Prec. was rapid, reaching equilibrium in 6 h with the removal efficiency ranging from 95.6 to 100.0% under the conditions of this study. Among the studied kinetics models, pseudo-second order fitted the experimental data very well, implying that all the MPAC adsorption sites had an equal affinity for PAHs. The results of the kinetic studies also indicated that the greater molecular weight PAHs had a slower adsorption rate due to the slower transfer of their molecules to the MPAC adsorption sites. With an R2 in the range 0.73-0.96, the Langmuir model described the isotherms adsorption of LMW and HMW PAHs better than the other isotherms models. Furthermore, according to the Langmuir model, the maximum adsorption capacity of MPAC-Prec. was determined to be between 8.7 and 11.4 µg/mg for the LMW PAHs, and 8.4 and 20.2 µg/mg for the HMW PAHs. In the third phase, a series of soil washing tests using MGAC synthesized by co-precipitation (MGAC-CoP) method, were carried out to explore the effect of MAC on the PAHs removal from soil. The employed MGAC was the second most efficient MAC in the PAHs adsorption experiments (first phase of research), and it showed greater recovery from soil washing mixture compared to the MPAC-Prec. in the preliminary tests. The MGAC-CoP composite had a surface area and total pore volume of 837.9 m2/g and 0.5 cm3/g, respectively, which were approximately 10% lower than the bare GAC, according to BET test results. Soil washing parameters were optimized for the treatment of a real contaminated soil, which were MGAC-CoP dose of 2% (w/w), washing time of 24 h, liquid to soil ratio of 15:1, stirring speed of 100 rpm, pH of 8.3, and temperature of 25 ˚C. Under these optimized conditions, an average PAHs removal of 47.4% was obtained. Among the LMW and HMW PAHs, anthracene (ANT), and fluoranthene (FLUO) showed the highest affinity to MGAC during the treatment process, with 57.7% and 67.1% removal from soil, respectively. The thermodynamic studies revealed that the adsorption of the LMW and HMW PAHs onto MGAC in soil washing was non-spontaneous and endothermic as the values of Gibbs free energy (∆G˚>0) and Enthalpy change (∆H˚>0) were positive. In the fourth phase, the efficiency of MGAC-CoP in surfactant-enhanced soil washing for the PAH removal and the recovery of the surfactant solution was studied. The effective parameters of soil washing with the surfactant (Tween 80) were assessed using a real contaminated soil sample, and the results showed that 5% Tween 80, a liquid to soil ratio of 10:1, and a 72-hour washing time at 20°C were optimum operating conditions. Under these conditions, the average PAHs removal efficiency was 67.6%, which was higher than the 47.4% obtained for the same soil with no surfactant addition in phase 3. The possibility of recycling and reusing the Tween 80 solution was investigated by adding MGAC-CoP to the soil and surfactant solution mixture during the soil washing process. For this purpose, 5% Tween 80 and 2% (w/w) MGAC were used in 7 successive washing cycles, with no regeneration process for the MGAC composite. The results revealed that the combination of surfactant and MGAC was capable of removing 68.6, 70.7, 70.3, 61.6, 55.5, 50.2, and 39.4% of the PAHs from soil in the 7 washing cycles, respectively. Furthermore, the recycled Tween 80 and non-regenerated MGAC did not produce any waste or effluent after 6 times reuse in the treatment process, while successfully recovered and reused. This implies that soil washing with Tween 80 and MGAC is a very affordable, efficient, and practical method for remediation of PAH-contaminated soils.