A new generation of medical grade Cf-252 sources was developed in 2002 at the Oak Ridge National Laboratory (ORNL). The combination of small size and large activity of these Cf-252 sources makes them suitable to be used with the conventional high-dose-rate (HDR) remote afterloading systems for interstitial brachytherapy. A recent in-water calibration experiment showed that the measured gamma dose rates near the new source are slightly greater than the neutron dose rates; contradicting the well established neutron-to-gamma dose ratio of approximately 2:1 at locations near a Cf-252 brachytherapy source. Specifically, the MCNP-predicted gamma dose rate is a factor of two higher than the measured gamma dose rate at the distance of 1 cm, and the differences between the two results gradually diminish at distances farther away from the source. To resolve this discrepancy, we updated the source gamma spectrum by including in the ORIGEN-S data library the experimentally measured Cf-252 prompt gamma spectrum as well as the true Cf-252 spontaneous fission yield data to explicitly model delayed gamma emissions from fission products. We also investigated the bremsstrahlung x-rays produced by the beta particles emitted from fission-product decays. The results show that the discrepancy of gamma dose rates is mainly caused by the omission of the bremsstrahlung x-rays in the MCNP runs. By including the bremsstrahlung x-rays, the MCNP results show that the gamma dose rates near a new Cf-252 source agree well with the measured results and that the gamma dose rates are indeed greater than the neutron dose rates. The calibration experiment also showed discrepancies between the experimental and computational neutron dose profiles obtained. Specifically the MCNP-predicted neutron dose rates were ~25% higher than the measured neutron dose rates at all distances. In attempting to resolve this discrepancy the neutron emission rate was verified by the National Institute of Standards and Technology (NIST) and an experiment was performed to explore the effects of bias voltage on ion chamber charge collection. So far the discrepancies between the computational and experimental neutron dose profiles have not been resolved. Further study is needed to completely resolve this issue and some suggestions on how to move forward are given.

Friction bit joining (FBJ) is a new method that enables lightweight metal to be joined to advanced high-strength steels. Weight reduction through the use of advanced high-strength materials is necessary in the automotive industry, as well as other markets, where weight savings are increasingly emphasized in pursuit of fuel efficiency. The purpose of this research is twofold: (1) to understand the influence that process parameters such as bit design, material type and machine commands have on the consistency and strength of friction bit joints in dissimilar metal alloys; and (2) to pioneer machine and bit configurations that would aid commercial, automated application of the system. Rotary broaching was established as an effective bit production method, pointing towards cold heading and other forming methods in commercial production. Bit hardness equal to the base material was found to be highly critical for strong welds. Bit geometry was found to contribute significantly as well, with weld strength increasing with larger bit shaft diameter. Solid bit heads are also desirable from both a metallurgical and industry standpoint. Cutting features are necessary for flat welds and allow multiple material types to be joined to advanced high-strength steel. Parameters for driving the bit were established and relationships identified. Greater surface area of contact between the bit and the driver was shown to aid in weld consistency. Microstructure changes resulting from the weld process were characterized and showed a transition zone between the bit head and the bit shaft where bit hardness was significantly increased. This zone is frequently the location of fracture modes. Fatigue testing showed the ability of FBJ to resist constant stress cycles, with the joined aluminum failing prior to the FBJ fusion bond in all cases. Corrosion testing established the use of adhesive to be an effective method for reducing galvanic corrosion and also for protecting the weld from oxidation reactions.