"An apparatus for the delivery of radiation to the tip-sample interface of an Atomic Force Microscope (AFM) is demonstrated. The Pulsed Light Delivery System (PLDS) was fabricated to probe photoinduced conformational changes of molecules using an AFM. The PLDS is 67 mm long, 59 mm wide, and 21 mm high, leaving clearance to mount the PLDS and a microscope slide coated with a thin film of photoactive molecules beneath the cantilever tip of a stand-alone AFM. The PLDS is coupled into a fiber pigtailed Nd:Yag frequency doubled laser, operating at a wavelength of 532 nm. The radiation delivered to a sample through the PLDS can be configured for continuous or pulsed mode. The maximum continuous wave (CW) power delivered was 0.903 mW and the minimum pulse width was 12.3 ms (maximal 401 ms), corresponding to a minimal energy of 0.150 nJ (maximal 362 nJ), and had a cycle duration of 10.0 ms. The PLDS consists of micro-optical components 3.0 mm and smaller in diameter. The optical design was inspired by the three-beam pick-up method used in CD players, which could provide a method to focus the pulse of light onto the sample layer. In addition, the system can be easily modified for different operational parameters (pulse width, wavelength, and power). As proof that the prototype design works, we observed a photoinduced ‘bimetallic’ bending of the cantilever, as evidenced by observing no photoinduced bending when a reflective-coated cantilever was replaced by an uncoated cantilever. Using the apparatus will allow investigation of many different types of molecules exhibiting photoinduced isomerization."

>Magister Scientiae - MSc / Electrochemiluminescence (EeL) is applied for industrial applications that have considerable potential, such as clinical diagnostic, analytical chemistry, and light-emitting devices, due to selectivity, sensitivity for detection and quantification of molecules through generation of fluorescence light when electric current is applied on the materials. In EeL the electrochemical reaction allows for precise control over the time and position of the light emitting reaction. The control over time allows one to synchronise the luminescence and the biochemical reaction under study and control over position not only improves sensitivity of the instrument by increasing the signal to noise ratio, but also allows multiple analytical reactions in the same sample to be analyzed using an electrode array. The EeL generation fluorescent materials are based on inorganic semiconductor materials for light-emitting devices. Further progress in this EeL field mainly depends on discovery of new advanced materials, interfacial films and nanoparticle coatings, advances in microfluidics leading to total increase in EeL properties. There has been extensive use of polymers for enhancement of EeL properties. Electrochemiluminescent conjugated polymers constitute a new class of fluorescent polymers that emit light when excited by the flow of an electric current. These new generation fluorescent materials may now challenge the domination by inorganic semiconductor materials for the commercial market of light-emitting devices such as lightemitting diodes and polymer laser devices (PLDs).