No description available.

No description available.

The synthesis and characterization of pyridinyl &alpha / -diimine Pd(II) complexes having a functionalized hydrocarbon attached to the imino nitrogen was performed. The catalytic activity of these complexes were then evaluated in the polymerization of ethylene and in the Heck coupling reaction of methyl acrylate with iodobenzene.<br /> <br /> Unconjugated &beta / -diimine complexes of palladium were also synthesized and their activities towards ethylene polymerization and the Heck coupling of methyl acrylate and iodobenzene also evaluated and compared to that of the &alpha / -diimine complexes. Three of the &alpha / -diimine complexes synthesized showed activity towards ethylene polymerization, these being the complexes bearing the allyl, styrene and phenol functionalities. &omega / -Carboxylato complexes which were also synthesized showed no activity towards ethylene polymerization.<br /> <br /> The polymer produced was found to be high density linear polyethylene with an average PDI of 2.54 with Mn values ranging between 3.42 and 6.90 x 10-5 and Mw values ranging between 6.05 and 17.6 x 10-5.<br /> <br /> The complexes bearing the allyl, styrene and phenol functionalities, as well as the &omega / -carboxylato complexes active in the Heck coupling reactions of methyl acrylate with iodobenzene. None of the unconjugated &beta / -diimine complexes prepared showed any activity towards ethylene polymerization even at high Al/Pd ratios. The activity of these complexes towards the Heck arylation reaction was comparable to that of the &alpha / -diimine complexes showing similar activities.

Little attention has been given to the formation of the putative PdL2 species required for Pd-catalyzed cross-coupling reactions. Active species are generally difficult to store due to air-sensitivity and are therefore formed in situ at unknown rates and in unknown yields via a variety of palladium precatalysts. Commonly employed Pd(0) and Pd(II) precatalysts are often relatively ineffective because they generate only low concentrations of the bis(phosphine) species PdL2 under most reaction conditions. This thesis describes the use of the easily synthesized and easily handled Pd(η3-1-Ph-C3H4)(η5-C5H5) (I) as a superior precursor than any other documented system for the in situ formation of PdL2. Rapid and quantitative formation of active catalyst solutions allow us to demonstrate that I is also the best precatalyst known for PdL2-catalyzed crosscoupling reactions. We discuss the Suzuki-Miyaura reaction of 4-bromoanisole with phenylboronic acid and demonstrate that, under mild reaction conditions, higher initial rates and higher conversions with I can be obtained compared with other common precatalysts (Pd(OAc)2, Pd(PPh3)4, Pd2dba3, etc.) containing a variety of phosphine ligands. This methodology has also been extended to other cross-coupling reactions, as we demonstrate that higher initial rates and higher conversions with I can be obtained for a variety of Mizoroki-Heck arylations and Buchwald-Hartwig aminations. / Thesis (Ph.D, Chemistry) -- Queen's University, 2013-06-25 11:53:06.75

The synthesis, characterization and coordination chemistry of novel zwitterionic late transition metal complexes has been carried out, and an investigation of their ability to act as olefin polymerisation catalysts has been conducted. These systems are based on 6- aminofulvene-2-aldiminate ligands (R2AFA¯) which are capable of binding metal centres via two nitrogen donors, delocalising the negative charge into their cyclopentadienyl moiety, thus resulting in the formation of neutral zwitterionic complexes. Preparation and characterisation of mono- and di-substituted complexes such as Ph2AFACuPPh3, (Ph2AFA)2Zn, (Ph2AFA)2Co, (Ph2AFA)2Ni and (Ph2AFA)2Pd have revealed that this type of ligand has enough flexibility to distort upon coordination to the metal depending on geometrical or steric restrictions. As a result, when the ligand coordination involves narrow binding angle of the metal chelate, as it happens in the square-planar species, a severe loss of planarity of the ligand framework is observed, in contrast with the tetrahedral structures where such binding angles are wider. Although the coordination of the ligand primarily occurs through the nitrogen donors, once they have been occupied by the metal centre, it is possible to exploit the aromatic Cp ring for coordination to a Cp*Ru+ unit. In this way, the synthesis and characterisation of two- and tri-metallic complexes [(Cp*Ru)(Ph’2AFA)Pd(η3-C3H5)][BF4] (where Ph’= 2,4,6-trimethylphenyl) and [(Cp*Ru)2(Ph2AFA)2Pd][BF4]2 has been achieved, featuring the R2AFA¯ molecule acting as an ambidentate ligand, binding the palladium atom in a diimine fashion and the ruthenium centres by means of the C5 ring. The synthesis of the complex Cp*RuPh2AFA where the two N atoms are vacant was also achieved and it was found that this compound acts as a proton sponge in the presence of protic solvents. In an effort to prepare AFA-metal complexes which could be of potential use in olefin polymerisation catalysis, two novel species, [(Ph2AFA)Pd(Me)PPh3] and [(Ph’2AFA)Pd(C3H5)] (where Ph’= 2,4,6-trimethylphenyl) have been synthesised and characterised, and polymerisation tests with ethylene have been carried out. Some preliminary screening of other molecules as monomers for polymerisation catalysis has also been conducted.

This thesis is divided into two main chapters, which are focused on two separated and uncorrelated research areas. The first part of this thesis is dedicated to the research I carried out in benzyne chemistry and the second part is focused on catalytic C-H bond activation. In the first place, a novel insertion reaction of arynes into the nitrogen-carbonyl σ-bond of amides has been investigated as a rapid and powerful approach for the preparation of valuable ortho-disubstituted arenes. Readily available aromatic amides undergo smooth insertion when treated with O-triflatophenyl silane aryne precursors, producing versatile anthranilic derivatives in good to excellent yields. The process is entirely metal-free and has been expanded to the synthesis of biologically active heterocycles such as acridones and acridines. Secondly, the synthesis of medium-sized ring systems by intramolecular oxidative CH bond coupling has been explored. Despite the abundance of biologically active natural products featuring mediumsized rings, the synthesis of such ring systems using classical synthetic routes faces many challenges and has led to a dearth of medium ring compounds in medicinal chemistry. In contrast to the more facile 5-membered ring synthesis by oxidative C-H coupling, medium ring synthesis has not been previously reported using this approach. The chemistry, which requires zero pre-functionalisation of the substrates, is catalysed by palladium and has been exemplified using heteroaromatic substrates at the core of numerous biologically active molecules. The mechanism of the reaction has also been studied and a catalytic cycle has been proposed.

The major part of this thesis concerns the development of catalytic methodologies based on palladium nanoparticles immobilized on aminopropyl-functionalized siliceous mesocellular foam (Pd0-AmP-MCF). The catalytic activity of the precursor to the nanocatalyst, PdII-AmP-MCF is also covered by this work. In the first part the application of Pd0-AmP-MCF in Suzuki-Miyaura cross-coupling reactions and transfer hydrogenation of alkenes under microwave irradiation is described. Excellent reactivity was observed and a broad range of substrates were tolerated for both transformations. The Pd0-AmP-MCF exhibited high recyclability as well as low metal leaching in both cases. The aim of the second part was to evaluate the catalytic efficiency of the closely related PdII-AmP-MCF for cycloisomerization of various acetylenic acids. The catalyst was able to promote formation of lactones under mild conditions using catalyst loadings of 0.3 - 0.5 mol% at temperatures of up to 50 oC in the presence of Et3N. By adding 1,4-benzoquinone to the reaction, the catalyst could be recycled four times without any observable decrease in the activity. The selective arylation of indoles at the C-2 position using Pd-AmP-MCF and symmetric diaryliodonium salts is presented in the third part. These studies revealed that Pd0-AmP-MCF was more effective than PdII-AmP-MCF for this transformation. Variously substituted indoles as well as diaryliodonium salts were tolerated, giving arylated indoles in high yields within 15 h at 20 - 50 oC in H2O. Only very small amounts of Pd leaching were observed and in this case the catalyst exhibited moderate recyclability. The final part of the thesis describes the selective hydrogenation of the C=C in different α,β-unsaturated systems. The double bond was efficiently hydrogenated in high yields both under batch and continuous-flow conditions. High recyclability and low metal leaching were observed in both cases. / <p>At the time of the doctoral defense, the following papers were unpublished and had a status as follows: Paper 4: Submitted. Paper 5: Submitted.</p><p> </p>

Increasing carbon emissions and insecurities in oil supply have led to heightened interest in hydrogen powered fuel cells. Preferably, the cell runs on hydrogen gas, though due to the sensitivity of the catalytic components in the fuel cell to carbon monoxide, the hydrogen must be extremely pure (typically <50 ppm CO). Due to a lack of hydrogen infrastructure, it is envisaged that a medium term solution will be the reforming of more conventional fuels such as gasoline. The gas mixture produced however, contains impurities such as CO, CO₂ and CH₄. Purification may be achieved using palladium membranes, which allow selective permeation of hydrogen. This thesis describes the research carried out in conjunction with Johnson Matthey on thin (typically 7.5 μm) palladium/silver alloy membranes supported on both ceramic and stainless steel porous tubular substrates. Extensive experimental flow testing has been performed to assess the effect of temperature, feed composition, including wet feeds, and membrane thickness on the hydrogen purification properties. An existing Fortran based model was validated and revised to accurately account for the effects of operating conditions such as temperature and carbon monoxide concentration. This work provided excellent correlation between experimental and simulated results. The validated and improved model was incorporated in the design of a hydrogen refuelling station in Aspen Plus and the palladium membrane requirements assessed to supply 650 fuel cell vehicles per day. The system incorporated a steam reformer, membrane clean-up module, water trap and high pressure compressor for hydrogen storage at 1000 bara. Operating conditions such as system pressure, fuel feed and steam to carbon ratio were investigated and adjusted to optimise the overall system efficiency. An efficiency of 52% was achieved with a steam to carbon ratio of SCR = 2.5. A membrane requirement of 6000 standard tubes was found to provide a 90% hydrogen recovery efficiency.

N-Heterocyclic carbenes (NHCs) have emerged as appropriate replacements for phosphines in transition metal catalyzed cross-coupling chemistry. The advantages of NHCs over phosphines include ease of handling, minimal toxicity, stability and powerful electron donating properties. Improvement of catalytic processes has become increasingly relevant in light of prospective applications of organic transformations in industry as well as in synthetic laboratories. To that end, NHCs represent an important class of catalysts and catalyst modifiers which mandate continued research efforts. Prospective applications of processes catalyzed by NHCs and NHC-metal catalysts provide a strong impetus to develop them and related methodologies. This dissertation focuses on the development of NHCs and NHC ligated metal complexes in various catalytic transformations. NHC ligated palladium catalysts were synthesized in simplified protocols amenable to large-scale industrial applications. The catalysts were utilized in developing different valuable coupling methodologies. Significant advances were achieved in Suzuki-Miyaura, á-arylation of ketones and Kumada-Tamao-Corriu cross coupling reactions. The focus of the work was to make the synthesized catalysts and their activity in these methodologies acceptable to wider range of applications. The strongly nucleophilic nature and easily tunable steric and electronic properties of NHCs have been exploited to mediate organic transformations by utilizing NHCs as catalysts. The metal-free catalysis has an added advantage of being more environmentally friendly. NHCs have proven to be excellent transesterification catalysts for reactions of alcohol and esters. An efficient catalytic system, widening the scope of N-heterocyclic carbenes catalyzed transesterification/acylation reaction of alcohols is described. The methodology has been expanded to include secondary alcohols as well as phosphorus based esters.

Over the past decade, heterogeneous photocatalysis have gained lots of interest and attention among the organic chemistry community due to its applicability as an alternative to its homogeneous counterpart. Heterogeneous catalysis offers the advantages of easy separation and reusability of the catalyst. Several studies showed that under optimized conditions, efficient and highly selective catalytic systems could be developed using supported metal/metal oxide nanoparticles. In this dissertation, we summarize the progress in the development of supported palladium nanoparticles for different types of organic reactions. Palladium-decorated TiO2 is a moisture, air-tolerant, and versatile catalyst. The direct excitation of Pd nanoparticles selectively isomerized the benzyl-substituted alkenes to phenyl-substituted alkenes (E-isomer) with complete conversion over Pd@TiO2 under H2-free conditions. Likewise, light excited Pd nanoparticles catalyzed Sonogashira coupling, a C-C coupling reaction between different aryl iodides and acetylenes under very mild conditions in short reaction times. On the other hand, UV irradiation of Pd@TiO2 in alcoholic solutions promotes alkenes hydrogenation at room temperature under Argon. Thus, The photocatalytic activity of Pd@TiO2 can be easily tuned by changing the irradiation wavelength. Nevertheless, some of these systems suffer from catalyst deactivation, one of the main challenges faced in heterogeneous catalysis that decreases the reusability potential of the materials. In order to overcome this problem, we developed an innovative method called “Catalytic Farming”. Our reactivation strategy is based on the crop rotation system used in agriculture. Thus, alternating different catalytic reactions using the same catalyst can reactivate the catalyst surface by restoring its oxidation states and extend the catalyst lifetime along with its selectivity and efficiency. In this work, the rotation strategy is illustrated by Sonogashira coupling –problem reaction that depletes the catalyst– and Ullmann homocoupling –plausible recovery reaction that restores the oxidation state of the catalyst (Pd@TiO2). The selection of the reactions in this approach is based on mechanistic studies that include the role of the solvent and evaluation of the palladium oxidation state after each reaction. In a more exploratory analysis, we successfully demonstrated that Pd nanoparticles could be supported in a wide range of materials, including inert ones such as nanodiamonds or glass fibers. The study of the action spectrum shows that direct excitation of the Pd nanoparticles is a requisite for Sonogashira coupling reactions. The main advantages of heterogeneous catalysis compared to its homogeneous counterpart are easy separation and reusability of the catalyst. Finally in order to facilitate catalyst separation from batch reaction and develop a suitable catalytic system for continuous flow chemistry, we employed glass fibers as catalyst support for a wide variety of thermal and photochemical organic reactions including C-C coupling, dehalogenation and cycloaddition. Different metal/metal oxide nanoparticles, namely Pd, Co, Cu, Au, and Ru were deposited on glass wool and fully characterized. As a proof of concept, Pd decorated glass fibers were employed in heterogeneous flow photocatalysis for Sonogashira coupling and reductive de-halogenation of aryl iodides.