No description available.

Robot motion can be described in several alternative representations, including joint configuration or end-effector spaces. These representations are often used for manipulation or navigation tasks but they are not suitable for tasks that involve close interaction with the environment. In these scenarios, collisions and relative poses of the robot and its surroundings create a complex planning space. To deal with this complexity, we exploit several representations that capture the state of the interaction, rather than the state of the robot. Borrowing notions of topology invariances and homotopy classes, we design task spaces based on winding numbers and writhe for synthesizing winding motion, and electro-static fields for planning reaching and grasping motion. Our experiments show that these representations capture the motion, preserving its qualitative properties, while generalising over finer geometrical detail. Based on the same motivation, we utilise a scale and rotation invariant representation for locally preserving distances, called interaction mesh. The interaction mesh allows for transferring motion between robots of different scales (motion re-targeting), between humans and robots (teleoperation) and between different environments (motion adaptation). To estimate the state of the environment we employ real-time sensing techniques utilizing dense stereo tracking, magnetic tracking sensors and inertia measurements units. We combine and exploit these representations for synthesis and generalization of motion in dynamic environments. The benefit of this method is on problems where direct planning in joint space is extremely hard whereas local optimal control exploiting topology and metric of these novel representations can efficiently compute optimal trajectories. We formulate this approach in the framework of optimal control as an approximate inference problem. This allows for consistent combination of multiple task spaces (e.g. end-effector, joint space and the abstract task spaces we investigate in this thesis). Motion generalization to novel situations and kinematics is similarly performed by projecting motion from abstract representations to joint configuration space. This technique, based on operational space control, allows us to adapt the motion in real time. This process of real-time re-mapping generates robust motion, thus reducing the amount of re-planning. We have implemented our approach as a part of an open source project called the Extensible Optimisation library (EXOTica). This software allows for defining motion synthesis problems by combining task representations and presenting this problem to various motion planners using a common interface. Using EXOTica, we perform comparisons between different representations and different planners to validate that these representations truly improve the motion planning.

This thesis is on the space--time variational multiscale (ST-VMS) computation of wind-turbine rotor and tower aerodynamics. The rotor geometry is that of the NREL 5MW offshore baseline wind turbine. We compute with a given wind speed and a specified rotor speed. The computation is challenging because of the large Reynolds numbers and rotating turbulent flows, and computing the correct torque requires an accurate and meticulous numerical approach. The presence of the tower increases the computational challenge because of the fast, rotational relative motion between the rotor and tower. The ST-VMS method is the residual-based VMS version of the Deforming-Spatial-Domain/Stabilized ST (DSD/SST) method, and is also called ``DSD/SST-VMST'' method (i.e., the version with the VMS turbulence model). In calculating the stabilization parameters embedded in the method, we are using a new element length definition for the diffusion-dominated limit. The DSD/SST method, which was introduced as a general-purpose moving-mesh method for computation of flows with moving interfaces, requires a mesh update method. Mesh update typically consists of moving the mesh for as long as possible and remeshing as needed. In the computations reported here, NURBS basis functions are used for the temporal representation of the rotor motion, enabling us to represent the circular paths associated with that motion exactly and specify a constant angular velocity corresponding to the invariant speeds along those paths. In addition, temporal NURBS basis functions are used in representation of the motion and deformation of the volume meshes computed and also in remeshing. We name this ``ST/NURBS Mesh Update Method (STNMUM).'' The STNMUM increases computational efficiency in terms of computer time and storage, and computational flexibility in terms of being able to change the time-step size of the computation. We use layers of thin elements near the blade surfaces, which undergo rigid-body motion with the rotor. We compare the results from computations with and without tower, and we also compare using NURBS and linear finite element basis functions in temporal representation of the mesh motion.