ITC/USA 2015 Conference Proceedings / The Fifty-First Annual International Telemetering Conference and Technical Exhibition / October 26-29, 2015 / Bally's Hotel & Convention Center, Las Vegas, NV / The emission of the telemetry signal is required over minimum two different antennas to keep the telemetry link available during a maneuver of a flying object. If nothing is made at the transmitter side, the telemetry link can be fully lost as both signals may have an opposite phase. We here propose a simple solution based on delay diversity to solve this problem. The basic idea is to introduce a delay between both emitted signals to guarantee a non-destructive signal recombination. We then exploit the ability of the blind equalizer developed by ZDS for the PCM/FM modulation to correctly equalize this signal and to recover the initial data. This solution does not require any modification of the on-board and floor set-ups except the introduction of a delay line between both transmitting antennas. It also does not need any pilot sequence and is natively robust to multipath perturbations.

ITC/USA 2015 Conference Proceedings / The Fifty-First Annual International Telemetering Conference and Technical Exhibition / October 26-29, 2015 / Bally's Hotel & Convention Center, Las Vegas, NV / The performance of telemetry systems may be strongly affected by diverse sources of perturbations. Among them, multipath channels and transmission noise are the most critical. While the effects due to the multipath channels can be attenuated thanks to equalization, the effects of the noise are limited if forward error correction is used. This paper first proves that the combination of blind equalization and forward error correction can strongly improve bit error rates. The other objective of the paper is to show that reasonably powerful codes like Reed-Solomon codes are sufficient to enable quasi-error free transmissions in a large majority of propagation channel scenarios.