This thesis compared macrotexture measurements obtained using the volumetric method (Sand Patch) and three laser-based devices: MGPS system, ICC laser profiler, and Circular Texture Meter (CTMeter). The study used data from three sources: two controlled experiments conducted at the Virginia Smart Road, field data collected on eight newly constructed hot-mix-asphalt (HMA) roadway surfaces, and data collected on airport surfaces at the Wallops flight facility, Virginia. The data collected at the Virginia Smart Road, a controlled-access two-lane road that includes various HMA and concrete surfaces, was used for the main analysis. The other two sets of data were used for verification and validation of the model developed. The analysis of the data collected at the Virginia Smart Road showed that the CTMeter mean profile depth (MPD) has the highest correlation with the volumetric (Sand Patch) mean texture depth (MTD). Furthermore, texture convexity had a significant effect on the correlation between the measurements obtained with different devices. Two sets of models for converting the laser-based texture measurements to an estimated MTD (ETD) were developed. One set of equations considered all the data collected at the Virginia Smart Road, and the other excluded the measurements on the Open-Graded Friction Course (OGFC). The developed models were tested using measurements collected at eight roadway sections throughout Virginia and the Wallops flight facility. The model, excluding the OGFC section, was successfully applied to other sites. / Master of Science

This diploma thesis deals with the relation between the longitudinal friction coefficient dependence on measuring speed and the value of road surface macrotexture MPD. Results of longitudinal friction coefficient and value of MPD measurement on 73 sections are included in this thesis. The results were compared by regression analysis and its outcome was used for determination of formula that enable calculation of longitudinal friction coefficient for any operating speed when longitudinal friction coefficient for 60 km/h and value of macrotexture are known. The evaluation scale for skid resistance index (SRI) was also determined in this thesis. It could be used for evaluation of skid resistance independently of the type of device used for friction coefficient measurement.