Spelling suggestions: "subject:"0ptical fiber sensors"" "subject:"aptical fiber sensors""
1 |
Single mode optical fibre bend loss modellingJones, Steven Lee January 1998 (has links)
No description available.
|
2 |
Development of advanced birefringent fibre force sensor systems based on frequency modulation continuous wave (FMCW) technologyZheng, Gang January 1997 (has links)
No description available.
|
3 |
Fabrication of wavelength division multiplexed in-fibre Bragg grating arrays for structural monitoring applicationsDockney, Michael Lee January 1997 (has links)
No description available.
|
4 |
Studies of multimode fibre linked white light interferometric sensor systemsWang, Qi January 1997 (has links)
No description available.
|
5 |
Optical actuation and control-by-light systemsMcKenzie, James Stuart January 1993 (has links)
No description available.
|
6 |
Development of photonic-based measurement devicesHua, Yan January 1996 (has links)
No description available.
|
7 |
Development of a reinforcing fibre light-guide for use as a damage sensor within composite structuresHayes, Simon Antony January 1995 (has links)
This study presents the results of an investigation to develop a novel sensor which would give a direct indication of the extent of impact damage in a composite. This was achieved by using glass reinforcing fibres to produce a light-guide, which was embedded within a composite laminate. The laminate was then subjected to impact events or bending stresses of sufficient magnitude to cause damage. The impact energies used in this study varied between 2 and 10 Joules, and the indentation depths varied between 0.125 and 1 mm, allowing damage propagation to be monitored. The fall-off in the transmitted light was used to monitor the level of damage, along with C-scanning and sectioning to provide reference data. The use of reinforcing fibres to produce the sensor meant that the strains required to cause failure in the fibres was realistically close to those of the composite constituents. Changes in the transmission characteristics of the sensor were found to correspond to real failure events occurring during impact.
|
8 |
Development of a distributed optical fibre pH sensor systemYang, Yatao January 1997 (has links)
No description available.
|
9 |
Puffer circuit breaker diagnostics using novel optical fibre sensorsIsaac, Leslie Thomas January 1997 (has links)
No description available.
|
10 |
In-situ cure monitoring of epoxy resins systemsPowell, Graham January 1998 (has links)
No description available.
|
Page generated in 0.0897 seconds