No description available.

New measurements of the masses of the isotopes⁸,⁹,¹¹Li were made using recently commissioned TITAN Penning trap mass spectrometer at TRIUMF. The measurement of the halo nucleus ¹¹Li represents a new standard in Penning trap mass spectrometry, as it is the shortest lived, t₁/₂ = 8.8 ms, isotope ever weighed using this technique. Low energy, E = 20 keV, beams of these radioactive isotopes were produced using the ISAC facility. These were subsequentlycooled and bunched using a square-wave-driven Radio- Frequency Quadrupole (RFQ) ion guide, which was filled with hydrogen gas. The cooled ion bunches were then passed into a Penning trap where the mass measurements were made. A description of the RFQ in the ISAC hall is given along with some results from the commissioning of the device. A new set of harmonic deceleration optics is presented which have been successfully used to inject ions into the RFQ. Cooling of lithium ions with high DC efficiencies of 20%, in helium, and 40%, in hydrogen, are shown. Extraction of extremely short ion bunches, 30 ns FWHM, is also demonstrated. Storage times for stable lithium ions in helium and hydrogen were investigated. It was found that lithium ions could be cooled in hydrogen for up to 30 ms without significant losses whereas cooling in helium lead to exponential losses with a half-life of 5.7(1)ms. The TITAN Penning trap is described and the ⁸,⁹,¹¹Li data presented. Final values for the mass excess of ∆(⁸Li) = 20945.70(38) keV, ∆(⁹Li) = 24954.80(60) keV and ∆(¹¹Li) = 40728.1(12) keV are obtained. The ⁹,¹¹Li results are then used to obtain a new value for two neutron separation energy of ¹¹Li, S₂n = 369.3(1.3) keV. This agrees with the recent measurement from the MISTRAL spectrometer, 376(5) keV, at the two sigma level, but shows over three standard deviations from the most recent atomic mass evaluation, 300(20) keV

A high frequency, large amplitude helium filled RFQ (Radio Frequency Quadrupole) beam cooler and buncher was developed and tested for use in the TITAN (TRIUMF's Ion Trap for Atomic and Nuclear science) Penning trap mass spectrometer facility. This device will cool and bunch radioactive ion beams for use in TITAN's high precision mass measurements of short-lived isotopes and other experiments. A test stand was built to test the transmission and properties of ions from a surface ion source through injection optics, the linear Paul trap RFQ and the extraction optics in both continuous and pulsed modes. The efficiency of the device was determined to be on the order of 60% in continuous mode. The present measurements confirm a transverse emittance of the extracted beam in bunched mode operation of 4 pi-mm-mrad at an extraction energy of 4 keV.

New measurements of the masses of the isotopes⁸,⁹,¹¹Li were made using recently commissioned TITAN Penning trap mass spectrometer at TRIUMF. The measurement of the halo nucleus ¹¹Li represents a new standard in Penning trap mass spectrometry, as it is the shortest lived, t₁/₂ = 8.8 ms, isotope ever weighed using this technique. Low energy, E = 20 keV, beams of these radioactive isotopes were produced using the ISAC facility. These were subsequentlycooled and bunched using a square-wave-driven Radio- Frequency Quadrupole (RFQ) ion guide, which was filled with hydrogen gas. The cooled ion bunches were then passed into a Penning trap where the mass measurements were made. A description of the RFQ in the ISAC hall is given along with some results from the commissioning of the device. A new set of harmonic deceleration optics is presented which have been successfully used to inject ions into the RFQ. Cooling of lithium ions with high DC efficiencies of 20%, in helium, and 40%, in hydrogen, are shown. Extraction of extremely short ion bunches, 30 ns FWHM, is also demonstrated. Storage times for stable lithium ions in helium and hydrogen were investigated. It was found that lithium ions could be cooled in hydrogen for up to 30 ms without significant losses whereas cooling in helium lead to exponential losses with a half-life of 5.7(1)ms. The TITAN Penning trap is described and the ⁸,⁹,¹¹Li data presented. Final values for the mass excess of ∆(⁸Li) = 20945.70(38) keV, ∆(⁹Li) = 24954.80(60) keV and ∆(¹¹Li) = 40728.1(12) keV are obtained. The ⁹,¹¹Li results are then used to obtain a new value for two neutron separation energy of ¹¹Li, S₂n = 369.3(1.3) keV. This agrees with the recent measurement from the MISTRAL spectrometer, 376(5) keV, at the two sigma level, but shows over three standard deviations from the most recent atomic mass evaluation, 300(20) keV

New measurements of the masses of the isotopes⁸,⁹,¹¹Li were made using recently commissioned TITAN Penning trap mass spectrometer at TRIUMF. The measurement of the halo nucleus ¹¹Li represents a new standard in Penning trap mass spectrometry, as it is the shortest lived, t₁/₂ = 8.8 ms, isotope ever weighed using this technique. Low energy, E = 20 keV, beams of these radioactive isotopes were produced using the ISAC facility. These were subsequentlycooled and bunched using a square-wave-driven Radio- Frequency Quadrupole (RFQ) ion guide, which was filled with hydrogen gas. The cooled ion bunches were then passed into a Penning trap where the mass measurements were made. A description of the RFQ in the ISAC hall is given along with some results from the commissioning of the device. A new set of harmonic deceleration optics is presented which have been successfully used to inject ions into the RFQ. Cooling of lithium ions with high DC efficiencies of 20%, in helium, and 40%, in hydrogen, are shown. Extraction of extremely short ion bunches, 30 ns FWHM, is also demonstrated. Storage times for stable lithium ions in helium and hydrogen were investigated. It was found that lithium ions could be cooled in hydrogen for up to 30 ms without significant losses whereas cooling in helium lead to exponential losses with a half-life of 5.7(1)ms. The TITAN Penning trap is described and the ⁸,⁹,¹¹Li data presented. Final values for the mass excess of ∆(⁸Li) = 20945.70(38) keV, ∆(⁹Li) = 24954.80(60) keV and ∆(¹¹Li) = 40728.1(12) keV are obtained. The ⁹,¹¹Li results are then used to obtain a new value for two neutron separation energy of ¹¹Li, S₂n = 369.3(1.3) keV. This agrees with the recent measurement from the MISTRAL spectrometer, 376(5) keV, at the two sigma level, but shows over three standard deviations from the most recent atomic mass evaluation, 300(20) keV / Science, Faculty of / Physics and Astronomy, Department of / Graduate

Criteria for the confinement of plasmas consisting of a positive and negative component in Penning type traps with nested electric potential wells are presented. Computational techniques for the self-consistent calculation of potential and plasma density distributions are developed. Analyses are presented of the use of nested well Penning traps for several applications. The analyses include: calculations of timescales relevant to the applications, e.g. reaction, confinement and relaxation timescales, self-consistent computations, and consideration of other physical phenomenon important to the applications. Possible applications of a nested well penning trap include production of high charge state ions, studies of high charge state ions, and production of antihydrogen. In addition the properties of a modified Penning trap consisting of an electric potential well applied along a radial magnetic field are explored.

This thesis describes the recent improvements of the SMILETRAP Penning trap mass spectrometer and a number of interesting high precision mass measurements, which have been performed using the improved apparatus, and are relevant in todays fundamental physics problems. The mass of the hydrogen-like 24,26Mg ions as well as the masses of the hydrogen- and lithium-like 40Ca ions are presented in this work that are indispensable input values when evaluating g-factor measurements of the bound electron. In both cases the uncertainty in the masses was improved by one order of magnitude compared to the literature values known so far. The mass of 7Li has been measured and a new mass value has been obtained with an unprecedented relative uncertainty of 6.3x10-10. A large deviation of 1.1 μu (160ppb) compared to the literature value has been observed. In order to find the reason of this large deviation and to look for possible systematics we have measured the mass of 4He and 6Li and concluded that the 6Li(n,γ)7Li reaction Q-value used in the literature when calculating the 7Li mass is wrong by about 1 keV. The mass difference between 3He and 3H (Δ m (3H -3He)) is the Q-value of the tritium β-decay. An accurate knowledge of the tritium Q-value is of importance in the search for a finite rest mass of the electron neutrino. By adding a measurement of the mass of 3He1+ to previous mass measurement of 3H1+ and 3He2+ we have improved our previous Q-value by a factor of 2. At the moment our Q-value is the most accurate and more importantly it is based on the correct atomic mass values.

Thesis (Ph. D.)--University of Washington, 2004. / Vita. Includes bibliographical references (p. 130-135).

The Canadian Penning Trap (CPT) mass spectrometer at the Argonne National Laboratory makes precise mass measurements of both stable and unstable nuclides. To date, more than 60 radioactive isotopes having half-lives as short as one second have been measured with the CPT with a mass precision approaching 10 ppb. This thesis will present measurements made of nuclides along the rp-process path, which describes a process resulting from a series of rapid proton-capture reactions in an astrophysical environment. One possible site for the rp-process mechanism is an x-ray burst which results from the rapid accretion of hydrogen and helium from one star onto the surface of its neutron star binary companion. Mass measurements are required as key inputs to network calculations used to describe the rp-process in terms of the abundances of the nuclides produced, the light-curve profile of the x-ray bursts, and the energy produced. This thesis will describe the CPT apparatus, explain the method used to make precise mass measurements, and present the masses of the "waiting-point" nuclides ⁶⁸Se and ⁶⁴Ge. The mass measurement results, when used in x-ray burst models, confirm both ⁶⁸Se and ⁶⁴Ge as waiting-point nuclides which delay the rp-process by approximately 30 s and 7 s respectively. / October 2005

The Canadian Penning Trap (CPT) mass spectrometer at the Argonne National Laboratory makes precise mass measurements of both stable and unstable nuclides. To date, more than 60 radioactive isotopes having half-lives as short as one second have been measured with the CPT with a mass precision approaching 10 ppb. This thesis will present measurements made of nuclides along the rp-process path, which describes a process resulting from a series of rapid proton-capture reactions in an astrophysical environment. One possible site for the rp-process mechanism is an x-ray burst which results from the rapid accretion of hydrogen and helium from one star onto the surface of its neutron star binary companion. Mass measurements are required as key inputs to network calculations used to describe the rp-process in terms of the abundances of the nuclides produced, the light-curve profile of the x-ray bursts, and the energy produced. This thesis will describe the CPT apparatus, explain the method used to make precise mass measurements, and present the masses of the "waiting-point" nuclides ⁶⁸Se and ⁶⁴Ge. The mass measurement results, when used in x-ray burst models, confirm both ⁶⁸Se and ⁶⁴Ge as waiting-point nuclides which delay the rp-process by approximately 30 s and 7 s respectively.