Photoluminescence (PL) has been studied from different types of bulk GaN samples grown by hydride vapor phase epitaxy technique at Kyma Technologies. Point defects in bulk and at the surface affect the electrical and optical properties of GaN and could be analyzed by PL. The surface of the samples was polished with different techniques: one is chemical mechanical polish (CMP) and another is mechanical polish (MP). PL data from MP and CMP surfaces show that PL intensity from the CMP-treated surface is much higher than that from the MP-treated surface. This can be explained by defects formed during the process of MP polish. However, after the MP-treated surface is etched with RIE method, the optical quality of the MP-treated surface improves. In particular, as the depth of etching increases from 50 nm to 700 nm, the PL intensity increases by a factor of 1000. PL from the CMP surfaces of undoped bulk GaN samples contains a broad red luminescence (RL) band and a broad green luminescence (GL) band. However, PL from the CMP surfaces of Fe-doped GaN samples contained a blue luminescence band (labeled as BL2 in literature) and the yellow luminescence (YL) band. PL from MP-treated surfaces (both undoped and Fe-doped) was very weak and it contained relatively narrow red and green bands. These bands, labeled RL2 and GL2, respectively, are quenched at relatively low temperatures, in contrast to the RL and GL bands which are almost independent of temperature in the range from 15 to 300 K.